by General Motors, LLC
Pontiac Grand Prix Recall for Front Problem - (10 Recalls Found)
Find your car listed below. Results are sorted year from newest to oldest. Select the desired vehicle to view the complete details.
Information provided by the National Highway Traffic Safety Administration.
|
|
|
Problem: VEHICLE DESCRIPTION: PASSENGER, SPORT UTILITY VEHICLES AND MINIVANS. THE PASSENGER AIR BAG INFLATOR MODULES WERE BUILT WITHOUT THE CORRECT AMOUNT OF GENERANT, WHICH PRODUCES THE GAS THAT FILLS THE AIR BAG. SOME WERE BUILT WITH A DOUBLE LOAD OF GENERANT AND SOME WERE BUILT WITHOUT GENERANT. Recall Details
Problem: ON CERTAIN PASSENGER, SPORT UTILITY VEHICLES AND MINI VANS, SOME OF THESE VEHICLES HAVE A PASSENGER AIR BAG THAT WAS MANUFACTURED WITHOUT A CHECK VALVE PIN. AN AIR BAG WITHOUT THE CHECK VALVE PIN COULD PRODUCE INCREASED PRESSURE AT THE ONSET OF THE AIR BAG DEPLOYMENT AND REDUCED PRESSURE AFTERWARD. Recall Details
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE PASSENGER SIDE AIR BAG MODULES HAVE AN UNDERSIZED INFLATOR ORIFICE. Recall Details
Problem: ON CERTAIN PASSENGER VEHICLES AND MINI VANS, THE DRIVER'S AIR BAG INFLATOR MODULES COULD PRODUCE EXCESSIVE INTERNAL PRESSURE. IN THE EVENT OF A CRASH THAT WOULD TRIGGER A DRIVER'S AIR BAG DEPLOYMENT, THE INCREASED INTERNAL PRESSURE CAN CAUSE THE INFLATOR MODULE TO EXPLODE. Recall Details
Problem: THE CENTER REAR SEAT BELT ANCHOR PLATE EXHIBITS STRESS CRACKS. Recall Details
Problem: THE CENTER REAR SEAT BELT ANCHOR PLATE EXHIBITS STRESS CRACKS. Recall Details
Problem: THE FRONT SHOULDER BELT GUIDE LOOP ATTACHED TO THE UPPER REAR CORNER OF THE DOOR MAY INTERFERE WITH THE GARNISH MOLDING. Recall Details
Problem: SOME VEHICLES HAVE BUCKET SEAT BACK LOCKS THAT DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, ANCHORAGE OF SEATS. IN EVENT OF A CRASH, THE SEAT BACK LOCK MAY NOT FUNCTION. Recall Details
Problem: THE INVOLVED VEHICLES CONTAIN SPLIT FRONT BENCH SEATS THAT MAY NOT HAVE THE CORRECT OUTBOARD PORTIONS OF THE LEFT AND RIGHT FRONT SEAT BELTS INSTALLED. THIS CONDITION WILL NOT ALLOW THE SEAT BELTS TO BE BUCKLED AND THEREFORE CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES". Recall Details
Problem: UNDER CERTAIN DRIVING CONDITIONS, THESE VEHICLES CAN EXPERIENCE TEMPERATURES IN THE FRONT WHEEL OUTER BEARING AREA WHICH CAN AFFECT THE WHEEL BEARING GREASE. THIS CAN RESULT IN INADEQUATE LUBRICATION OF THE BEARING. THIS CONDITION MAY BE FURTHER AGGRAVATED BY IMPROPER ADJUSTMENT OF THE FRONT WHEEL SPINDLE NUT. Recall Details
|