|
1992 Recalls ↓
Problem: THE ZINC PLATING OPERATION PERFORMED ON THE UPPER STEERING COLUMN SHAFT COUPLING BOLT CAUSED HYDROGEN EMBRITTLEMENT AND BREAKAGE OF THE BOLT. Recall Details - 2/14/1992
Problem: THE HOOD LATCH ASSEMBLY MAY NOT HAVE BEEN PROPERLY INSTALLED AND THE SECONDARY HOOD LATCH MAY BE PREVENTED FROM ENGAGING WHEN THE HOOD IS CLOSED. Recall Details - 5/13/1992
1991 Recalls ↓
Problem: THE OWNER'S MANUAL INCORRECTLY STATES THAT THE FRONT PASSENGER DOOR CANNOT BE OPENED FROM THE INSIDE IF THE DOOR IS LOCKED UNTIL THE LOCK CONTROL HANDLE HAS BEEN PULLED UP. ON THESE VEHICLES, THE FRONT PASSENGER DOOR CAN BE OPENED BY THE INSIDE DOOR HANDLE EVEN IF THE DOOR IS LOCKED. Recall Details - 2/11/1992
Problem: FRONT DISC BRAKE CALIPER GUIDE PIN BOLTS MAY NOT HAVE BEEN ADEQUATELY TORQUED AND COULD LOOSEN. Recall Details - 9/4/1990
Problem: THE TWO AIR BAG SYSTEM FRONT IMPACT SENSORS MAY NOT BE SECURED TO THEIR MOUNTING BRACKETS. Recall Details - 11/19/1990
Problem: MISMATCHED PARKING BRAKE CABLE LENGTHS TO THE REAR WHEELS REDUCES BRAKING ABILITY OF ONE OF THE REAR WHEELS, IN VIOLATION OF FMVSS 105. Recall Details - 5/14/1991
Problem: FRONT OUTBOARD SAFETY BELT MAY BECOME DIFFICULT TO LATCH AND OR UNLATCH DUE TO A WEBBING STIFFENER ENTERING THE BUCKLE HOUSING AND DISLODGING THE BUCKLE LATCH GUIDE. Recall Details - 7/11/1991
1990 Recalls ↓
Problem: THE ENGINE VALVE COVER GASKET MAY DISLOCATE AND ALLOW AN ENGINE OIL LEAK AT THE GASKET. Recall Details - 12/27/1989
Problem: AIR BAG INFLATOR MODULES MAY NOT CONTAIN DIFFUSER HOLES BETWEEN THE IGNITOR AND PROPELLANT CHAMBERS. Recall Details - 4/25/1990
1989 Recalls ↓
Problem: THE BONDED DISC BRAKE LININGS MAY SEPARATE FROM THE SHOES DUE TO A BONDING DEFICIENCY WHICH MAY ALLOW CORROSION DEGRADATION OF THE BOND ATTACHMENT. Recall Details - 2/11/1992
Problem: THE ENGINE VALVE COVER GASKET MAY DISLOCATE AND ALLOW AN ENGINE OIL LEAK AT THE GASKET. Recall Details - 12/27/1989
1987 Recalls ↓
Problem: DRIVERS FLOORMAT MISPOSITIONED SUCH AS TO INTERFERE WITH ACCELERATOR PEDAL. Recall Details - 7/16/1987
Problem: FUEL LEAKAGE MAY OCCUR IN LOW AMBIENT TEMPERATURE OPERATION AT CONNECTIONS OF AN ENGINE COMPARTMENT FUEL SUPPLY HOSE TO THE PRESSURE REGULATOR AND TO THE FUEL RAIL. Recall Details - 7/1/1988
1986 Recalls ↓
Problem: A SERVICE REPLACEMENT DRIVERS SEAT CUSHION (MANUAL SEAT TYPE) MAY CONTAIN WRONG CUSHION WITH A BRACE THAT COULD INTERFERE WITH POWER SEAT ADJUSTER MECHANISM AND CAUSE STRESS ON THE FRAME. Recall Details - 4/8/1988
Problem: A RESISTOR IN THE ELECTRONIC PANEL CLUSTER MAY BE SUBJECTED TO AN ELECTRICAL CURRENT OVERLOAD DUE TO FAILURE OF A SWITCHING TRANSISTOR. CONSEQUENCE OF DEFECT: THE OVERHEATED RESISTOR COULD IGNITE AND START AN INSTRUMENT PANEL FIRE. Recall Details - 2/19/1986
Problem: BATTERY CAP VENTS MAY BE PARTIALLY OR COMPLETELY BLOCKED WITH PLASTIC FLASHING. CONSEQUENCE OF DEFECT: A BUILD UP OF INTERNAL GAS PRESSURE COULD OCCUR WHICH COULD RESULT IN CASE RUPTURE, PARTICULARLY DURING POST CHARGING. SHOULD A PERSON BE IN THE VICINITY OF THE BATTERY WHEN THE CASE RUPTURES, THEY MAY BE INJURED BY THE RELEASED GASES AND/OR ACID. Recall Details - 4/10/1986
Problem: FUEL LEAKAGE MAY OCCUR IN LOW AMBIENT TEMPERATURE OPERATION AT CONNECTIONS OF AN ENGINE COMPARTMENT FUEL SUPPLY HOSE TO THE PRESSURE REGULATOR AND TO THE FUEL RAIL. Recall Details - 7/1/1988
1985 Recalls ↓
Problem: A SERVICE REPLACEMENT DRIVERS SEAT CUSHION (MANUAL SEAT TYPE) MAY CONTAIN WRONG CUSHION WITH A BRACE THAT COULD INTERFERE WITH POWER SEAT ADJUSTER MECHANISM AND CAUSE STRESS ON THE FRAME. Recall Details - 4/8/1988
Problem: FUEL LEAKAGE MAY OCCUR IN LOW AMBIENT TEMPERATURE OPERATION AT CONNECTIONS OF AN ENGINE COMPARTMENT FUEL SUPPLY HOSE TO THE PRESSURE REGULATOR AND TO THE FUEL RAIL. Recall Details - 7/1/1988
Problem: DRIVERS SEAT FRAME MAY EXPERIENCE FATIGUE FAILURE AT ONE (FRONT/OUTBOARD) OF ITS FOUR ATTACHMENTS. Recall Details - 1/31/1989
Problem: REQUIRED FRONT CENTER SEAT BELT ASSEMBLY WAS OMITTED. VEHICLES ARE NOT IN COMPLIANCE WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 209, SEAT BELT ASSEMBLIES. Recall Details - 12/23/1984
Problem: AN ENGINE COMPARTMENT FUEL HOSE ROUTED TO THE FUEL SYSTEM PRESSURE REGULATOR MAY HAVE AN INADEQUATELY TIGHTENED HOSE CLAMP. CONSEQUENCE OF DEFECT: THE FUEL HOSE COULD LEAK AND RESULT IN AN ENGINE COMPARTMENT FIRE. Recall Details - 1/1/1985
1984 Recalls ↓
Problem: THE POTENTIAL FOR FUEL LEAKAGE EXISTS IN THE ENGINE COMPARTMENT AT THE FUEL RESERVOIR SEAM AND ITS HOSE CONNECTIONS. THE FUEL RESERVOIR IS A SILVER COLORED CAN MOUNTED TO THE AIR CLEANER. Recall Details - 11/21/1984
1983 Recalls ↓
Problem: ON THE INVOLVED VEHICLES, IMPROPER ROUTING OF THE HYDRAULIC BRAKE TUBE COULD CAUSE IT TO CHAFE AGAINST THE PARK BRAKE CABLES. EVENTUALLY, THE BRAKE TUBE MAY FAIL AND BRAKE FLUID LEAKAGE MAY OCCUR. Recall Details - 9/9/1982
Problem: THE TRAVEL COMPUTER SYSTEM WIRING, ON THE INVOLVED VEHICLES, MAY BE IMPROPERLY CONNECTED. THIS CONDITION CAN CAUSE DAMAGE TO INTERNAL COMPONENTS. Recall Details - 9/24/1982
Problem: HYDRAULIC BRAKE TUBING ROUTED TO THE LEFT REAR WHEEL BRAKE SYSTEM MAY HAVE BEEN BENT OUT OF SHAPE DURING ASSEMBLY AND COULD CHAFE AGAINST THE EXHAUST SYSTEM HANGER BOLT. Recall Details - 12/9/1982
Problem: FRONT SUSPENSION CROSSMEMBER MAY CORRODE AND FAIL AT LOWER CONTROL ARM REAR PIVOT MOUNTS IF OPERATED WHERE SALT IS USED TO AID IN SNOW REMOVAL. Recall Details - 3/29/1989
1982 Recalls ↓
Problem: FRONT SUSPENSION CROSSMEMBER MAY CORRODE AND FAIL AT LOWER CONTROL ARM REAR PIVOT MOUNTS IF OPERATED WHERE SALT IS USED TO AID IN SNOW REMOVAL. Recall Details - 3/29/1989
Problem: THE AUTOMATIC SPEED CONTROL SWITCH MAY STICK IN THE "RESUME" POSITION RESTRICTING RETURN MOVEMENT. THIS WILL NOT ALLOW THE NORMAL BRAKE PEDAL OPERATION TO DEACTIVATE THE SYSTEM. Recall Details - 9/22/1981
Problem: CLAMP BOLTS INSTALLED ON CERTAIN VEHICLES MAY CONTAIN CRACKS. EVENTUALLY THESE BOLTS MAY BREAK THROUGH, CAUSING SEPARATION OF THE BALL JOINT FROM THE STEERING KNUCKLE. Recall Details - 5/27/1982
Problem: THE BRAKE HYDRAULIC SYSTEM BAY BE EQUIPPED WITH BRAKE FLUID CONTAINING AN EXCESS OF WATER. Recall Details - 6/15/1982
1981 Recalls ↓
Problem: ENGINE MAY LOSE POWER OR STALL DUE TO CARBURETOR FLOODING. THIS IS CAUSED BY A POOR ELECTRICAL GROUND ON THE CARBURETOR FUEL BOWL VENT SOLENOID. VEHICLES MAY ALSO HAVE DRIVEABILITY PROBLEMS WHILE THE ENGINE IS WARMING UP IN COLD WEATHER. THESE PROBLEMS INCLUDE ENGINE MISSING, SAGS, AND HESITATION. THIS IS CAUSED BY A STICKING CARBURETOR OXYGEN FEEDBACK SOLENOID. Recall Details - 5/5/1981
Problem: THE AUTOMATIC SPEED CONTROL SWITCH MAY STICK IN THE "RESUME" POSITION RESTRICTING RETURN MOVEMENT. THIS WILL NOT ALLOW THE NORMAL BRAKE PEDAL OPERATION TO DEACTIVATE THE SYSTEM. Recall Details - 9/22/1981
1980 Recalls ↓
Problem: THE FRONT BRAKE HOSE ROUTING ON THE INVOLVED VEHICLES MAY ALLOW INTERFERENCE BETWEEN THE HOSES AND THE FRONT TIRES DURING EXTREME TURNING ANGLES. Recall Details - 9/11/1979
1978 Recalls ↓
Problem: ON THE INVOLVED VEHICLES, THE HOOD SECONDARY CATCH SYSTEM MAY BE MISALIGNED WHICH MAY CAUSE THE SECONDARY CATCH TO MALFUNCTION. CONSEQUENTLY, THE HOOD MAY NOT BE SECURELY LATCHED. Recall Details - 12/28/1977
Problem: ON THE INVOLVED VEHICLES, DAMAGE TO THE FRONT WHEEL BRAKE HYDRAULIC SYSTEM COULD OCCUR DUE TO FRONT WHEEL BRAKE LINE TUBE CORROSION. FRONT WHEEL BRAKE HOSES MAY BECOME BRITTLE AND CRACK DUE TO PROLONGED OPERATION IN COLD TEMPERATURES. Recall Details - 10/25/1977
Problem: THE COLUMNS MAY CONTAIN STEERING SHAFTS IN WHICH THE STEERING COLUMN COUPLING ROLL PIN RETAINING NOTCH WAS MACHINED TOO DEEP. THIS MAY CAUSE THE STEERING WHEEL SHAFT TO BECOME DISENGAGED FROM THE REST OF THE STEERING ASSEMBLY. Recall Details - 11/28/1977
1977 Recalls ↓
Problem: ON THE INVOLVED VEHICLES, DAMAGE TO THE FRONT WHEEL BRAKE HYDRAULIC SYSTEM COULD OCCUR DUE TO FRONT WHEEL BRAKE LINE TUBE CORROSION. FRONT WHEEL BRAKE HOSES MAY BECOME BRITTLE AND CRACK DUE TO PROLONGED OPERATION IN COLD TEMPERATURES. Recall Details - 10/25/1977
Problem: ON THE INVOLVED VEHICLES, THE HOOD SECONDARY CATCH SYSTEM MAY BE MISALIGNED WHICH MAY CAUSE THE SECONDARY CATCH TO MALFUNCTION. CONSEQUENTLY, THE HOOD MAY NOT BE SECURELY LATCHED. Recall Details - 12/28/1977
1976 Recalls ↓
Problem: ON THE INVOLVED VEHICLES, DAMAGE TO THE FRONT WHEEL BRAKE HYDRAULIC SYSTEM COULD OCCUR DUE TO FRONT WHEEL BRAKE LINE TUBE CORROSION. FRONT WHEEL BRAKE HOSES MAY BECOME BRITTLE AND CRACK DUE TO PROLONGED OPERATION IN COLD TEMPERATURES. Recall Details - 10/25/1977
Problem: ON THE INVOLVED VEHICLES, THE HOOD SECONDARY CATCH SYSTEM MAY BE MISALIGNED WHICH MAY CAUSE THE SECONDARY CATCH TO MALFUNCTION. CONSEQUENTLY, THE HOOD MAY NOT BE SECURELY LATCHED. Recall Details - 12/28/1977
|