ALTEC AT200A Recalls

Dec 20, 2024 – Altec Industries, Inc. (Altec) is recalling certain 2017-2024 Ford E350 van chassis equipped with a AT200A devices. The units mounted on certain Ford E350 van chassis with Gross Axle Weight Rating (GAWR) of 4050 and 4200 pounds, may fail at high loads due to a defect in the front axle.

Jun 30, 2022 – Altec Industries Inc. (Altec) is recalling certain 2016-2022 van mounted AT200A and AT30G vehicles. The ground-fault circuit interrupter (GFCI) outlet may not provide adequate circuit protection against an electrical overload condition.

Mar 30, 2020 – Altec Industries Inc. (Altec) is recalling certain 2016-2018 AT200A vehicles built on Ford E-350 Cutaway chassis. The rear tire size and load rating may be incorrect, possibly resulting in the vehicle being overloaded.

Sep 26, 2013 – Altec Industries, Inc. (Altec) is recalling certain model year 2010-2013 AT200A, AT235, AT235P, AT30-G, AT35-G, AT37-G, AT40-G and AT237 Aerial Devices mounted on Ford Super Duty Chassis' equipped with 6.8L gas engines and Muncie FR67 power take offs (PTO). In the affected vehicles, oil may leak from the PTO pressure switch onto a thermal blanket covering the exhaust.

May 29, 2013 – Altec Industries, Inc. is recalling certain model year 2010-2012 AT200A, AT235/235P, AT237, AT248F, AT35/37-G, and AT40-G aerial devices built on Ford F550 chassis with a gross vehicle weight rating of 19,500lbs. The battery cable going to the unit auxiliary functions could be damaged and possibly short to ground.

Aug 08, 2012 – Altec Industries, Inc. is recalling certain model year 2012 Aerial Device vehicles built on a Navistar Terrastar chassis because the Altec-installed torsion bar increases the ride height of the front suspension, which when the vehicle hits bumps, may cause the vehicle to alter its steering direction.

Mar 28, 2011 – ALTEC IS RECALLING CERTAIN AT35-G, AT37-G, AT235, AND AT237 AERIAL DEVICES MANUFACTURED FROM JANUARY 2005 THROUGH OCTOBER 2008. THESE UNITS ARE EQUIPPED WITH BILLET STEEL COUNTERWEIGHT THAT IS WELDED IN PLACE. IN THE EVENT OF WELD FAILURE, THE COUNTERWEIGHT MAY FALL OUT WHILE TRAVELLING.

Sep 02, 2010 – ALTEC IS RECALLING CERTAIN MODEL YEAR 2006-2007 AT200A, AT235, MODEL YEAR 2007-2010 AT235P AND MODEL YEAR 2008 AT3XG TRUCKS BUILT ON GM CHASSIS. THERE IS A POTENTIAL HYDRAULIC HOSE ROUTING CONDITION IN THE ENGINE COMPARTMENT. THE HOSE COULD CONTACT AND CAUSE SOME ABRASIONS TO AN OEM 12V CHASSIS WIRE OR POSSIBLY RUB ON THE STEEL POWER STEERING LINE WHICH MAY LEAD TO POSSIBLE DAMAGE OF THE HYDRAULIC LINE.