Hyundai Motor America is recalling certain 2025-2026 IONIQ 5 and 2026 IONIQ 9 vehicles

Feb 05, 2026 — Recall Campaign #26V068000

Hyundai Motor America (Hyundai) is recalling certain 2025-2026 IONIQ 5 and 2026 IONIQ 9 vehicles. The high voltage battery system may contain an improperly tightened bus bar, which can cause a short-circuit.

The recall was influenced by the manufacturer with about 27 units affected.

See recall notice

NHTSA Safety Recall Notice

26V068000

Manufacturer:	Hyundai Motor America
Recall date:	February 05, 2026
NHTSA Campaign #:	26V068000
Units affected:	27

Description:: Hyundai Motor America (Hyundai) is recalling certain 2025-2026 IONIQ 5 and 2026 IONIQ 9 vehicles. The high voltage battery system may contain an improperly tightened bus bar, which can cause a short-circuit.
Consequeces:: An electrical short in the high voltage battery system increases the risk of a fire.
Corrective action:: Dealers will inspect and tighten the bus bar retention bolts and replace the battery system assembly, as necessary, free of charge. Owner notification letters were mailed April 3, 2026. Owners may contact Hyundai customer service at 1-855-371-9460. Hyundai's number for this recall is 294. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on February 7, 2026.

Affects the following:

2026 HYUNDAI IONIQ 5 Complaints
I am reporting a suspected safety defect involving inconsistent deceleration behavior in my 2026 Hyundai IONIQ 5. I regularly use Hyundai’s i-PEDAL one-pedal-driving mode. In this mode, releasing the accelerator produces strong regenerative deceleration and can bring the vehicle to a stop. However, the vehicle does not retain this selected driving behavior after it is turned off and restarted. It reverts to a mode requiring substantially more use of the brake pedal. The behavior also changes in connection with shifting into reverse. In a Costco parking lot in [XXX], I stopped near the customer pickup area while using i-PEDAL. I briefly turned off the vehicle while a passenger loaded groceries. When I restarted and began moving, I expected the strong accelerator-release deceleration the vehicle had provided immediately before shutdown. Instead, the vehicle continued moving because i-PEDAL had been reset. A crosswalk ahead contained pedestrians, and I had to apply the brake pedal to avoid striking them. No collision or injury occurred, but this was a serious near-miss. The concern is not simply that the vehicle offers different regenerative-braking settings. The safety concern is that a driver-selected setting that materially affects accelerator-release deceleration changes automatically after a brief shutdown or simply backing up. A driver who has adapted to i-PEDAL may reasonably expect the vehicle to decelerate as it did moments earlier. The regeneration level should be set and remain as the driver prefers, not reset on each start or backup of the vehicle. I request that NHTSA evaluate whether this inconsistent default behavior creates an unreasonable risk of unintended vehicle movement or pedestrian collisions and whether the vehicle should retain the selected mode or provide a prominent warning requiring driver acknowledgment whenever the deceleration behavior changes. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6);
2026 HYUNDAI IONIQ 9 Complaints
When reaching speeds of approximately 55 to 60 mph, the car would begin to shake and the steering wheel would excessively begin shaking. You did not feel like you had great control of the car. The front two tires required replacing due to the foam being detached/mangled within the tires. The dealership put the new tires onto the back of the car and rotated the original back tires to the front of the car as part of the repair/replacement.;