|
1984 Recalls ↓
Problem: SOME VEHICLES HAVE BUCKET SEAT BACK LOCKS THAT DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, ANCHORAGE OF SEATS. IN EVENT OF A CRASH, THE SEAT BACK LOCK MAY NOT FUNCTION. Recall Details - 2/6/1984
Problem: THE FUEL SYSTEM MAY LEAK AT THE THROTTLE BODY INJECTION FUEL FEED PIPE CONNECTION. CONSEQUENCE OF DEFECT: THIS LEAKAGE COULD RESULT IN AN UNDERHOOD FIRE WHICH COULD SPREAD TO THE PASSENGER COMPARTMENT AND CAUSE BURN INJURIES TO OCCUPANTS. Recall Details - 3/29/1985
1983 Recalls ↓
Problem: THE BRAKE PROPORTIONER VALVES MAY BREAK AND SEPARATE FROM THE MASTER CYLINDER. THIS WOULD ALLOW BRAKE FLUID TO LEAK AND WOULD RESULT IN A PARTIAL LOSS OF THE BRAKE SYSTEM. Recall Details - 10/13/1983
1982 Recalls ↓
Problem: THE CLUTCH CABLE MAY RUB AGAINST THE MASTER CYLINDER BRAKE PIPE WHEN THE CLUTCH PEDAL IS OPERATED. CONTINUED OPERATION OF THE VEHICLE MAY RESULT IN WEAR THROUGH OF THE INSULATION ON THE CLUTCH CABLE. THE RESULTING METAL ON METAL CONTACT COULD LEAD TO FAILURE OF THE BRAKE PIPE, LOSS OF BRAKE FLUID, AND PARTIAL LOSS OF BRAKE ACTION. Recall Details - 3/2/1982
Problem: UNDER CERTAAIN CONDITIONS, THE HOSE CLAMPS ON THE FUEL TANK FILLER PIPE AND FUEL TANK FILLER VENT PIPE COULD FRACTURE. THE FRACTURE OF THESE CLAMPS COULD CAUSE FUEL LEAKAGE AT ANY OF THE FOUR PIPE TO HOSE CONNECTIONS. LEAKAGE CAN OCCUR DURING REFUELING, OR WHILE DRIVING, IF THE FUEL TANK IS ABOVE 3/4 FULL. Recall Details - 3/8/1982
Problem: REAR BRAKE HOSES MAY HAVE BEEN MANUFACTURED INCORRECTLY WHEN THE METAL END FITTINGS WERE INSTALLED. SOME REAR BRAKE HOSES MAY SEPARATE FROM THE METAL END FITTINGS WHEN SUBJECTED TO THE PULLING FORCE SPECIFIED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD 106, "BRAKE HOSES". Recall Details - 1/1/1983
1981 Recalls ↓
Problem: THE INVOLVED VEHICLES MAY HAVE BEEN ASSEMBLED WITH THE POWER STEERING HOSE INCORRECTLY ROUTED. THE POWER STEERING HOSE MAY THEN CONTACT THE EXHAUST MANIFOLD, RESULTING IN DETERIORATION AND EVENTUAL FAILURE OF THE HOSE AND LEAKAGE OF POWER STEERING FLUID ONTO THE EXHAUST MANIFOLD. Recall Details - 10/8/1980
Problem: THE ENGINE-TO-BODY GROUND CABLE ON CERTAIN VEHICLES MAY HAVE BEEN DAMAGED DURING MANUFACTURE. THE CABLE COULD EVENTUALLY BREAK DUE TO THE RELATIVE MOTION BETWEEN THE ENGINE AND BODY DURING VEHICLE OPERATION. Recall Details - 3/24/1981
1980 Recalls ↓
Problem: UNDER CERTAIN CONDITIONS, THE REAR BRAKES COULD LOCK UP WITHOUT PRIOR WARNING DURING HIGH DECELERATION BRAKING. THE PROBLEM MAY BE CAUSED BY DEFECTIVE PROPORTIONER VALVES IN THE BRAKING SYSTEM. Recall Details - 8/10/1981
Problem: THERE IS A POTENTIAL FOR INTERFERENCE BETWEEN THE CLUTCH CONTROL CABLE AND BRAKE PIPE IN THE MASTER CYLINDER. THIS CAN RESULT IN RUBBING CONTACT WHEN THE CLUTCH PEDAL IS OPERATED. ALSO, THE BRAKE PIPE CLEARANCE TO THE TRANSMISSION CASE MAY BE INADEQUATE. IF THIS CONDITION EXISTS, IT COULD EVENTUALLY RESULT IN A FAILURE IN THE BRAKE PIPE, CAUSING LOSS OF BRAKE FLUID AND PARTIAL LOSS OF BRAKING ACTION. Recall Details - 4/5/1979
Problem: FUEL HOSES MAY BE INCORRECTLY POSITIONED AND CONTACT THE RIGHT FRONT DRIVE AXLE BOOT DURING VEHICLE OPERATION. AFTER A PERIOD OF TIME, THE ROTATING BOOT COULD WEAR A HOLE IN THE FUEL HOSE, RESULTING IN FULE LEAKAGE. Recall Details - 4/5/1979
Problem: THE LONGITUDINAL BODY BARS AT THE REAR CONTROL ARM LOCATION MAY NOT HAVE BEEN ADEQUATELY WELDED INTO THE STRUCTURE. SOME OF THESE BARS MAY HAVE BEEN PULLED DOWN FROM THE BODY DURING SHIPMENT WITH RESULTING DAMAGE TO THE BRAKE OR FUEL LINES. SEPARATION OF THE CONTROL ARM ATTACHMENT MAY ALSO RESULT. Recall Details - 4/5/1979
Problem: THE FRONT SUSPENSION COIL SPRING MAY HAVE A LARGER THAN DESIRED INSIDE DIAMETER OF THE LOWER COIL WHERE IT RESTS ON THE SPRING SEAT. THIS COULD ALLOW THE SPRING TO BE FORCED OVER THE LOWER SPRING SEAT DUE TO SUSPENSION FORCES. Recall Details - 4/17/1979
Problem: THE AUTOMATIC COOLER LINE HOSES ON SOME OF THE SUSPECT VEHICLES MAY CONTAIN MATERIAL VOIDS, WHICH COMBINED WITH A HIGH THERMAL EXPANSION AT ELEVATED TEMPERATURES, COULD RESULT IN HOSE FAILURE AND TRANSMISSION FLUID LEAKAGE. Recall Details - 9/25/1979
Problem: THE STEERING GEAR MOUNTING PLATE ON THE INVOLVED VEHICLES MAY DEVELOP FATIGUE CRACKS AT HIGH MILEAGE WHICH WOULD ALLOW THE STEERING GEAR ATTACHMENT TO BECOME LOOSE. IF THIS CONDITION EXISTS, THE DRIVER MAY NOTICE CONSIDERABLE "FREE PLAY" IN THE STEERING WHEEL. Recall Details - 10/17/1979
Problem: UNDER CERTAIN CONDITIONS, VEHICLES MAY EXPERIENCE PREMATURE REAR WHEEL SKID DURING BRAKING. REAR WHEEL SKIDDING IS MOST LIKELY TO OCCUR ON A WET OR SLICK SURFACE. Recall Details - 2/24/1983
1978 Recalls ↓
Problem: THE HUB PORTION OF THE FAN BLADE ASSEMBLY COULD CRACK DUE TO HIGH STRESS LEVELS GENERATED DURING ENGINE OPERATING CONDITIONS. EVENTUALLY, THE BLADE COULD BREAK APART AT THE HUB AND BLADE PIECES COULD BE PROPELLED INTO THE ENGINE. IF THE HOOD IS OPEN WHILE THE ENGINE IS RUNNING, THE FRAGMENTS WOULD BE FREE TO FLY FROM THE VEHICLE. Recall Details - 6/13/1978
Problem: THE REAR AXLE SHAFTS ON THE INVOLVED VEHICLES MAY HAVE A FLAW IN THE METAL. AS A RESULT, THE SHAFT MAY BREAK, WHICH WOULD ALLOW THE TIRE AND WHEEL ASSEMBLY TO SEPARATE FROM THE VEHICLE. Recall Details - 9/27/1977
1977 Recalls ↓
Problem: THE REAR AXLE SHAFTS ON THE INVOLVED VEHICLES MAY HAVE A FLAW IN THE METAL. AS A RESULT, THE SHAFT MAY BREAK, WHICH WOULD ALLOW THE TIRE AND WHEEL ASSEMBLY TO SEPARATE FROM THE VEHICLE. Recall Details - 9/27/1977
|