Latest MACK DMM SERIES Recallshttp://www.arfc.org/rss/feeds/autos/mack/dmm_seriesThe latest automotive recalls from the National Highway Transportation Safety AdministrationWed, 04 Dec 2024 08:40:40 GMTen-us1440Copyright 2024, Eladrel Technologies, LLCAutomotive1988 MACK DMM SERIES RECALLED FOR STEERING, HYDRAULIC POWER ASSIST, HOSE, PIPING, AND CONNECTIONSAN INCORRECT HIGH PRESSURE POWER STEERING HOSE MAY HAVE BEEN INSTALLED.http://www.arfc.org/commercial/mack/dmm_series/recalls/000005524000032030000000013/recall.aspxFri, 03 Mar 1989 00:00:00 GMT1988 MACK DMM SERIES RECALLED FOR SUSPENSION, REAR, SPRINGSDOWELS MAY HAVE BEEN OMITTED DURING SPRING CAP INSTALLATION; THIS WOULD PUT SHEAR LOAD ON THE FOUR (4) SPRING CAP BOLTS.http://www.arfc.org/commercial/mack/dmm_series/recalls/000005525000032030000000046/recall.aspxFri, 03 Mar 1989 00:00:00 GMT1987 MACK DMM SERIES RECALLED FOR STEERING, HYDRAULIC POWER ASSIST, HOSE, PIPING, AND CONNECTIONSAN INCORRECT HIGH PRESSURE POWER STEERING HOSE MAY HAVE BEEN INSTALLED.http://www.arfc.org/commercial/mack/dmm_series/recalls/000005524000032287000000013/recall.aspxFri, 03 Mar 1989 00:00:00 GMT1988 MACK DMM SERIES RECALLED FOR ENGINE AND ENGINE COOLING, ENGINECERTAIN ENGINE SUPPORT CASTINGS WERE PRODUCED WITH FAULTY METALLURGY AND COULD FAIL.http://www.arfc.org/commercial/mack/dmm_series/recalls/000005351000032030000000128/recall.aspxTue, 18 Oct 1988 00:00:00 GMT1988 MACK DMM SERIES RECALLED FOR STEERING, LINKAGESSOME OF THE NUTS/BOLTS USED TO FASTEN THE STEERING PITMAN ARM MAY LOOSEN.http://www.arfc.org/commercial/mack/dmm_series/recalls/000005315000032030000000015/recall.aspxWed, 27 Jul 1988 00:00:00 GMT1988 MACK DMM SERIES RECALLED FOR POWER TRAIN, DRIVELINE, CENTER SUPPORT BEARINGCLAMP PLATES USED BETWEEN THE DRIVE SHAFT AND CARRIER YOKES MAY CRACK AND COULD BREAK DUE TO IMPROPER HEAT TREATMENT.http://www.arfc.org/commercial/mack/dmm_series/recalls/000005273000032030000000193/recall.aspxMon, 23 May 1988 00:00:00 GMT1981 MACK DMM SERIES RECALLED FOR SEAT BELTSTHE INVOLVED TRUCKS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION", IN THAT THE EXTENDED RIDER"S SEAT WAS NOT EQUIPPED WITH A SEAT BELT AS REQUIRED.http://www.arfc.org/commercial/mack/dmm_series/recalls/000003734000033797000000263/recall.aspxWed, 08 Jul 1981 00:00:00 GMT1980 MACK DMM SERIES RECALLED FOR SEAT BELTSTHE INVOLVED TRUCKS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION", IN THAT THE EXTENDED RIDER"S SEAT WAS NOT EQUIPPED WITH A SEAT BELT AS REQUIRED.http://www.arfc.org/commercial/mack/dmm_series/recalls/000003734000033796000000263/recall.aspxWed, 08 Jul 1981 00:00:00 GMT