by General Motors, LLC
GMC P20 RECALLS - (5 Recalls Found)
Since 1969, GMC has issued a total of 2094 car recalls worldwide. Of those recalls, 5 have been for the GMC P20 starting in 1977. This accounts for approximately 3.6% of the 58048 car recalls issued by the NHTSA since 1966. The P20 accounts for less than 1.0% of all the GMC recalls issued since 1969. Compared to other car manufacturers, GMC ranks #8 in overall number of recalls issued by a car maker.
Please keep in mind these numbers are for statistical purposes only & do not necessarily reflect the quality of the GMC P20 or GMC itself. These figures are based only on the number of recalls issued and NOT the total number of vehicles affected by a particular recall.
Find your GMC P20 listed below. Results are sorted year from newest to oldest. Select the desired GMC P20 to view the complete recall details.
Information provided by the National Highway Traffic Safety Administration.
| View GMC P20 Recalls Below ↓ |
|
1982 Recalls ↓
Problem: THE REAR AXLE SHAFTS RECEIVED IMPROPER HEAT TREATMENT DURING MANUFACTURE. THE SHAFT MAY BREAK AND THE TIRE AND WHEEL ASSEMBLY COULD DISENGAGE FROM THE VEHICLE. Recall Details - 8/24/1982
Problem: IN A VEHICLE IMPACT FROM THE REAR, THE THREE PIECE HOSES COULD SEPARATE AND RESULT IN FUEL LEAKAGE IN EXCESS OF THE AMOUNT PERMITTED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY". Recall Details - 9/2/1983
1977 Recalls ↓
Problem: THE INVOLVED VEHICLES FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "ANCHORAGE OF SEATS", DUE TO POSSIBLE FAILURE OF THE SEAT POST ATTACHMENT AT THE FLOOR IN THE EVENT OF AN ACCIDENT. THESE VEHICLES HAVE OVERSIZED BOLT HOLES IN THE FLOOR PAN WHICH MAY ALLOW THE SEAT ATTACHING NUTS TO PASS THROUGH THEM AND THUS TIGHTEN AGAINST THE BOTTOM OF THE SEAT BASE INSTEAD OF THE LONGITUDINAL SILL. Recall Details - 12/14/1977
1976 Recalls ↓
Problem: THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE. Recall Details - 6/22/1977
1975 Recalls ↓
Problem: THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE. Recall Details - 6/22/1977
|