Lincoln Continental Recall for Power Train Problem - (7 Recalls Found)
Find your car listed below. Results are sorted year from newest to oldest. Select the desired vehicle to view the complete details.
Information provided by the National Highway Traffic Safety Administration.
|
|
|
Problem: THE PARK PAWL ABUTMENT BRACKET HAS A SHARP EDGE WHICH CAN CAUSE THE PARKING PAWL TO HANG UP AND NOT ENGAGE THE PARK GEAR. THIS WOULD ALLOW THE VEHICLE TO MOVE EVEN THOUGH THE GEAR SHIFT INDICATOR SHOWS THAT THE VEHICLE IS IN PARK. Recall Details
Problem: THE AUTOMATIC TRANSMISSION PARK PAWL SHAFT MAY NOT BE FREE TO ROTATE AS INTENDED. IF THE PARK PAWL SHAFT DOES NOT ROTATE, IT WOULD PREVENT THE PARK PAWL FROM ENGAGING THE PARK GEAR WHEN THE SHIFT LEVER IS IN THE PARK POSITION. Recall Details
Problem: TRANSMISSION SHIFT CABLES MAY NOT MEET FORDS PULL OUT LOAD SPECIFICATIONS FOR THE SWIVEL TUBE PORTION OF THE CABLE, WHICH COULD ALLOW THE SWIVEL TUBE TO SEPARATE FROM THE SHIFT CABLE ASSEMBLY. Recall Details
Problem: THE SHIFT INDICATOR MAY NOT ACCURATELY REFLECT THE SHIFT SELECTOR POSITION. SOME VEHICLES WERE PRODUCED WITH TRANSMISSION CONTROL SELECTOR TUBE RETAINING CLIPS THAT MAY NOT BE HARD ENOUGH. THE CLIP MAY LOOSEN OR FALL OFF, AND THE SELECTOR TUBE MAY BECOME DISPLACED. Recall Details
Problem: THE PARKING GEAR MAY NOT ENGAGE, EVEN THOUGH THE GEAR SHIFT LEVER IS PLACED IN THE "PARK" POSITION. THIS OCCURS IF THE LINKAGE INSIDE THE TRANSMISSION THAT ACTUATES THE PARK GEAR WAS IMPROPERLY MANUFACTURED. A PIN THAT RETAINS COMPONENTS ON A LINKAGE (ACTUATING) ROD COULD BREAK AND THE LINKAGE MAY NOT ENGAGE THE PARKING GEAR. Recall Details
Problem: THE INVOLVED VEHICLES WERE EQUIPPED WITH AUTOMATIC TRANSMISSIONS IN WHICH THE PARKING PAWL WAS NOT HEAT-TREATED. DURING NORMAL VEHICLE OPERATION, A PARKING PAWL THAT HAS NOT BEEN HEAT-TREATED COULD BECOME DEFORMED OR WORN TO THE POINT THAT THE TRANSMISSION WILL NOT LOCK IN "PARK". AS A RESULT, THE VEHICLE COULD ROLL FREE IF THE DRIVER DOES NOT SET THE PARKING BRAKE WHEN PARKING OR LEAVING VEHICLE UNATTENDED. Recall Details
Problem: THE INVOLVED VEHICLES WERE FITTED WITH TILT STEERING COLUMNS CONTAINING TRANSMISSION CONTROL INSERTS INTENDED FOR TRUCKS RATHER THAN PASSENGER VEHICLES. THIS MAY CAUSE THE TRANSMISSION SELECTOR POINTER TO BE MISALIGNED AND THE POSSIBILITY OF STARTING THE ENGINE WHEN THE SELECTOR IS BETWEEN THE NEUTRAL (N) AND DRIVE (D) DETENTS AND THE TRANSMISSION IS IN DRIVE. Recall Details
|