AMTRAN Recalls

May 20, 2003 – CERTAIN SCHOOL BUSES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 217, "BUS EMERGENCY EXITS AND WINDOW RETENTION AND RELEASE." THESE BUSES DO NOT COMPLY WITH THE EMERGENCY EXIT REQUIREMENTS.

Mar 27, 2003 – CERTAIN SCHOOL BUSES EQUIPPED WITH FLIP SEATS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 217, "BUS EMERGENCY EXITS AND WINDOW RETENTION AND RELEASE." SEATS WITH SEAT BELTS WERE BOLTED TO THE FLOOR WITHOUT THE USE OF REQUIRED REINFORCEMENTS UNDER THE FLOOR.

Feb 20, 2003 – ON CERTAIN SCHOOL BUS WARNING LAMPS, A STATIC ELECTRICITY DISCHARGE CAN OCCUR DURING NORMAL SERVICES OR HANDLING. THIS DISCHARGE CAN POTENTIALLY INITIATE A CHEMICAL REACTION OF MATERIALS WITHIN THE LAMP WHICH COULD CAUSE THE LENS TO FRACTURE.

Dec 30, 2002 – ON CERTAIN BUSES EQUIPPED WITH HYDRAULIC BRAKES, THE MASTER CYLINDER WAS DAMAGED DURING THE FILL AND BLEED PROCEDURE.

Aug 07, 2002 – CERTAIN SCHOOL BUSES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD (FMVSS) NO. 221, "SCHOOL BUS BODY JOINT STRENGTH." THE ENTRANCE DOOR STEPWELL VERTICAL JOINTS WERE BUILT WITH AN INADEQUATE NUMBER OF FASTENERS.

Jul 12, 2002 – CERTAIN SCHOOL BUSES EQUIPPED WITH AN OPTIONAL BETWEEN-THE-FRAME MOUNTED FUEL TANKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD (FMVSS) NO. 301, "FUEL SYSTEM INTEGRITY." THESE BUSES WERE BUILT WITH THE WRONG CROSSMEMBER. THE CROSSMEMBER INSTALLED WAS NOT OF THE SAME STRENGTH THAT WAS USED IN THE CERTIFICATION OF THE FUEL SYSTEM TO FMVSS NO. 301.

Nov 20, 2001 – VEHICLE DESCRIPTION: CERTAIN BUSES WERE BUILT WITH A WIRING DIAGRAM DECAL THAT SHOWS THE CIRCUIT PROTECTION SIZE OF 30 AMPERES INSTEAD OF 20 AMPERES FOR THE HEATER SUPPLY CIRCUITS.

Nov 20, 2001 – VEHICLE DESCRIPTION: CERTAIN SCHOOL AND TRANSIT BUSES WERE BUILT WITH A POOR QUALITY HEATER/DEFROSTER BLOWER SWITCH. IN SOME CASES THIS HAS CAUSED THE MELTING OF THE HEATER HARNESS CONNECTOR AT THE SWITCH TERMINALS OR THE HIGH-SPEED WIRE INSULATION AT THE CONNECTOR. ALSO, SOME OF THE UNITS HAD IMPROPER CIRCUIT PROTECTION SIZE INSTALLED IN THE HEATER DEFROSTER CIRCUIT.

Nov 15, 2001 – VEHICLE DESCRIPTION: CERTAIN BUSES WERE BUILT WITH AN IMPROPER CONNECTION OF THE HEATER HARNESS FROM THE HEATER SWITCH TO THE CONNECTOR JUST OUTSIDE THE HEATER UNIT. THE ASSEMBLY LEFT A LOOSE HOT WIRE IN THE HEATER HARNESS WITH AN UNPROTECTED TERMINAL THAT COULD CAUSE A DIRECT SHORT. THIS WIRE IS PROTECTED WITH A 20-AMPERE CIRCUIT PROTECTION, BUT IN A RARE CASE COULD CAUSE A FIRE.

Aug 26, 2001 – VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES EQUIPPED WITH 39-INCH FLIP SEATS. THE FLIP SEATS COULD BIND IN THE OCCUPIED POSITION AND NOT RETURN TO THE STORED POSITION WHEN NOT OCCUPIED. THE CUSHION FRAME SUPPORT BAR SLIDES OFF THE SEAT SUPPORT PAD, WHICH COULD RETAIN THE SEAT IN THE OCCUPIED POSITION.