BUICK ROADMASTER Recalls

Oct 24, 2007 – CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

Nov 24, 1997 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE ANTILOCK BRAKE SYSTEM (ABS) MODULATOR CAN CORRODE AND LEAK FLUID FROM THE FRONT BRAKE CIRCUIT.

Dec 10, 1996 – THE WHEEL LUG NUTS WERE NOT TIGHTENED TO THE PROPER SPECIFICATION DURING ASSEMBLY.

Jan 30, 1996 – DEFECTIVE LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WERE NOT PROPERLY TORQUED AND CAN LOOSEN.

Nov 16, 1995 – THESE VEHICLES WERE PRODUCED WITH AN IMPROPERLY ADJUSTED TRANSMISSION SHIFT CONTROL LINKAGE. THIS DOES NOT MEET WITH THE REQUIREMENTS OF FMVSS NO. 114, "THEFT PROTECTION."

Nov 03, 1995 – THESE VEHICLES WERE SHIPPED WITH BOTH THE SUPPLEMENTAL INFLATABLE RESTRAINT CAUTION LABEL AND A ROOF RACK CAUTION LABEL INSTALLED ON THE SAME SIDE OF THE SUN VISOR. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO.208, "OCCUPANT CRASH PROTECTION."

Apr 24, 1995 – THESE VEHICLES FAIL TO CONFORM TO FMVSS NO. 124, "ACCELERATOR CONTROL SYSTEMS." AT LOW TEMPERATURES, EXCESSIVE FRICTION CAN OCCUR IN THE ACCELERATOR PEDAL ASSEMBLY.

Oct 25, 1994 – THE FUEL TANK ATTACHMENT STRAP FASTENERS WERE NOT PROPERLY TIGHTENED. THE FASTENERS CAN COMPLETELY DETACH, EVENTUALLY ALLOWING THE FUEL TANK TO SAG AND THE BOTTOM OF THE TANK TO STRIKE THE ROADWAY.

Apr 16, 1994 – PAINT ON THE WHEEL MOUNTING SURFACES CAN ACT AS A SHIM BETWEEN THE WHEEL AND THE ROTOR/DRUM. AS THE VEHICLE IS DRIVEN, THE WHEEL IMBEDS INTO THE PAINT, LOOSENING THE LUG NUT AND CAUSING A LOSS OF CLAMP LOAD.

Mar 21, 1994 – THE ENGINE OIL COOLER INLET HOSE MAY HAVE BEEN INSTALLED TOO CLOSE TO THE STEERING GEAR CAUSING CHAFING. THE CHAFING CAN EVENTUALLY WEAR THROUGH THE HOSE'S PROTECTIVE SLEEVE RESULTING IN ENGINE OIL LEAKING ONTO THE ENGINE.