FREIGHTLINER Recalls

Dec 28, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH CATERPILLAR EPA07 C155 ENGINES, THE EXTENSION PIPES ATTACHED TO THE AFTERTREATMENT REGENERATION DEVICE MAY DEVELOP A CRACK OR HOLE AND HEAT OR FLAME MAY ESCAPE DURING A REGENERATION OF THE DIESEL PARTICULATE FILTER.

Dec 21, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH TRW STEERING GEARS, MODELS TAS85 AND RCS85, THESE STEERING GEARS CONTAIN POTENTIALLY DEFECTIVE SECTOR SHAFTS WITH AN INCORRECT GEAR TOOTH WHICH MAY INTERFERE WITH THE RACK-PISTON TEETH, RESULTING IN A STICK OR BIND CONDITION.

Dec 21, 2007 – ON CERTAIN UTILITY VANS, THE CRANKSHAFT SENSOR IN CERTAIN DIESEL ENGINES COULD FAIL DUE TO SEPARATION OF BOND WIRES FROM THE LEAD FRAME IN THE SENSOR. THIS RESULTS IN AN INTERRUPTION IN THE ELECTRICAL CONNECTION IN THE CHIP HOUSING OF THE SENSOR.

Dec 10, 2007 – ON CERTAIN MOTOR HOME CHASSIS BUILT USING INLINE POWER STEERING FILTERS, PART NO. 14-16829-000, THE FILTER CAN PLUG DUE TO FAILURE OF THE SCREEN ADHESION TO THE FILTER HOUSING CAUSING A RISE IN RETURN LINE PRESSURE. THIS CAN LEAD TO HOSE SEPARATION FROM THE FILTER OR STEERING GEAR FITTING RESULTING IN A SUDDEN LOSS OF STEERING FLUID AND POWER ASSIST.

Nov 13, 2007 – ON CERTAIN TRUCK-TRACTORS EQUIPPED WITH HOLLAND SIMPLEX SE OR SE II FIFTH WHEELS, THE LATCH LEVER PIVOT BOLT ASSEMBLY MAY HAVE BEEN OVER-TIGHTENED WHICH COULD DISTORT THE PIVOT BOLT SPACER SLEEVE. CORROSION OR CONTAMINATES IN THE PIVOT MAY CAUSE IT TO BIND AND PREVENT THE FIFTH WHEEL JAW FROM LATCHING SECURELY AROUND THE TRAILER KING PIN.

Nov 13, 2007 – ON CERTAIN TRUCKS, THE WIPER MOTOR GROUND WIRE WAS OMITTED IN A NEW HARNESS DESIGN. THE WIPER MOTOR MAY NOT OPERATE OR MAY FUNCTION INTERMITTENTLY.

Sep 06, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH RACK AND PINION STEERING, THE BALL SOCKET ASSEMBLY AT THE INNER END OF THE DRIVER SIDE TIE ROD MAY BE DAMAGED IN A SHARP TURN. EXCESSIVE TIE ROD ANGLES MAY LOOSEN THE TIE ROD IN THE BALL SOCKET OR DAMAGE THE THREADED TIE ROD SOCKET ATTACHMENT TO THE STEERING RACK ON THE DRIVER SIDE. THE THREADED END OF THE BALL SOCKET ASSEMBLY MAY FRACTURE AND SEPARATE.

Sep 05, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH RACK AND PINION STEERING, THE TIE ROD ARMS MAY HAVE BEEN INCORRECTLY INSTALLED. THE THREADED END OF THE BALL SOCKET ASSEMBLY MAY FRACTURE AND SEPARATE.

Aug 30, 2007 – ON CERTAIN SCHOOL BUS AND MOTOR HOME CHASSIS, IMPROPER PINCH BOLT INSTALLATION MAY RESULT IN DECOUPLING OF THE STEERING SHAFT AND A LOSS OF STEERING.

Aug 13, 2007 – ON CERTAIN TRUCKS BUILT WITH A TRW GLOBAL ADJUSTABLE UPPER STEERING COLUMN, TWO UPPER TILT PLATE BOLTS MAY LOOSEN WITH USE AND FALL OUT. THESE FASTENERS HOLD THE UPPER COLUMN ASSEMBLY IN PLACE. THE STEERING COLUMN PIVOT MAY FRACTURE IF THE BOLTS ARE MISSING WHEN AN EXCESSIVE FORCE IS APPLIED TO THE STEERING WHEEL.