GMC SIERRA 1500 Recalls

Dec 17, 2010 – GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CADILLAC ESCALADE EXT, CHEVROLET AVALANCHE, SILVERADO LD AND GMC SIERRA LD VEHICLES. THE REAR AXLE CROSS PINS WERE NOT PROPERLY HEAT TREATED AND COULD FRACTURE AND BECOME DISPLACED WITHIN THE REAR AXLE. SHOULD THE PIN SHIFT OUT OF POSITION, IT COULD CREATE AN INTERFERENCE CONDITION AND CAUSE THE REAR AXLE TO LOCK.

Dec 17, 2007 – CERTAIN FEDERAL-MOGUL REPLACEMENT WHEEL HUB ASSEMBLIES WITH THE BRAND NAMES: NATIONAL, CARQUEST P/NOS. 515020, 515021, 515025, 515053, 515054, 515059, AND 515060, SHIPPED BETWEEN JANUARY 23, 2006, AND DECEMBER 20, 2007, SOLD FOR LIGHT DUTY AND MEDIUM DUTY TRUCKS. THE INBOARD RETENTION NUT USED TO MAINTAIN HUB BEARING ASSEMBLY CAN LOOSEN RESULTING IN AN ABS LIGHT INDICATION, NOISE, AND/OR WHEEL SEPARATION.

Oct 24, 2007 – CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

Jun 06, 2006 – CERTAIN FEDERAL-MOGUL NATIONAL AND CARQUEST AFTERMARKET HUB ASSEMBLIES, P/N 515058, SOLD FOR USE ON 2001-2006 GENERAL MOTORS 1500 AND 2500 4WD TRUCKS. ON THE SUBJECT HUB ASSEMBLIES, THE ABS SENSOR CORD DEPARTS FROM THE HUB ASSEMBLY AT A 90 DEGREE ANGLE. AS A RESULT, THERE IS A FIT ISSUE WITH THE BRAKE ROTOR DUST SHIELD INTERFERING WITH THE ABS SENSOR CORD. IF THE HUB ASSEMBLY IS INSTALLED DESPITE THIS INTERFERENCE, THE GAP BETWEEN THE ABS SENSOR AND THE TONE WHEEL MAY BE ALTERED. THIS MAY WEAKEN THE OUTPUT OF THE ABS SENSOR. DIMINISHED OUTPUT COULD RESULT IN AN UNWANTED ABS ACTIVATION AT LOW SPEEDS AND STOPPING DISTANCE COULD BE AFFECTED.

May 19, 2006 – CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

Nov 26, 2004 – ON CERTAIN VANS EQUIPPED WITH SURE-LOK WHEELCHAIR SECUREMENT SYSTEMS, THE SPROCKET TEETH OF THE RETRACTOR ASSEMBLY IS OUT OF ALIGNMENT.

May 17, 2004 – THE SPARE TIRE AND WHEEL ASSEMBLY THAT WAS PROVIDED ON CERTAIN CONVERSION VEHICLES WILL NOT FIT ON THE FRONT WHEEL HUB DUE TO OFFSET OF THE WHEEL. HOWEVER, IT WILL FIT ON THE REAR WHEELS.

Apr 10, 2001 – VEHICLE DESCRIPTION: CERTAIN 2-WHEEL DRIVE PICKUP TRUCKS FAIL TO COMPLY WITH REQUIREMENTS OF FMVSS NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." THE PROBLEM WAS CAUSED BY A COMPUTER ERROR THAT RESULTED IN THE CERTIFICATION LABEL LISTING TIRE SIZE AND INFLATION PRESSURE INFORMATION THAT DIFFER FROM THE TIRE SIZE AND THE INFLATION PRESSURE INFORMATION FOR THE TIRES ON THE VEHICLE. IF THE VEHICLE OWNER OR SOMEONE SERVICING THE VEHICLE INFLATES THE TIRES ACCORDING TO THE PRESSURE SPECIFIED ON THE LABEL VERSUS THE APPROPRIATE PRESSURE FOR THE TIRES, THE TIRES COULD BE UNDER-INFLATED OR OVER-INFLATED DEPENDING ON THE TIRES MOUNTED ON THE VEHICLE.

Aug 08, 2000 – VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH VACUUM POWER, 4-WHEEL DISC BRAKES. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS." THESE VEHICLES WERE BUILT WITH A KINKED BRAKE BOOSTER VACUUM SUPPLY HOSE.

Apr 27, 2000 – VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES. THESE VEHICLES DO NOT COMPLY WITH THE OCCUPANT PROTECTION REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."