CHEVROLET MALIBU Recalls

Nov 24, 1984 – REAR AXLE ASSEMBLY MAY HAVE AXLES THAT WERE IMPROPERLY MANUFACTURED. THIS CONDITION MAY RESULT IN SEPARATION OF THE AXLE SHAFT AND WHEEL ASSEMBLY FROM THE VEHICLE.

Oct 13, 1983 – THE MASTER CYLINDER REAR BRAKE PIPE, WHICH CARRIES BRAKE FLUID TO THE REAR BRAKES, MAY DEVELOP A LEAK DUE TO EXTENDED CHAFING ON THE AIR CLEANER RESONATOR BRACKET.

Aug 19, 1983 – ACCELERATOR PUMP LEVER RETAINING PIN MAY LOOSEN AFTER REPEATED HEAVY ACCELERATOR PEDAL APPLICATIONS. THIS COULD CAUSE THE THROTTLE TO BECOME STUCK IN THE OPEN POSITION.

Jan 03, 1982 – UNDER CERTAIN VEHICLE OPERATING CONDITIONS, THE GOVERNOR WEIGHT RETAINER IN THE INJECTION PUMP MAY FAIL. THE THROTTLE VALVE COULD STICK, PREVENTING RETURN TO IDLE AND SHUT DOWN OF THE ENGINE BY THE DRIVER.

Feb 25, 1981 – THE BOLTS THAT ATTACH THE LOWER REAR CONTROL ARM TO THE FRAME MAY FRACTURE. THE REAR CONTROL ARM SUPPORTS AND POSITIONS THE REAR AXLE. FRACTURE OF THE BOLTS WOULD ALLOW THE CONTROL ARM TO DROP FREE.

Feb 11, 1981 – THE ELECTRO-CLEAR REAR WINDOW DEFOGGERS CONTAIN A DEFECT WHICH CAUSES THE GLASS TO SHATTER WITHOUT IMPACT DURING OR SOME TIME AFTER USE OF THE DEFOGGER. VERTICAL ELECTRICAL STRIPS MAY DETERIORATE AND CAUSE HOT SPOTS THAT CAN RESULT IN BREAKAGE OF THE REAR GLASS.

Aug 28, 1979 – THE INVOVLED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACTS". INCORRECT HEAD RESTRAINTS MAY HAVE BEEN INSTALLED.

Jul 23, 1979 – UNDER CERTAIN DRIVING CONDITIONS, THESE VEHICLES CAN EXPERIENCE TEMPERATURES IN THE FRONT WHEEL OUTER BEARING AREA WHICH CAN AFFECT THE WHEEL BEARING GREASE. THIS CAN RESULT IN INADEQUATE LUBRICATION OF THE BEARING. THIS CONDITION MAY BE FURTHER AGGRAVATED BY IMPROPER ADJUSTMENT OF THE FRONT WHEEL SPINDLE NUT.

Jun 13, 1978 – THE REAR AXLE SHAFTS MAY CONTAIN A FLAW IN THE METAL. THIS FLAW COULD ALLOW THE SHAFT TO BREAK AND THE TIRE AND WHEEL ASSEMBLY TO SEPARATE.

Jun 13, 1978 – THE HUB PORTION OF THE FAN BLADE ASSEMBLY COULD CRACK DUE TO HIGH STRESS LEVELS GENERATED DURING ENGINE OPERATING CONDITIONS. EVENTUALLY, THE BLADE COULD BREAK APART AT THE HUB AND BLADE PIECES COULD BE PROPELLED INTO THE ENGINE. IF THE HOOD IS OPEN WHILE THE ENGINE IS RUNNING, THE FRAGMENTS WOULD BE FREE TO FLY FROM THE VEHICLE.