MACK DM Recalls

Mar 22, 1984 – IMPROPER STEERING CLAMP BOLTS AND TORQUE APPLIED DURING INSTALLATION. THE BOLT COULD FAIL, ALLOWING THE STEERING YOKE TO BECOME LOOSE.

Jul 08, 1981 – THE INVOLVED TRUCKS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION", IN THAT THE EXTENDED RIDER"S SEAT WAS NOT EQUIPPED WITH A SEAT BELT AS REQUIRED.

May 31, 1979 – IN THE EVENT OF TURBOCHARGER COMPRESSOR WHEEL FAILURE, ONE OR MORE OF THE FOUR CAPSCREWS THAT HOLD THE TURBOCHARGER TOGETHER MAY BE STRUCK BY PARTS OF THE COMPRESSOR WHEEL, RESULTING IN THE CAPSCREWS BEING DAMAGED. IF THESE CAPSCREWS ARE DAMAGED TO THE POINT THAT THEY ALLOW THE COMPRESSOR BACK PLATE TO DISLOCATE FROM THE TURBOCHARGER BEARING HOUSING, ENGINE LUBRICATING OIL MAY BE ALLOWED TO ESCAPE UNDER PRESSURE, CONTACTING THE ENGINE EXHAUST MANIFOLD SECTIONS OR TURBOCHARGER TURBINE HOUSING.

May 30, 1979 – IN THE INVOLVED TRUCKS IT IS POSSIBLE THE ADJUSTABLE STEERING COLUMN REAR MOUNTING BRACKET COULD FAIL, ALLOWING STEERING WHEEL ASSEMBLY TO FALL DOWN ONTO THE OPERATOR"S LAP.

Apr 03, 1979 – AN IMPROPER PINCH BOLT AND NUT MAY HAVE BEEN USED IN THE CLAMPING OF THE STEERING SHAFT TO THE STEERING GEAR INPUT SHAFT. DUE TO CLAMPING FORCE LOADS APPLIED AT THE BOLT, THE NUT COULD YIELD, RESULTING IN LOOSENESS OF THE INPUT SHAFT YOKE. SHOULD THIS CONDITION GO UNNOTICED, SPLINE WEAR COULD CAUSE SHAFT SEPARATION.

Jan 12, 1979 – A CASTING DEFICIENCY EXISTS IN THE LOWER SECTION OF THE CAPS RESULTING IN A REDUCTION IN THE THICKNESS OF THE MATERIAL. FAILURE OF A CAP CAN ALLOW THE END OF THE REAR SPRING TO DETACH FROM THE AXLE HOUSING.

Oct 03, 1978 – DELAYS OF UP TO ABOUT 2 SECONDS MAY EXIST IN THE BRAKE APPLICATION TIMES TO THE BRAKES ON THE BOGIE AXLES IN THE PRESENCE OF CERTAIN TYPES OF WHEEL SPEED SENSOR SIGNAL DISCONTINUITIES OR DISTORTIONS THAT MAY OCCUR AS A RESULT OF SENSOR WIRE FAILURE. THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS".

Aug 08, 1978 – THE EXISTING CROSS STEERING ARMS MAY HAVE INSUFFICIENT FATIGUE LIFE IN THE NECK AREA. THIS IS NEAR THE BOSS FOR THE CROSS STEERING TUBE BALL JOINT CONNECTION. FAILURE OF EITHER OF THE CROSS STEERING LEVERS COULD LEAD TO LOSS OF STEERING CONTROL OF THE RIGHT FRONT WHEEL.

Apr 04, 1978 – AN AXLE "NO BRAKE" CONDITION COULD RESULT FROM AN EATON CONTROLLER INTERNAL ELECTRICAL MALFUNCTION. THIS CONDITION MAY CAUSE THE ANTI-WHEEL LOCK VALVE SOLENOID TO BE CONTINUOUSLY ENERGIZED AND PREVENT THE BRAKES FROM BEING APPLIED ON ONE OF THE AXLES. AS A RESULT, THE ANTI-WHEEL LOCK WARNING LAMP IS NOT ACTIVATED.

Feb 09, 1978 – THE SYNFLEX-TYPE OIL PRESSURE SIGNAL LINE MAY HAVE BEEN ROUTED TOO CLOSE TO THE EXHAUST MANIFOLD. EXCESSIVE HEAT MAY CAUSE THE LINE TO RUPTURE, AND OIL LEAKAGE MAY OCCUR.