BMW X5 Recalls

Apr 11, 2008 – BMW IS RECALLING 55 MY 2008 X5 SPORT UTILITY VEHICLES FOR PROBLEMS WITH THE REAR AXLE STABILIZER (ANTI-SWAY BAR). THESE VEHICLES WERE EQUIPPED WITH A SPORTS-SUSPENSION STABILIZER RATHER THAN A STANDARD SUSPENSION STABILIZER ON THE REAR AXLE.

Oct 12, 2007 – ON CERTAIN VEHICLES EQUIPPED WITH V8 ENGINES, IN CONDITIONS OF BELOW FREEZING TEMPERATURES COMBINED WITH LOW HUMIDITY, IT IS POSSIBLE FOR ELECTROSTATIC DISCHARGE TO OCCUR AT THE FUEL RAILS. IF THIS WERE TO OCCUR, THE ENGINE ELECTRONIC CONTROL UNIT (ECU) COULD BE AFFECTED SO THAT ENGINE STALLING COULD RESULT.

Sep 06, 2007 – CERTAIN AFTERMARKET BMW BIKE CARRIERS, P/N 82110393954, SOLD FOR USE ON MY 2005 BMW X3 AND X5 VEHICLES. A PINCH BOLT EXISTS BETWEEN THE BIKE ARM BRACKET AND THE UPRIGHT ASSEMBLY OF THE HITCH STYLE BICYCLE RACK.

Aug 29, 2007 – CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, "PASSENGER CAR BRAKE SYSTEMS." THE CAP OF THE BRAKE FLUID RESERVOIR HAS BEEN DESIGNED IN ORDERTO RECOGNIZE A LOW FLUID LEVEL OF THE HYDRAULIC BRAKE SYSTEM BY TRIGGERING A RED WARNING LAMP IN THE INSTRUMENT CLUSTER. A SWITCH THAT IS ATTACHED TO THIS CAP COULD MALFUNCTION AT HIGH TEMPERATURES.

Nov 01, 2005 – CERTAIN PASSENGER VEHICLES MAY HAVE BEEN BUILT WITH AN INCORRECTLY MANUFACTURED AUTOMATIC TRANSMISSION PARKING PAWL GUIDE PLATE.

Aug 26, 2005 – ON CERTAIN SPORT UTILITY VEHICLES, THE ATTACHMENT OF THE BRAKE LINE SUPPORT BRACKET WITHIN THE FRONT LEFT WHEEL WELL WAS NOT WELDED ACCORDING TO SPECIFICATIONS. IT COULD LOOSEN AND OVER TIME THE BRAKE HOSE COULD RUB AGAINST THE WHEEL WELL.

Aug 18, 2004 – ON CERTAIN PASSENGER VEHICLES WITH 3.0 L ENGINES AND MANUAL TRANSMISSIONS, IF THE VEHICLE IS IN FIRST GEAR, AND MOVING SLOWLY, WITH THE ACCELERATOR PEDAL HELD IN A CONSTANT POSITION OF LOW ENGINE SPEED AND WITH THE CLUTCH PEDAL HELD IN A PARTIALLY DEPRESSED POSITION, ENGINE SPEED MAY INCREASE.

Aug 13, 2004 – ON CERTAIN SPORT UTILITY VEHICLES, THE IN-TANK FUEL LINE MAY HAVE BEEN ATTACHED INCORRECTLY.

Jul 14, 2004 – ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 8 AND 12 CYLINDER ENGINES, THE DIGITAL ENGINE MANAGEMENT CONTROL (EMC) UNITS WERE NOT PRODUCED ACCORDING TO SPECIFICATIONS.

Nov 14, 2003 – ON CERTAIN SPORT UTILITY VEHICLES, THE BOLTS THAT HOLD THE FRONT DIFFERENTIAL, THE RIGHT OUTPUT SHAFT HOUSING FLANGE AT THE ENGINE, AND THE RIGHT-HAND ENGINE SUPPORT MAY BE INSUFFICIENTLY TIGHTENED.