NISSAN 200SX RECALLS - (8 Recalls Found)
Since 1978, NISSAN has issued a total of 1903 car recalls worldwide. Of those recalls, 8 have been for the NISSAN 200SX starting in 1980. This accounts for approximately 3.3% of the 58048 car recalls issued by the NHTSA since 1966. The 200SX accounts for less than 1.0% of all the NISSAN recalls issued since 1978. Compared to other car manufacturers, NISSAN ranks #11 in overall number of recalls issued by a car maker.
Please keep in mind these numbers are for statistical purposes only & do not necessarily reflect the quality of the NISSAN 200SX or NISSAN itself. These figures are based only on the number of recalls issued and NOT the total number of vehicles affected by a particular recall.
Find your NISSAN 200SX listed below. Results are sorted year from newest to oldest. Select the desired NISSAN 200SX to view the complete recall details.
Information provided by the National Highway Traffic Safety Administration.
| View NISSAN 200SX Recalls Below ↓ |
|
1998 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. WATER CAN ENTER AND DISPLACE THE GREASE IN THE WIPER ARM LINKAGE BALL JOINT WHERE THE WIPER LINKAGE ATTACHES TO THE WIPER MOTOR LINKAGE. Recall Details - 5/5/1998
1997 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. WATER CAN ENTER AND DISPLACE THE GREASE IN THE WIPER ARM LINKAGE BALL JOINT WHERE THE WIPER LINKAGE ATTACHES TO THE WIPER MOTOR LINKAGE. Recall Details - 5/5/1998
1996 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. WATER CAN ENTER AND DISPLACE THE GREASE IN THE WIPER ARM LINKAGE BALL JOINT WHERE THE WIPER LINKAGE ATTACHES TO THE WIPER MOTOR LINKAGE. Recall Details - 5/5/1998
1995 Recalls ↓
Problem: VEHICLE DESCRIPTION: PASSENGER VEHICLES. WATER CAN ENTER AND DISPLACE THE GREASE IN THE WIPER ARM LINKAGE BALL JOINT WHERE THE WIPER LINKAGE ATTACHES TO THE WIPER MOTOR LINKAGE. Recall Details - 5/5/1998
Problem: THE ANTI-LOCK BRAKING SYSTEM (ABS) HYDRAULIC ACTUATOR WAS NOT PROPERLY PURGED OF ALL AIR DURING THE FILL AND EVACUATION PROCESS CAUSING AIR BUBBLES TO GET INTO THE BRAKE SYSTEM. Recall Details - 3/1/1995
1988 Recalls ↓
Problem: THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY. Recall Details - 5/24/1995
1987 Recalls ↓
Problem: THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY. Recall Details - 5/24/1995
1980 Recalls ↓
Problem: MOISTURE PRESENT IN THE EXHAUST GAS RECIRCULATION SYSTEM MAY, UNDER CONDITIONS OF SUB-ZERO TEMPERATURES AND LOW EGR FLOW RATE, CONDENSE AND FREEZE IN THE THROTTLE CHAMBER. AN ICING CONDITION COULD OCCUR IF THE VEHICLE OWNER FAILS TO ADEQUATELY WARM UP THE ENGINE BEFORE DRIVING. THIS COULD PREVENT THE THROTTLE FROM CLOSING COMPLETELY AND WOULD RESULT IN HIGHER THAN NORMAN IDLE RPM. Recall Details - 8/28/1980
|