General Motors LLC is recalling certain model year 2016 Chevrolet Traverse

Dec 11, 2015 — Recall Campaign #15V833000

General Motors LLC (GM) is recalling certain model year 2016 Chevrolet Traverse, GMC Acadia, and Buick Enclave vehicles manufactured November 6, 2015, to November 12, 2015. The affected vehicles have a the third row left lower seat frame that may have welds that are not in the correction location.

The recall was influenced by the manufacturer with about 2,633 units affected.

See recall notice

NHTSA Safety Recall Notice

15V833000

Manufacturer:	General Motors, LLC
Recall date:	December 11, 2015
NHTSA Campaign #:	15V833000
Units affected:	2,633

Description:: General Motors LLC (GM) is recalling certain model year 2016 Chevrolet Traverse, GMC Acadia, and Buick Enclave vehicles manufactured November 6, 2015, to November 12, 2015. The affected vehicles have a the third row left lower seat frame that may have welds that are not in the correction location.
Consequeces:: If the seat frame is not welded in the correct places, the seat may not perform as intended, and in the event of a crash, the seat occupant could be at an increased risk of injury.
Corrective action:: GM will notify owners, and dealers will inspect the third row left side lower seat frame, replacing it as necessary, free of charge. The recall began on January 29, 2016. Owners may contact Chevrolet customer service at 1-800-222-1020, GMC customer service at 1-800-462-8782 or Buick customer service at 1-800-521-7300. GM's number for this recall is 21930.
Notes:: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Affects the following:

2016 BUICK ENCLAVE Complaints
I purchased this used 2016 Buick Enclave in July 2026. Shortly after purchase, the vehicle began repeatedly jerking and hesitating while driving. During occurrences, Traction Control/StabiliTrak warnings appeared and the vehicle experienced loss of power and difficulty accelerating normally. I reported the jerking/drivability problem to the selling dealer. On July 27, 2026, the selling dealer attempted a repair after I reported the jerking/drivability problem. Within approximately five minutes of leaving the dealership, the vehicle began jerking again. I then took the vehicle to an auto-parts store, where an OBD-II scan produced multiple diagnostic trouble codes, including P0300 engine misfire and several MAP-sensor-related codes. I have photographs documenting the scan results. The vehicle became disabled shortly thereafter and required towing. It was subsequently evaluated by an independent repair facility, where the MAP sensor was replaced. The vehicle later again experienced the jerking/loss-of-power condition and StabiliTrak/Traction Control warnings. On August 10, the vehicle became disabled again. These incidents have occurred while driving in traffic. When the condition occurs, I cannot reliably accelerate or maintain normal vehicle operation, creating a safety concern because I may be unable to move safely with surrounding traffic. The specific cause is UNKNOWN. The vehicle has been evaluated by the selling dealer and an independent repair facility and is being taken to an authorized Buick dealership for further diagnosis. The vehicle is available for inspection.;
2016 CHEVROLET TRAVERSE Complaints
The contact owns a 2016 Chevrolet Traverse. The contact received notification of NHTSA Campaign Number: 23V334000 (Air Bags). The contact stated that four local dealers were contacted. The contact was informed that parts were on back order. The manufacturer was not contacted. The contact had not experienced a failure associated with the unrepaired recall repair.;
2016 GMC ACADIA Complaints
Technician told me the engine "grenaded itself". "Cylinder #4 melted into the side walls of the cylinder wall caused by air to fuel mix ratio controlled by the ECU failure to mix appropriately." My family and I were traveling for Easter and were stranded on the side of the highway. I had a private repair shop (Greenville Auto Clinic LLC) confirm as well as the local dealership Greenville Chevy. The vehicle required an engine replacement. I did contact GMC's Zone Manager out of Atlanta, GA for assistance, he reduced the bill from over $10,000 down to $6098. There was no error messaging, only an engine that would not respond to the accelerator pedal. The engine would try to accelerate, but struggled to the point it would die when I applied too much pressure on the gas pedal.;