Vehicle |
2008 MAZDA CX-9 |
|
Manufacturer |
Mazda North American Operations |
Manufactured between |
10/24/2006 - 12/28/2013 |
Recalled on |
7/20/2015 |
Influenced by |
OFFICE OF DEFECTS INVESTIGATION |
Owners Notified on |
9/14/2015 |
# Affected |
193,484 |
Recalled for |
SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT |
|
|
Description |
Mazda North American Operations (Mazda) is recalling certain model year 2007-2014 CX-9 vehicles manufactured October 24, 2006, to December 28, 2013. The affected vehicles have front suspension ball joints that may corrode from water leaking into the fitting. |
Consequences |
Over time, the ball joint corrosion may result in the front lower control arm separating from the ball joint, causing a loss of steering control and increasing the risk of a crash. |
Corrective action |
Mazda will notify owners, and dealers will replace both the left and right lower control arms, free of charge. The recall began on September 14, 2015. The recall will begin with model year 2007-2009 vehicles registered in Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, Washington D.C., West Virginia, and Wisconsin. The second phase will be for model year 2010-2014 vehicles in the same states. Finally, all remaining vehicles will be remedied. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 8515G. |
Notes |
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. |
See also |
2008 MAZDA CX-9 Recall for ELECTRICAL SYSTEM, WIRING, INTERIOR/UNDER DASH
2008 MAZDA CX-9 Recall for SUSPENSION, FRONT, CONTROL ARM, LOWER ARM
2008 MAZDA CX-9 Recall for AIR BAGS, FRONTAL, PASSENGER SIDE, INFLATOR MODULE
2008 MAZDA CX-9 Recall for AIR BAGS, FRONTAL, PASSENGER SIDE, INFLATOR MODULE
2008 MAZDA CX-9 Recall for AIR BAGS, FRONTAL, PASSENGER SIDE, INFLATOR MODULE
|
Technical Service Bulletins |
Jan 05, 2022 - 100000 POWER TRAIN
Automatic Transmission/Transaxle Cooler and Lines Flushing Procedure: Automatic Transaxle/Transmission (A/T) oil cooler and lines must be power flushed completely before an overhauled or replacement A/T is installed (except SKYACTIV-DRIVE)
Jan 05, 2022 - 110000 ELECTRICAL SYSTEM
Battery Maintenance: This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost.
Jan 05, 2022 - 110000 ELECTRICAL SYSTEM
Remote Start Causes HVAC1 or IGN1 Fuse to Blow - Install Load Reduction Relay Service Harness: TSB 01-046/08 - 2007-2008 CX-7, 2007-2008 CX-9 - REMOTE START CAUSES HVAC1 OR IGN1 FUSE TO BLOW - INSTALL LOAD REDUCTION RELAY SERVICE HARNESS i
Jan 05, 2022 - 350000 EQUIPMENT
Remote Start Causes HVAC1 or IGN1 Fuse to Blow - Install Load Reduction Relay Service Harness: TSB 01-046/08 - 2007-2008 CX-7, 2007-2008 CX-9 - REMOTE START CAUSES HVAC1 OR IGN1 FUSE TO BLOW - INSTALL LOAD REDUCTION RELAY SERVICE HARNESS i
Oct 30, 2021 - 061540 ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION:OIL COOLER
Some customers may complain about high engine oil consumption. Before attempting any repairs, verify the complaint by using the guideline below to determine if an engine repair is necessary:
View all Technical Service Bulletins
|
|