Ford Motor Company is recalling certain model year 2015 Ford F-150 trucks manufactured March 19

May 12, 2015 — Recall Campaign #15V279000

Ford Motor Company (Ford) is recalling certain model year 2015 Ford F-150 trucks manufactured March 19, 2015, to March 30, 2015. The affected vehicles may have been built with a steering upper intermediate shaft that was improperly riveted.

The recall was influenced by the manufacturer with about 8,963 units affected.

See recall notice

NHTSA Safety Recall Notice

15V279000

Manufacturer:	Ford Motor Company
Recall date:	May 12, 2015
NHTSA Campaign #:	15V279000
Units affected:	8,963

Description:: Ford Motor Company (Ford) is recalling certain model year 2015 Ford F-150 trucks manufactured March 19, 2015, to March 30, 2015. The affected vehicles may have been built with a steering upper intermediate shaft that was improperly riveted.
Consequeces:: If the intermediate shaft was improperly riveted, it could separate from the intermediate shaft flex coupling, resulting in a loss of steering control and increasing the risk of a vehicle crash.
Corrective action:: Ford will notify owners, and dealers will inspect the intermediate shaft and replace it, as necessary, free of charge. The recall began on May 22, 2015. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 15S17.
Notes:: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Affects the following:

2015 FORD F-150

2015 FORD F-150 Complaints
This is a supplemental complaint to my earlier report regarding NHTSA Campaign 26V237 / Ford Safety Recall 26S28. The recall remedy (PCM software update) was performed at W.C. Sanderson Ford in Healdsburg, CA on XXX. The original downshift defect recurred within weeks, including a near-miss where I nearly lost control of the vehicle with my [XXX] son inside. Since then, I have had the vehicle independently scanned twice, including a full all-systems diagnostic scan. The scan shows a communication fault (U0401, "Invalid Data Received From PCM") present across five separate control modules: ABS, Airbag/Occupant Classification System, Power Steering Control Module, Tire Pressure Monitoring/Body Control, and the engine module. The scan's own assessment recommends repairing CAN-BUS wiring and connections. I believe this network-wide wiring fault may be the actual underlying cause of the condition recall 26S28 was intended to fix — the recall's software update assumes a signal-loss problem can be resolved in software, but if the root cause is physical wiring, the remedy would not correct it. This would explain why the defect recurred so soon after the software update was installed. A second code, P2112 (Throttle Actuator Stuck Closed), also appeared spontaneously while the vehicle was parked. This code is documented in Ford's own Technical Service Bulletin 16-0139 (issued 2018), indicating Ford had prior knowledge of related fault patterns on this vehicle range. Of particular concern, the Airbag/Occupant Classification System is affected by the same communication fault. This system governs airbag deployment behavior based on occupant detection, and my son rides in this vehicle regularly. The vehicle is currently not safe to drive. I am requesting NHTSA evaluate whether the 26S28 remedy adequately addresses the underlying defect, given evidence that a wiring-level fault — not solely a software issue — may be the true root cause. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B);