|
2000 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. AN INCORRECT LABEL WAS INSTALLED ON THE DRIVER SIDE REAR DOOR. THIS LABEL CONTAINS INSTRUCTIONS FOR THE ACTIVATION OF THE CHILDPROOF SAFETY LOCKS. Recall Details - 12/29/1999
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES NOT EQUIPPED WITH THE ANTI-LOCK BRAKING SYSTEM (ABS). A PRESSURE CONSCIOUS REDUCING VALVE (PCRV) IN THE REAR BRAKES MAY BE SUBJECT TO CORROSION AND RESULT IN MALFUNCTION, WHEN OPERATED IN AREAS THAT USE SALT COMPOUNDS ON THE ROADWAY FOR DE-ICING OR DUST CONTROL. Recall Details - 3/9/2000
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES." Recall Details - 8/18/2000
1999 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES NOT EQUIPPED WITH THE ANTI-LOCK BRAKING SYSTEM (ABS). A PRESSURE CONSCIOUS REDUCING VALVE (PCRV) IN THE REAR BRAKES MAY BE SUBJECT TO CORROSION AND RESULT IN MALFUNCTION, WHEN OPERATED IN AREAS THAT USE SALT COMPOUNDS ON THE ROADWAY FOR DE-ICING OR DUST CONTROL. Recall Details - 3/9/2000
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES BUILT WITH AUTOMATIC TRANSMISSIONS WHICH UTILIZE A PARK/LOCK SOLENOID. IT IS POSSIBLE TO ROTATE THE IGNITION KEY TO THE LOCK POSITION AND REMOVE THE KEY WITHOUT THE SHIFT LEVER AND TRANSMISSION BEING IN PARK. THESE VEHICLES DO NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 114, "THEFT PROTECTION." Recall Details - 3/17/1999
1998 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FLOOR SHIFT AUTOMATIC TRANSMISSION CONTROL CAN BE DAMAGED IF SUBJECTED TO CERTAIN INTERIOR CLEANING PRODUCTS. THE GEAR POSITION INDICATOR CAN DETERIORATE AND NOT CORRECTLY INDICATE THE ACTUAL GEAR POSITION. Recall Details - 9/18/1998
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE TERMINALS AT THE HEADLIGHT SWITCH AND WIRING HARNESS CONNECTOR CAN EXPERIENCE HEAT DAMAGE AS A RESULT OF OVERHEATING. Recall Details - 5/5/1999
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE ACCELERATOR CABLE MAY HAVE BEEN MANUFACTURED WITH A BURR ON OR NEAR THE END OF THE CABLE SLEEVE INTERIOR. THIS BURR COULD FRAY THE CORE WIRE RESULTING IN THE ACCELERATOR NOT RETURNING TO IDLE WHEN THE ACCELERATOR IS RELEASED. Recall Details - 7/20/1999
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE AIR BAG SENSOR WIRING PIGTAIL INSULATION CAN BECOME BRITTLE AND CRACK OVER TIME DUE TO ACCUMULATION OF WATER IN THE PIGTAIL PROTECTIVE CONVOLUTE IN COMBINATION WITH HIGH UNDERHOOD TEMPERATURES RELATED TO THE ROUTING OF THE WIRING PIGTAIL NEAR THE RADIATOR. THIS CAN RESULT IN ENVIRONMENTAL STRESS CRACKING OF THE INSULATION. Recall Details - 9/8/1999
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE TEXT AND/OR GRAPHICS FOR THE VEHICLE HEADLAMP AIMING INSTRUCTIONS PROVIDED IN THE OWNER GUIDES ARE NOT SUFFICIENTLY CLEAR. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Recall Details - 2/10/1998
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES NOT EQUIPPED WITH THE ANTI-LOCK BRAKING SYSTEM (ABS). A PRESSURE CONSCIOUS REDUCING VALVE (PCRV) IN THE REAR BRAKES MAY BE SUBJECT TO CORROSION AND RESULT IN MALFUNCTION, WHEN OPERATED IN AREAS THAT USE SALT COMPOUNDS ON THE ROADWAY FOR DE-ICING OR DUST CONTROL. Recall Details - 3/9/2000
Problem: ON CERTAIN MY 1996-1998 PASSENGER VEHICLES BUILT AT THE KANSAS CITY, CUAUTITLAN ASSEMBLY PLANTS OR ON MY 1999 PASSENGER VEHCLES BUILT AT THE AUTOMOTIVE ALLIANCE INTERNATIONAL ASSEMBLY PLANTS, THE ROUGH SURFACE OF THE HEATER BLOWER RESISTOR'S STAINLESS STEEL BLADES CAN DAMAGE THE COPPER SURFACE OF THE WIRING HARNESS CONNECTOR. THE DAMAGE COULD, OVER TIME, CAUSE INCREASED RESISTANCE IN THE CONNECTOR AND, DUE TO SUBSEQUENT TERMINAL RELAXATION, RESULT IN AN OPEN CIRCUIT CONDITION. Recall Details - 7/9/2001
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES BUILT AT THE KANSAS CITY ASSEMBLY PLANT AND ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, AND WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT COIL SPRINGS MAY FRACTURE AS A RESULT OF CORROSION IN HIGH CORROSION ENVIRONMENTS. DEPENDING ON THE LOCATION OF THE FRACTURE, A BROKEN SPRING COULD MOVE PAST THE SPRING SEAT AND CONTACT A FRONT TIRE. Recall Details - 8/8/2001
1997 Recalls ↓
Problem: ON CERTAIN MY 1996-1998 PASSENGER VEHICLES BUILT AT THE KANSAS CITY, CUAUTITLAN ASSEMBLY PLANTS OR ON MY 1999 PASSENGER VEHCLES BUILT AT THE AUTOMOTIVE ALLIANCE INTERNATIONAL ASSEMBLY PLANTS, THE ROUGH SURFACE OF THE HEATER BLOWER RESISTOR'S STAINLESS STEEL BLADES CAN DAMAGE THE COPPER SURFACE OF THE WIRING HARNESS CONNECTOR. THE DAMAGE COULD, OVER TIME, CAUSE INCREASED RESISTANCE IN THE CONNECTOR AND, DUE TO SUBSEQUENT TERMINAL RELAXATION, RESULT IN AN OPEN CIRCUIT CONDITION. Recall Details - 7/9/2001
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE TERMINALS AT THE HEADLIGHT SWITCH AND WIRING HARNESS CONNECTOR CAN EXPERIENCE HEAT DAMAGE AS A RESULT OF OVERHEATING. Recall Details - 5/5/1999
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES NOT EQUIPPED WITH THE ANTI-LOCK BRAKING SYSTEM (ABS). A PRESSURE CONSCIOUS REDUCING VALVE (PCRV) IN THE REAR BRAKES MAY BE SUBJECT TO CORROSION AND RESULT IN MALFUNCTION, WHEN OPERATED IN AREAS THAT USE SALT COMPOUNDS ON THE ROADWAY FOR DE-ICING OR DUST CONTROL. Recall Details - 3/9/2000
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FLOOR SHIFT AUTOMATIC TRANSMISSION CONTROL CAN BE DAMAGED IF SUBJECTED TO CERTAIN INTERIOR CLEANING PRODUCTS. THE GEAR POSITION INDICATOR CAN DETERIORATE AND NOT CORRECTLY INDICATE THE ACTUAL GEAR POSITION. Recall Details - 9/18/1998
1996 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE TERMINALS AT THE HEADLIGHT SWITCH AND WIRING HARNESS CONNECTOR CAN EXPERIENCE HEAT DAMAGE AS A RESULT OF OVERHEATING. Recall Details - 5/5/1999
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FUEL FILLER PIPE VENT HOSE MAY HAVE LESS THAN THE INTENDED LEVEL OF OZONE RESISTANCE, WHICH COULD RESULT IN THE HOSE BECOMING BRITTLE AND CRACKING. Recall Details - 9/13/1999
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH THE TRACTION CONTROL OPTION. THE THROTTLE CABLES WERE DAMAGED DURING VEHICLE ASSEMBLY LEADING TO FRAYING OR SEPARATION OF THE THROTTLE CABLE. Recall Details - 12/8/1997
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FLOOR SHIFT AUTOMATIC TRANSMISSION CONTROL CAN BE DAMAGED IF SUBJECTED TO CERTAIN INTERIOR CLEANING PRODUCTS. THE GEAR POSITION INDICATOR CAN DETERIORATE AND NOT CORRECTLY INDICATE THE ACTUAL GEAR POSITION. Recall Details - 9/18/1998
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES NOT EQUIPPED WITH THE ANTI-LOCK BRAKING SYSTEM (ABS). A PRESSURE CONSCIOUS REDUCING VALVE (PCRV) IN THE REAR BRAKES MAY BE SUBJECT TO CORROSION AND RESULT IN MALFUNCTION, WHEN OPERATED IN AREAS THAT USE SALT COMPOUNDS ON THE ROADWAY FOR DE-ICING OR DUST CONTROL. Recall Details - 3/9/2000
Problem: VEHICLE DESCRIPTION: 1995 PASSENGER VEHICLES EQUIPPED WITH THE 2.0L AND 2.5L ENGINES, AND 1996 VEHICLES EQUIPPED WITH 2.5L ENGINES. TIGHTENING OF THE ENGINE COOLING FAN MOTOR BEARINGS, UP TO AND INCLUDING MOTOR STALL, CAN RESULT IN INCREASED MOTOR TORQUE AND HIGHER THAN NORMAL MOTOR CURRENT AND ACCOMPANYING HIGH MOTOR TEMPERATURES. Recall Details - 11/6/2000
Problem: ON CERTAIN MY 1996-1998 PASSENGER VEHICLES BUILT AT THE KANSAS CITY, CUAUTITLAN ASSEMBLY PLANTS OR ON MY 1999 PASSENGER VEHCLES BUILT AT THE AUTOMOTIVE ALLIANCE INTERNATIONAL ASSEMBLY PLANTS, THE ROUGH SURFACE OF THE HEATER BLOWER RESISTOR'S STAINLESS STEEL BLADES CAN DAMAGE THE COPPER SURFACE OF THE WIRING HARNESS CONNECTOR. THE DAMAGE COULD, OVER TIME, CAUSE INCREASED RESISTANCE IN THE CONNECTOR AND, DUE TO SUBSEQUENT TERMINAL RELAXATION, RESULT IN AN OPEN CIRCUIT CONDITION. Recall Details - 7/9/2001
1995 Recalls ↓
Problem: VEHICLE DESCRIPTION: 1995 PASSENGER VEHICLES EQUIPPED WITH THE 2.0L AND 2.5L ENGINES, AND 1996 VEHICLES EQUIPPED WITH 2.5L ENGINES. TIGHTENING OF THE ENGINE COOLING FAN MOTOR BEARINGS, UP TO AND INCLUDING MOTOR STALL, CAN RESULT IN INCREASED MOTOR TORQUE AND HIGHER THAN NORMAL MOTOR CURRENT AND ACCOMPANYING HIGH MOTOR TEMPERATURES. Recall Details - 11/6/2000
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FLOOR SHIFT AUTOMATIC TRANSMISSION CONTROL CAN BE DAMAGED IF SUBJECTED TO CERTAIN INTERIOR CLEANING PRODUCTS. THE GEAR POSITION INDICATOR CAN DETERIORATE AND NOT CORRECTLY INDICATE THE ACTUAL GEAR POSITION. Recall Details - 9/18/1998
Problem: A METAL SHIELD ON THE OUTSIDE OF THE PLASTIC FUEL FILLER PIPE CAN DEVELOP A STATIC ELECTRICAL CHARGE DURING REFUELING OF THE VEHICLE. Recall Details - 9/29/1994
Problem: THE FUEL TANK FILLER PIPE OPENING REINFORCEMENT CAN LEAK AT THE WELD. Recall Details - 10/18/1994
Problem: THE GLASS TEMPERING PROCESS ON THE RIGHT HAND REAR DOOR WINDOWS WAS NOT CORRECTLY PERFORMED. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 205, "GLAZING MATERIALS." Recall Details - 1/24/1995
Problem: CRACKS HAVE BEEN FOUND IN THE FRONT SAFETY BELT OUTBOARD ANCHOR TABS DUE TO A COMBINATION OF HYDROGEN EMBRITTLEMENT OF THE TAB AND STRESS INTRODUCED DURING ATTACHMENT OF THE ANCHOR TAB TO THE SEAT FRAME. THIS DOES NOT CONFORM WITH THE REQUIREMENTS OF FMVSS NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." Recall Details - 12/4/1995
Problem: THE FUEL TANK FILLER PIPE OPENING REINFORCEMENT, CONSTRUCTED FROM TWO SEPARATELY MOLDED PIECES, CAN LEAK AT THE WELD. Recall Details - 12/5/1995
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH THE TRACTION CONTROL OPTION. THE THROTTLE CABLES WERE DAMAGED DURING VEHICLE ASSEMBLY LEADING TO FRAYING OR SEPARATION OF THE THROTTLE CABLE. Recall Details - 12/8/1997
|