Daimler Trucks North America LLC is recalling certain 2018-2019 Freightliner Cascadia vehicles

Feb 27, 2019 — Recall Campaign #19V136000

Daimler Trucks North America LLC (DTNA) is recalling certain 2018-2019 Freightliner Cascadia vehicles. In the affected vehicles, the Anti-Lock Braking system (ABS) malfunction warning light may not reactivate after the ignition has been turned off and then switched back on. As such, the vehicles fail to comply with Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems."

The recall was influenced by the manufacturer with about 14 units affected.

See recall notice

NHTSA Safety Recall Notice

19V136000

Manufacturer:	Daimler Trucks North America, LLC
Recall date:	February 27, 2019
NHTSA Campaign #:	19V136000
Units affected:	14

Description:: Daimler Trucks North America LLC (DTNA) is recalling certain 2018-2019 Freightliner Cascadia vehicles. In the affected vehicles, the Anti-Lock Braking system (ABS) malfunction warning light may not reactivate after the ignition has been turned off and then switched back on. As such, the vehicles fail to comply with Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems."
Consequeces:: Unknowingly operating a truck with an ABS malfunction may increase the risk of a crash.
Corrective action:: DTNA will notify owners, and dealers will reprogram the ABS module, free of charge. The recall began April 26, 2019. Owners may contact DTNA customer service at 1-800-547-0712. The DTNA number for this recall is FL-810.
Notes:: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Affects the following:

2018-2019 FREIGHTLINER CASCADIA

2019 FREIGHTLINER CASCADIA Complaints
I am writing to bring to your attention a potentially dangerous situation caused by what I believe to be a manufacturer design flaw with the SS 1034797 M2, 108SD, 114SD Coolant Level Sensor P/N 06-93316-002. On [XXX], one of our trucks (VIN: [XXX]) experienced a low coolant warning and an automatic engine shutdown while traveling on the interstate in a construction zone. As you can imagine, the sudden stoppage of a tractor-trailer in the traffic lanes of a freeway presents an extremely hazardous situation, not only for our driver but for all motorists in the vicinity. For us as a motor carrier, this is compounded by the likelihood of legal liability resulting from any collision involving a stationary truck in such conditions. The root cause of this incident appears to be the failure of the magnet within the surge tank to maintain its buoyancy. When the magnet sinks to the bottom of the tank, it signals the engine control module (ECM) that the coolant level is critically low, triggering an engine shutdown. While I understand the intent is to protect the engine from potential damage, this design flaw creates an unacceptably dangerous scenario—especially since, in many cases, the engine is not actually at risk of damage. In this instance, I instructed the driver to unplug and after a 15-minute period, he restarted the truck and drove to a nearby truck stop. Remarkably, the truck remains operational without the sensor repair, further underscoring the superficial nature of this issue. Unfortunately, this is not an isolated incident. We have encountered similar sensor failures across our fleet, but this particular event was the most severe. While I am not an engineer, it seems logical that the coolant level sensor should be paired with a high-temperature reading before an engine shutdown is initiated. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6);