Chrysler is recalling certain model year 2009-2010, Ram 1500 and Dodge Dakota trucks

Oct 02, 2012 — Recall Campaign #12V474000

Chrysler is recalling certain model year 2009-2010, Ram 1500 and Dodge Dakota trucks, manufactured from July 1, 2009, through November 30, 2009, because the rear axle pinion nut may loosen due to a lack of adhesive.

The recall was influenced by the Office of Defects Investigation with about 44,300 units affected.

See recall notice

NHTSA Safety Recall Notice

12V474000

Manufacturer:	Chrysler (FCA US, LLC)
Recall date:	October 02, 2012
NHTSA Campaign #:	12V474000
Units affected:	44,300

Description:: Chrysler is recalling certain model year 2009-2010, Ram 1500 and Dodge Dakota trucks, manufactured from July 1, 2009, through November 30, 2009, because the rear axle pinion nut may loosen due to a lack of adhesive.
Consequeces:: If the rear axle pinion nut loosens, the axle can lock up and cause a loss of vehicle control and/or a vehicle crash with little warning.
Corrective action:: Chrysler will notify owners, and dealers will install a pinion nut retainer, free of charge. The recall began on June 17, 2013. Owners may contact Chrysler at 1-800-247-9753.
Notes:: Chrysler's recall campaign number is M34. Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Affects the following:

2010 DODGE DAKOTA Complaints
Vehicle Has Experienced all Dash waring lights & noises going on and off while driving Threw multiple codes saying the PCM was not connecting with the ODB2 reader , Vehicle would not crank or start 2 times did a Hard reset and it started, the end result is all Dash Lights luminated when Key is on , No crank & No communication with the PCM, No Code visible any more I replaced the PCM same issue Now the TIPM which I believe Blew my PCM also at 141,000 miles! Very Dangerous!! A well maintained vehicle should never have Computer Problems at 140,000 , FYI I am a state Licensed auto Mechanic. this Vehicle also had a fuel pump problem 12/21/2011 and was serviced at the dealership , I believe this truck was a "lemon" from that point on. Also, No vehicles should have mother Board computer's managing every system of the vehicle! Dangerous! The Manufactures are Scamming the Consumer. BCM, TCM, PCM ,ECS ,TIPM Are all Scam Engineering By the auto industry, EFI vehicle's only need 1 Computer for the ignition A ECU that's it , the rest of those systems are a Violation of wright to Repair and NHTSA Safety standards. [XXX] the lower Bolt mounting the PCM was so Corroded it broke off in the original PCM on removal. This Vehicle is a lemon . INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6);
2010 DODGE RAM 1500 Complaints
The contact owns a 2010 Dodge Ram 1500. The contact stated while driving at an undisclosed speed, the driveshaft detached. No warning lights were illuminated. The contact received notification for NHTSA Campaign Number: 13V038000 (Power Train) however, the part to complete the recall repair was not yet available. The vehicle was towed to a dealer, where it was diagnosed that the rear axle pinion nut needed to be replaced. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 262,420. ;