by General Motors, LLC
SATURN L200 RECALLS - (4 Recalls Found)
Since 1992, SATURN has issued a total of 233 car recalls worldwide. Of those recalls, 4 have been for the SATURN L200 starting in 2002. This accounts for less than 1.0% of the 58048 car recalls issued by the NHTSA since 1966. The L200 accounts for about 1.7% of all the SATURN recalls issued since 1992. Compared to other car manufacturers, SATURN ranks #39 in overall number of recalls issued by a car maker.
Please keep in mind these numbers are for statistical purposes only & do not necessarily reflect the quality of the SATURN L200 or SATURN itself. These figures are based only on the number of recalls issued and NOT the total number of vehicles affected by a particular recall.
Find your SATURN L200 listed below. Results are sorted year from newest to oldest. Select the desired SATURN L200 to view the complete recall details.
Information provided by the National Highway Traffic Safety Administration.
| View SATURN L200 Recalls Below ↓ |
|
2003 Recalls ↓
Problem: CERTAIN SPORT UTILITY AND PASSENGER VEHICLES EXHIBIT A CONDITION IN WHICH THE WINDSHIELD WIPER MOTOR COULD FAIL DURING USE BECAUSE OF IMPROPER MANUFACTURE. Recall Details - 10/29/2002
Problem: ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.2L L4 (L61) ENGINES, A FAILURE OF THE IGNITION CONTROL MODULE MAY CAUSE DETERIORATION IN IDLE QUALITY, REDUCTION IN OVERALL ENGINE POWER, AND THE VEHICLE MAY BE HARD TO START. CONTINUED OPERATION OF THE VEHICLE AFTER SUCH AN IGNITION MODULE FAILURE WILL RESULT IN THE "SERVICE ENGINE SOON" LIGHT FLASHING, AND MAY LEAD TO SECONDARY FAILURES OF THE CATALYTIC CONVERTER, OXYGEN SENSOR, AND EXHAUST RESONATOR. Recall Details - 6/23/2003
Problem: CERTAIN WAGONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THE SEAT BELT ANCHOR MAY SEPARATE FROM THE FLOOR OF THE VEHICLE BEFORE HOLDING THE REQUIRED TEST LOAD FOR THE REQUIRED TIME. Recall Details - 4/20/2005
Problem: ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME. Recall Details - 6/2/2005
|