PONTIAC PHOENIX Recalls

Oct 24, 2007 – CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

May 19, 2006 – CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

Mar 29, 1985 – THE FUEL SYSTEM MAY LEAK AT THE THROTTLE BODY INJECTION FUEL FEED PIPE CONNECTION. CONSEQUENCE OF DEFECT: THIS LEAKAGE COULD RESULT IN AN UNDERHOOD FIRE WHICH COULD SPREAD TO THE PASSENGER COMPARTMENT AND CAUSE BURN INJURIES TO OCCUPANTS.

Feb 06, 1984 – SOME VEHICLES HAVE BUCKET SEAT BACK LOCKS THAT DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, ANCHORAGE OF SEATS. IN EVENT OF A CRASH, THE SEAT BACK LOCK MAY NOT FUNCTION.

Oct 13, 1983 – THE BRAKE PROPORTIONER VALVES MAY BREAK AND SEPARATE FROM THE MASTER CYLINDER. THIS WOULD ALLOW BRAKE FLUID TO LEAK AND WOULD RESULT IN A PARTIAL LOSS OF THE BRAKE SYSTEM.

Feb 24, 1983 – UNDER CERTAIN CONDITIONS, VEHICLES MAY EXPERIENCE PREMATURE REAR WHEEL SKID DURING BRAKING. REAR WHEEL SKIDDING IS MOST LIKELY TO OCCUR ON A WET OR SLICK SURFACE.

Jan 01, 1983 – REAR BRAKE HOSES MAY HAVE BEEN MANUFACTURED INCORRECTLY WHEN THE METAL END FITTINGS WERE INSTALLED. SOME REAR BRAKE HOSES MAY SEPARATE FROM THE METAL END FITTINGS WHEN SUBJECTED TO THE PULLING FORCE SPECIFIED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD 106, "BRAKE HOSES".

Mar 08, 1982 – UNDER CERTAAIN CONDITIONS, THE HOSE CLAMPS ON THE FUEL TANK FILLER PIPE AND FUEL TANK FILLER VENT PIPE COULD FRACTURE. THE FRACTURE OF THESE CLAMPS COULD CAUSE FUEL LEAKAGE AT ANY OF THE FOUR PIPE TO HOSE CONNECTIONS. LEAKAGE CAN OCCUR DURING REFUELING, OR WHILE DRIVING, IF THE FUEL TANK IS ABOVE 3/4 FULL.

Mar 02, 1982 – THE CLUTCH CABLE MAY RUB AGAINST THE MASTER CYLINDER BRAKE PIPE WHEN THE CLUTCH PEDAL IS OPERATED. CONTINUED OPERATION OF THE VEHICLE MAY RESULT IN WEAR THROUGH OF THE INSULATION ON THE CLUTCH CABLE. THE RESULTING METAL ON METAL CONTACT COULD LEAD TO FAILURE OF THE BRAKE PIPE, LOSS OF BRAKE FLUID, AND PARTIAL LOSS OF BRAKE ACTION.

Aug 10, 1981 – UNDER CERTAIN CONDITIONS, THE REAR BRAKES COULD LOCK UP WITHOUT PRIOR WARNING DURING HIGH DECELERATION BRAKING. THE PROBLEM MAY BE CAUSED BY DEFECTIVE PROPORTIONER VALVES IN THE BRAKING SYSTEM.