|
Problem: SEAT PEDESTALS FOR DRIVER AND PASSENGERS MAY HAVE A LARGER THAN SPECIFIED SLOT IN THE CENTER CHANNEL. Recall Details
Problem: SEAT PEDESTALS FOR DRIVER AND PASSENGERS MAY HAVE A LARGER THAN SPECIFIED SLOT IN THE CENTER CHANNEL. Recall Details
Problem: SEAT PEDESTALS FOR DRIVER AND PASSENGERS MAY HAVE A LARGER THAN SPECIFIED SLOT IN THE CENTER CHANNEL. Recall Details
Problem: SEAT PEDESTALS FOR DRIVER AND PASSENGERS MAY HAVE A LARGER THAN SPECIFIED SLOT IN THE CENTER CHANNEL. Recall Details
Problem: LEFT HAND LOWER CONTROL ARM CAN CRACK AND COULD EVENTUALLY CAUSE THE LOWER BALL JOINT TO SEPARATE FROM THE CONTROL ARM. Recall Details
Problem: THREE BOLTS WHICH ATTACH THE SILL THAT SUPPORTS THE BASE OF THE SEAT WERE OMITTED; THEREFORE VEHICLES DO NOT COMPLY WITH FMVSS 210 AND FMVSS 207. CONSEQUENCE OF DEFECT: IN THE EVENT OF A CRASH, THE FLOOR PLATE COULD BUCKLE ALONG THE INBOARD SIDE CAUSING THE SEAT PEDESTAL TO BE IMBALANCED, AND INCREASING THE LIKELIHOOD OF INJURY TO THE SEAT OCCUPANT. Recall Details
Problem: LEFT HAND LOWER CONTROL ARM CAN CRACK AND COULD EVENTUALLY CAUSE THE LOWER BALL JOINT TO SEPARATE FROM THE CONTROL ARM. Recall Details
Problem: THE FAN BLADE, WHEN SUBJECTED TO HIGH STRESS LEVELS, CAN FATIGUE AND BREAK APART AT THE HUB WHILE THE ENGINE IS RUNNING. CONSEQUENCE OF DEFECT: IF BREAKAGE OCCURS WHILE HOOD IS OPEN, A PERSON WORKING UNDER THE HOOD OR NEAR THE TRUCK COULD BE STRUCK BY A BLADE PART AND BE INJURED. Recall Details
Problem: THE WHEEL MAY DEVELOP CRACKS BETWEEN THE DISC AND RIM. CONSEQUENCE OF DEFECT: IF THIS OCCURS AND IS NOT NOTICED, THE CRACK COULD INCREASE AROUND THE RIM, RESULTING IN SEPARATION OF THE RIM FROM THE DISC, LOSS OF CONTROL AND AN ACCIDENT MAY OCCUR. Recall Details
Problem: DURING A COMBINED CORNERING AND BRAKING MANEUVER, THE TIE ROD END COULD CONTACT THE TIRE WALL. CONSEQUENCE OF DEFECT: THIS CONTACT CAN CAUSE GROOVING OF THE TIRE, WHICH COULD EVENTUALLY RESULT IN TIRE FAILURE AND POSSIBLY A VEHICLE CRASH WITHOUT PRIOR WARNING. Recall Details
Problem: THREE BOLTS WHICH ATTACH THE SILL THAT SUPPORTS THE BASE OF THE SEAT WERE OMITTED; THEREFORE VEHICLES DO NOT COMPLY WITH FMVSS 210 AND FMVSS 207. CONSEQUENCE OF DEFECT: IN THE EVENT OF A CRASH, THE FLOOR PLATE COULD BUCKLE ALONG THE INBOARD SIDE CAUSING THE SEAT PEDESTAL TO BE IMBALANCED, AND INCREASING THE LIKELIHOOD OF INJURY TO THE SEAT OCCUPANT. Recall Details
Problem: THE FAN BLADE, WHEN SUBJECTED TO HIGH STRESS LEVELS, CAN FATIGUE AND BREAK APART AT THE HUB WHILE THE ENGINE IS RUNNING. CONSEQUENCE OF DEFECT: IF BREAKAGE OCCURS WHILE HOOD IS OPEN, A PERSON WORKING UNDER THE HOOD OR NEAR THE TRUCK COULD BE STRUCK BY A BLADE PART AND BE INJURED. Recall Details
Problem: DUE TO A MANUFACTURING PROBLEM WITH THE FUEL TANK FILLER PIPE, THE FUEL CAP MAY IMPROPERLY SEAL THE END OF THE FILLER PIPE. THIS FAILS TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY." IN THE EVENT OF A COLLISION, AN IMPROPERLY SEALED FILLER PIPE COULD ALLOW FUEL SPILLAGE. Recall Details
Problem: THE FAN BLADE, WHEN SUBJECTED TO HIGH STRESS LEVELS, CAN FATIGUE AND BREAK APART AT THE HUB WHILE THE ENGINE IS RUNNING. CONSEQUENCE OF DEFECT: IF BREAKAGE OCCURS WHILE HOOD IS OPEN, A PERSON WORKING UNDER THE HOOD OR NEAR THE TRUCK COULD BE STRUCK BY A BLADE PART AND BE INJURED. Recall Details
Problem: IN A VEHICLE IMPACT FROM THE REAR, THE THREE PIECE HOSES COULD SEPARATE AND RESULT IN FUEL LEAKAGE IN EXCESS OF THE AMOUNT PERMITTED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY". Recall Details
Problem: THE FAN BLADE, WHEN SUBJECTED TO HIGH STRESS LEVELS, CAN FATIGUE AND BREAK APART AT THE HUB WHILE THE ENGINE IS RUNNING. CONSEQUENCE OF DEFECT: IF BREAKAGE OCCURS WHILE HOOD IS OPEN, A PERSON WORKING UNDER THE HOOD OR NEAR THE TRUCK COULD BE STRUCK BY A BLADE PART AND BE INJURED. Recall Details
Problem: VEHICLES MAY BE SUBJECT TO ABRASIVE CONTACT BETWEEN THE REAR BRAKE HOSE/PIPE ASSEMBLY AND THE AXLE HOUSING WITH NORMAL BRAKE USAGE AND REAR PAD WEAR. SHOULD THIS CONDITION OCCUR, IT COULD LEAD TO A BRAKE HOSE/PIPE FAILURE, RESULTING IN LOSS OF BRAKE FLUID AND LOSS OF REAR BRAKING ACTION. Recall Details
Problem: THE FUEL TANK FUSIBLE BUSHING ELEMENT MAY HAVE MELTED DUE TO EXTREMELY HIGH TEMPERATURES ENCOUNTERED WHEN THE TANKS WERE EXPOSED TO DIRECT SUNLIGHT RAYS DURING CHASSIS STORAGE. Recall Details
Problem: THE INVOLVED VEHICLES DO NOT HAVE A BRAKE FLUID RESERVOIR WARNING WHICH STATES, "WARNING, CLEAN FILLER CAP BEFORE REMOVING. USE ONLY DOT 3 FLUID FROM A SEALED CONTAINER". THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". Recall Details
Problem: THE INTERMEDIATE SHAFT COUPLING ON THE INVOLVED VEHICLES MAY HAVE BEEN MACHINED OVERSIZED IN THE SERRATION AREA WHERE IT ATTACHES TO THE STEERING COLUMN. THIS WOULD PREVENT THE COUPLING FROM PROPERLY TIGHTENING ON THE SHAFT WHEN THE CLAMP AND PINCH BOLT WERE INSTALLED. Recall Details
Problem: THE PARKING BRAKE SWITCH CONNECTOR CONTAINS ELECTRICAL WIRES THAT MAY BE REVERSED. AS A RESULT, THE LAMP WILL BE ACTIVATED WHENEVER THE IGNITION IS TURNED ON, EVEN THOUGH THE PARKING BRAKE IS NOT ENGAGED. THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". THE STANDARD REQUIRES THAT THE INDICATOR LAMP BE ACTIVATED UPON APPLICATION OF THE PARKING BRAKE. Recall Details
Problem: THE INVOLVED VEHICLES DO NOT HAVE A BRAKE FLUID RESERVOIR WARNING WHICH STATES, "WARNING, CLEAN FILLER CAP BEFORE REMOVING. USE ONLY DOT 3 FLUID FROM A SEALED CONTAINER". THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". Recall Details
Problem: THE PARKING BRAKE SWITCH CONNECTOR CONTAINS ELECTRICAL WIRES THAT MAY BE REVERSED. AS A RESULT, THE LAMP WILL BE ACTIVATED WHENEVER THE IGNITION IS TURNED ON, EVEN THOUGH THE PARKING BRAKE IS NOT ENGAGED. THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". THE STANDARD REQUIRES THAT THE INDICATOR LAMP BE ACTIVATED UPON APPLICATION OF THE PARKING BRAKE. Recall Details
Problem: ON THE INVOLVED VEHICLES, THE BRAKE MASTER CYLINDER MAY HAVE BEEN ASSEMBLED WITH RESERVOIR MOUNTING BOLTS THAT WERE IMPROPERLY PROCESSED. THIS COULD MAKE THESE BOLTS BRITTLE AND SUBJECT TO BREAKING. IF BREAKAGE OCCURS, A BRAKE FLUID LEAK MAY DEVELOP BETWEEN THE RESERVOIR AND MASTER CYLINDER. LOSS OF BRAKE FLUID WOULD ADVERSELY AFFECT VEHICLE BRAKING CAPABILITY. Recall Details
Problem: THE FUEL TANK FUSIBLE BUSHING ELEMENT MAY HAVE MELTED DUE TO EXTREMELY HIGH TEMPERATURES ENCOUNTERED WHEN THE TANKS WERE EXPOSED TO DIRECT SUNLIGHT RAYS DURING CHASSIS STORAGE. Recall Details
Problem: ON THE INVOLVED VEHICLES, THE BRAKE MASTER CYLINDER MAY HAVE BEEN ASSEMBLED WITH RESERVOIR MOUNTING BOLTS THAT WERE IMPROPERLY PROCESSED. THIS COULD MAKE THESE BOLTS BRITTLE AND SUBJECT TO BREAKING. IF BREAKAGE OCCURS, A BRAKE FLUID LEAK MAY DEVELOP BETWEEN THE RESERVOIR AND MASTER CYLINDER. LOSS OF BRAKE FLUID WOULD ADVERSELY AFFECT VEHICLE BRAKING CAPABILITY. Recall Details
Problem: THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE. Recall Details
Problem: THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE. Recall Details
|