Chrysler is recalling certain 2018 Jeep Cherokee all-wheel-drive vehicles

Jul 26, 2018 — Recall Campaign #18V494000

Chrysler (FCA US LLC) is recalling certain 2018 Jeep Cherokee all-wheel-drive vehicles. The bearing cage for the right front halfshaft assembly may not have been properly heat treated, possibly resulting in the bearing cage breaking and a potential halfshaft assembly failure.

The recall was influenced by the manufacturer with about 702 units affected.

See recall notice

NHTSA Safety Recall Notice

18V494000

Manufacturer:	Chrysler (FCA US, LLC)
Recall date:	July 26, 2018
NHTSA Campaign #:	18V494000
Units affected:	702

Description:: Chrysler (FCA US LLC) is recalling certain 2018 Jeep Cherokee all-wheel-drive vehicles. The bearing cage for the right front halfshaft assembly may not have been properly heat treated, possibly resulting in the bearing cage breaking and a potential halfshaft assembly failure.
Consequeces:: If the halfshaft bearing cage breaks, the halfshaft may not be able to transmit engine power, causing a loss of drive or it can allow the vehicle to move while in the "Park" position. Either condition may increase the risk of a crash.
Corrective action:: Chrysler will notify owners, and dealers will replace the front right halfshaft assemblies, free of charge. The recall began September 20, 2018. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is U78.
Notes:: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Affects the following:

2018 JEEP CHEROKEE

2018 JEEP CHEROKEE Complaints
My 2018 Jeep Cherokee Trailhawk is subject to FCA Recall 01C/NHTSA 25V-011 for two-speed PTU failure. I have experienced 3 serious drivetrain events requiring towing. In April 2024, before the recall was announced, the vehicle suddenly lost acceleration while entering an interstate/on-ramp, with loud grinding/revving and jerking. An independent repair facility replaced the transmission. On May 18, 2026, another drivetrain failure occurred. An authorized Jeep dealer confirmed PTU failure and performed Recall 01C. Dealer records state the PTU had “MAJOR INTERNAL DAMAGE” and document damage at the PTU/transmission interface, including a transmission-side stub shaft and damage/scored gears attributed to the old PTU gear. The vehicle remained at the dealer until approximately August 7. About 2 weeks later, the Service 4WD warning appeared, followed by loud drivetrain noise, jerking and severe loss of propulsion. The vehicle also rolled backward while in PARK unless the parking brake was applied and required another tow. The dealer diagnosed a failed left-front CV axle/halfshaft and attributes it to progressive wear, unrelated to the PTU repair. I am not claiming the PTU caused the axle failure; I am asking NHTSA to evaluate the timing and repeated loss-of-propulsion/PARK events. Additionally, the dealer performed a multipoint inspection about one week before the axle failure that marked the CV drive axle category as passing. As of Sept. 2, 2026, BOTH NHTSA and FCA/Mopar systems still listed Recall 01C as incomplete/unrepaired despite the dealer having performed the recall repair. I request review of these repeated safety failures, the recall remedy, and the continued incomplete recall status.;