FORD B SERIES Recalls

Aug 27, 2007 – CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

May 24, 1990 – INCORRECT SIZE MASTER CYLINDER INSTALLED WILL PROVIDE LESS LINE PRESSURE TO WHEEL CYLINDERS FOR A GIVEN PEDAL PRESSURE.

Apr 27, 1987 – DIESEL ENGINE GOVEERNOR LEVER ASSEMBLIES MAY HAVE BEEN IMPROPERLY ASSEMBLED SO THAT ONE OR MORE OF THREE RETAINING PRONGS MAY NOT BE ENGAGED IN THE GOVERNOR LEVER PIVOT SHAFTS.

Dec 20, 1985 – THE HYDRAULIC PARKING BRAKE CONTROL VALVE MAY INADVERTENTLY ACTIVATE DUE TO MOMENTARY PRESSURE DISRUPTIONS WITHIN THE SYSTEM AND CAUSE THE PARKING BRAKE TO BE APPLIED, STOPPING OR SLOWING THE TRUCK UNEXPECTEDLY. CONSEQUENCE OF DEFECT: THIS UNEXPECTED STOPPING OR SLOWING OF THE TRUCK MAY INCREASE THE RISK OF A REAR END COLLISION SINCE THE BRAKE (STOP) LIGHTS ARE NOT ACTIVATED. ALSO, ON CERTAIN ROAD CONDITIONS THIS OCCURRENCE MAY RESULT IN LOSS OF VEHICLE CONTROL WHICH WOULD LEAD TO AN ACCIDENT.

Mar 22, 1983 – SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF MAINTAINING IT.

Mar 29, 1979 – CERTAIN AIR BRAKE ANTI-LOCK MODULATORS COULD MALFUNCTION DURING OPERATION OF THE ANTI-LOCK SYSTEM. A NYLON PISTON WITHIN THE MODULATOR AIR VALVE SYSTEM CAN SWELL FROM EXPOSURE TO SYSTEM CONTAMINANTS. CONTINUED EXPOSURE MAY CAUSE THE PISTON TO SWELL TO THE EXTENT THAT INTERFERENCE WITH THE CYLINDER WALL WILL RESULT, CAUSING MOMENTARY STICKING OR A PERMANENT JAM. THIS CAN RESULT IN TEMPORARY OR PERMANENT LOSS OF BRAKING FOR THE AFFECTED AXLE.

Jul 03, 1978 – THE ENGINE COOLING FAN BLADES MAY CRACK AND CHIP DUE TO HIGH STRESSES CAUSED BY VIBRATIONS. THE CHIPPED PIECES OF THE BLADE COULD FLY INTO THE UNDERHOOD COMPONENTS. ALSO, THESE PIECES COULD FLY OUT FROM THE VEHICLE IF THE HOOD IS OPEN AND THE ENGINE IS RUNNING.