CHEVROLET CAVALIER Recalls

Jun 23, 2004 – CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, 'SEAT BELT ASSEMBLY ANCHORAGES.' THE PASSENGER-SIDE REAR SAFETY BELT MAY HAVE BEEN INSTALLED WITH AN INCORRECT NUT AND BOLT.

Jan 27, 2004 – ON CERTAIN PASSENGER VEHICLES. IF THE ENGINE FAILS TO START AND THE DRIVER HOLDS THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, AND SOMETIMES PRODUCES ENOUGH HEAT TO MELT INTERNAL SWITCH PARTS.

Nov 04, 2002 – CERTAIN PASSENGER VEHICLES AND MINI VANS HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE AND SOME OTHER RETAINERS USED IN VEHICLES ASSEMBLED BETWEEN JANUARY 1, 1996 AND OCTOBER 31, 1997, COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.

Mar 06, 2002 – ON CERTAIN PASSENGER VEHICLES. IF THE ENGINE FAILS TO START AND THE DRIVER HOLDS THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, AND SOMETIMES PRODUCES ENOUGH HEAT TO MELT INTERNAL SWITCH PARTS.

Jul 20, 2000 – VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH THE BI-FUEL OPTION FAIL TO COMPLY WITH FMVSS NO. 101, "CONTROL LOCATION, IDENTIFICATION, AND ILLUMINATION." THE INSTRUMENT PANEL LIGHTS IN THESE VEHICLES ARE AT FULL ILLUMINATION LEVELS AND CANNOT BE ADJUSTED. THE STANDARD REQUIRES AT LEAST TWO LEVELS OF ILLUMINATION.

Feb 28, 2000 – VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH BI-FUEL COMPRESSED NATURAL GAS (CNG) VEHICLES. THE CNG FUEL LINE AND THE CNG HIGH PRESSURE REGULATOR COOLANT LINES CAN CONTACT OTHER FUEL (GASOLINE) AND BRAKE LINES ON THE VEHICLE. ABRASION FROM CONTACT CAN CAUSE A LEAK IN THE BRAKE PIPE, FUEL PIPE, OR BOTH.

Aug 11, 1999 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES DO NOT COMPLY WITH REQUIREMENTS OF FMVSS NO. 101, "CONTROL LOCATION, IDENTIFICATION, AND ILLUMINATION." THE INSTRUMENT PANEL BACKLIGHTING MAY NOT FUNCTION AFTER ADJUSTING THE INTERIOR LIGHT INTENSITY.

Dec 15, 1998 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. ONE OF THE REAR SUSPENSION TRAILING ARM BOLTS CAN FATIGUE AND BREAK.

Jun 29, 1998 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. BECAUSE OF CERTAIN CALIBRATIONS IN THE AIR BAG'S SENSING AND DIAGNOSTIC MODULE, AN INADVERTENT AIR BAG DEPLOYMENT COULD OCCUR IN A LOW SPEED CRASH OR WHEN AN OBJECT STRIKES THE FLOOR PAN.

Feb 25, 1998 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES WERE BUILT WITH MIS-LOCATED WELDS AT THE JOINT BETWEEN THE LEFT ROCKER PANEL INNER REINFORCEMENT AND THE BODY SIDE RING. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 214, "SIDE DOOR STRENGTH."