1997 OLDSMOBILE CUTLASS SUPREME RECALL - #03V527000
RECALL FOR STEERING : RACK AND PINION
CERTAIN PASSENGER VEHICLES HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE RETAINERS COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.
Information provided by the
National Highway Traffic Safety Administration.
•
Send to a friend
•
Hide Form
Recall Details
| Vehicle |
1997 OLDSMOBILE CUTLASS SUPREME |
|
| Manufacturer |
GENERAL MOTORS CORP. |
| Manufactured between |
4/1/1996 - 5/31/1997 |
| Recalled on |
12/18/2003 |
| Influenced by |
OFFICE OF DEFECTS INVESTIGATION |
| Owners Notified on |
2/5/2004 |
| # Affected |
750,283 |
| Recalled for |
STEERING:RACK AND PINION |
|
|
| Description |
CERTAIN PASSENGER VEHICLES HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE RETAINERS COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE. |
| Consequences |
IF THIS OCCURS, THE PINION SHAFT CAN BE FORCED UPWARD DURING LEFT TURNS AND BACK DOWN AS THE STEERING WHEEL IS MOVED BACK AND TO THE RIGHT. IF THE PINION SHAFT MOVES FURTHER, THE DRIVER WILL NEED TO EXERT MORE EFFORT TO TURN THE STEERING WHEEL, SIMILAR TO A VEHICLE WITHOUT POWER ASSISTED STEERING. IF THE PINION SHAFT MOVES EVEN FURTHER, THE DRIVER WILL REQUIRE MUCH HIGHER EFFORT TO TURN LEFT AND MAY NOT BE ABLE TO TURN THE WHEEL AS MUCH AS INTENDED. WITH THE MAXIMUM PINION SHAFT MOVEMENT, WHICH REQUIRES INTERNAL GEAR COMPONENT DAMAGE, THE DRIVER CAN ENCOUNTER HIGH RESISTANCE TO TURNING LEFT, FOLLOWED BY UNINTENDED POWER ASSIST TO THE RIGHT. IN ANY OF THESE CONDITIONS, A CRASH COULD OCCUR. |
| Corrective action |
DEALERS WILL INSTALL A NEW LOWER PINION BEARING UNLESS INSPECT OF THE EXISTING BEARING INDICATES THAT REPLACEMENT OF THE GEAR ASSEMBLY IS NECESSARY. OWNER NOTIFICATION BEGAN ON FEBRUARY 5, 2004. OWNERS SHOULD CONTACT BUICK AT 1-866-608-8080; CHEVROLET AT 1-800-630-2438; OLDSMOBILE AT 1-800-630-6537; OR PONTIAC AT 1-800-620-7668. |
| Notes |
GM RECALL NO. 03062.CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236). |
| See also |
|
| Technical Service Bulletins |
Mar 31, 2003 - 061000 ENGINE AND ENGINE COOLING:ENGINE
REVISED PISTON PIN REMOVAL / INSTALLATION PROCEDURE. *TT
May 24, 2001 - 061100 ENGINE AND ENGINE COOLING:ENGINE:GASOLINE
SOME OWNERS MAY COMMENT ON DRIVEABILITY SYMPTONS OF LONG OR HARD STARTS, CHUGGLE, ROUGH IDLE AND LIGHT OR INTERMITTENT MISFIRE DUE TO CLOGGED FUEL INJECTORS. *TT
May 24, 2001 - 106000 POWER TRAIN:AXLE ASSEMBLY
OWNERS OF SOME VEHICLES EQUIPPED WITH HYDRA-MATIC 3T40, 4T60, 4T60-E OR 4T65-E TRANSAXLES MAY COMMENT ON A GRINDING AND / OR GROWLING NOISE THAT IS NOTICEABLE WHEN STANDING IN PARK ON A HILL OR SLOPE WITH THE ENGINE RUNNING AND THE PARKING
Dec 27, 2000 - 020000 SUSPENSION
SOME VEHICLES MAY EXHIBIT FRONT SUSPENSION SCRUNCH / POPPING TYPE NOISE COMING FROM THE FRONT OF VEHICLE THAT IS APPARENT DURING LOW SPEED TURNING MANEUVERS. *TT
Dec 26, 2000 - 061100 ENGINE AND ENGINE COOLING:ENGINE:GASOLINE
SOME V6 ENGINES MAY, ON A VERY INFREQUENT BASIS, HAVE AN OIL ODOR CONDITION THAT IS GENERALLY ENCOUNTERED AFTER THE ENGINE'S OIL HAS BEEN CHANGED.TYPICALLY THE ODOR LASTS APPROXIMATELY 1000 MILES AFTER THE CHANGE OF OIL AND THEN DOES NOT RE
View all Technical Service Bulletins
|
|