OLDSMOBILE OMEGA Recalls

Mar 24, 1981 – THE ENGINE-TO-BODY GROUND CABLE ON CERTAIN VEHICLES MAY HAVE BEEN DAMAGED DURING MANUFACTURE. THE CABLE COULD EVENTUALLY BREAK DUE TO THE RELATIVE MOTION BETWEEN THE ENGINE AND BODY DURING VEHICLE OPERATION.

Oct 08, 1980 – THE INVOLVED VEHICLES MAY HAVE BEEN ASSEMBLED WITH THE POWER STEERING HOSE INCORRECTLY ROUTED. THE POWER STEERING HOSE MAY THEN CONTACT THE EXHAUST MANIFOLD, RESULTING IN DETERIORATION AND EVENTUAL FAILURE OF THE HOSE AND LEAKAGE OF POWER STEERING FLUID ONTO THE EXHAUST MANIFOLD.

Oct 17, 1979 – THE STEERING GEAR MOUNTING PLATE ON THE INVOLVED VEHICLES MAY DEVELOP FATIGUE CRACKS AT HIGH MILEAGE WHICH WOULD ALLOW THE STEERING GEAR ATTACHMENT TO BECOME LOOSE. IF THIS CONDITION EXISTS, THE DRIVER MAY NOTICE CONSIDERABLE "FREE PLAY" IN THE STEERING WHEEL.

Sep 25, 1979 – THE AUTOMATIC COOLER LINE HOSES ON SOME OF THE SUSPECT VEHICLES MAY CONTAIN MATERIAL VOIDS, WHICH COMBINED WITH A HIGH THERMAL EXPANSION AT ELEVATED TEMPERATURES, COULD RESULT IN HOSE FAILURE AND TRANSMISSION FLUID LEAKAGE.

Apr 17, 1979 – THE FRONT SUSPENSION COIL SPRING MAY HAVE A LARGER THAN DESIRED INSIDE DIAMETER OF THE LOWER COIL WHERE IT RESTS ON THE SPRING SEAT. THIS COULD ALLOW THE SPRING TO BE FORCED OVER THE LOWER SPRING SEAT DUE TO SUSPENSION FORCES.

Apr 05, 1979 – THERE IS A POTENTIAL FOR INTERFERENCE BETWEEN THE CLUTCH CONTROL CABLE AND BRAKE PIPE IN THE MASTER CYLINDER. THIS CAN RESULT IN RUBBING CONTACT WHEN THE CLUTCH PEDAL IS OPERATED. ALSO, THE BRAKE PIPE CLEARANCE TO THE TRANSMISSION CASE MAY BE INADEQUATE. IF THIS CONDITION EXISTS, IT COULD EVENTUALLY RESULT IN A FAILURE IN THE BRAKE PIPE, CAUSING LOSS OF BRAKE FLUID AND PARTIAL LOSS OF BRAKING ACTION.

Apr 05, 1979 – FUEL HOSES MAY BE INCORRECTLY POSITIONED AND CONTACT THE RIGHT FRONT DRIVE AXLE BOOT DURING VEHICLE OPERATION. AFTER A PERIOD OF TIME, THE ROTATING BOOT COULD WEAR A HOLE IN THE FUEL HOSE, RESULTING IN FULE LEAKAGE.

Mar 22, 1979 – VEHICLES DO NOT COMPLY TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "ANCHORAGE OF SEATS". THE LOCK BAR IN THE FRONT SEAT ADJUSTER ASSEMBLIES MAY NOT ENGAGE PROPERLY AND THE ABILITY OF THE SEAT ADJUSTER TO MAINTAIN THE SEAT IN A LATCHED POSITION DURING AN ACCIDENT MAY BE REDUCED.

Jun 13, 1978 – THE HUB PORTION OF THE FAN BLADE ASSEMBLY COULD CRACK DUE TO HIGH STRESS LEVELS GENERATED DURING ENGINE OPERATING CONDITIONS. EVENTUALLY, THE BLADE COULD BREAK APART AT THE HUB AND BLADE PIECES COULD BE PROPELLED INTO THE ENGINE. IF THE HOOD IS OPEN WHILE THE ENGINE IS RUNNING, THE FRAGMENTS WOULD BE FREE TO FLY FROM THE VEHICLE.

Sep 27, 1977 – THE REAR AXLE SHAFTS ON THE INVOLVED VEHICLES MAY HAVE A FLAW IN THE METAL. AS A RESULT, THE SHAFT MAY BREAK, WHICH WOULD ALLOW THE TIRE AND WHEEL ASSEMBLY TO SEPARATE FROM THE VEHICLE.