VOLKSWAGEN JETTA Recalls

Sep 12, 2002 – CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEMS." CHILD SEAT ANCHORAGES INSTALLED IN THE VEHICLE'S REAR SEATS MUST BE IDENTIFIED BY MARKINGS, AND THEIR LOCATION AND USE BE DESCRIBED IN THE OWNER'S MANUAL.

Jan 31, 2002 – ON SOME PASSENGER VEHICLES, SHORT CIRCUITS CAN OCCUR WITHIN THE ELECTRONIC CONTROL UNIT OF THE ANTI-LOCK BRAKING SYSTEM (ABS).

Jan 25, 2002 – ON SOME PASSENGER VEHICLES, THE FUEL TANK FILLER NECK CAN SUFFER ABRASION DAMAGE IF THE REAR TIRE GOES FLAT AND THE VEHICLE IS DRIVEN UNTIL THE TIRE DISINTEGRATES.

Sep 17, 1999 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. SOME OF THESE VEHICLES DO NOT COMPLY WITH THE HEAD INJURY CRITERION REQUIREMENTS OF FMVSS NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." THE UPPER RETAINER CLIP NEAR THE BP1 IMPACT LOCATION IS DESIGNED TO BREAK WHEN IMPACTED BY THE HEAD FORM. IN SOME CASES, THE MATERIAL OF THE TRIM PART MAY BE MORE IMPACT RESISTANT AS A RESULT OF VARIATIONS IN THE MOLDING PROCESS.

Feb 05, 1999 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE SOUND ABSORBING MAT ATTACHED TO THE INSIDE OF THE B-PILLAR SIDE TRIM PANEL COULD HAVE BEEN IMPROPERLY INSTALLED. SURFACE AND EDGES OF THE MAT COULD HAVE BEEN DAMAGED DURING THE ASSEMBLY PROCESS. IT COULD IGNITE WHEN EXPOSED TO THE EXHAUST GAS OF THE SEAT BELT PRE-TENSIONER IGNITER IN THE EVENT OF A SEVERE FRONT OR SIDE COLLISION.

Aug 17, 1998 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK.

Jul 16, 1998 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH.

Jul 08, 1996 – THE SHEET METAL PANELS OF BOTH REAR DOORS HAVE OPENINGS FOR THE ROUTING OF THE ELECTRICAL WINDOW REGULATOR WIRING. THE PANEL OPENINGS HAVE SHARP EDGES THAT CAN DAMAGE THE INSULATION OF THE WIRING HARNESS.

Sep 20, 1995 – IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.

Aug 18, 1995 – WHEN INSTALLED IN THE VEHICLES, A TIE WRAP IS USED TO GUIDE THE CRUISE CONTROL CABLE IN THE ENGINE COMPARTMENT. SOME TIE WRAPS HAVE BEEN INSTALLED WITH A LARGE LOOP OPENING IMPROPERLY GUIDING THE CABLE WHICH COULD PREVENT THE THROTTLE FROM RETURNING TO ITS FULL IDLE POSITION.