CHEVROLET P6 Recalls

Jul 05, 1995 – THESE VEHICLES WERE ASSEMBLED WITH A TRANSMISSION REVERSE SIGNAL SWITCH THAT COULD LEAK CAUSING LOSS OF ELECTRICAL CONTACT WHEN THE TRANSMISSION IS IN REVERSE. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Jan 08, 1994 – THE INTERMEDIATE STEERING SHAFT WAS ASSEMBLED WITH LOOSE OR MISSING UPPER AND LOWER PINCH BOLTS WHICH MAY CAUSE SEPARATION OF THE SHAFT.

Jun 01, 1990 – IMPROPER DRILLING OF HOLE TAPERS IN THE STEERING ARM AND PITMAN ARM MAY CAUSE INADEQUATE SEATING OF THE DRAG LINK BALL STUD ON EITHER THE PITMAN ARM OR THE STEERING ARM AND TIE ROD END ON THE STEERING ATTACHMENTS.

Oct 02, 1984 – THE DUAL AIR RESERVOIRS OF SOME TRUCKS WERE EQUIPPED WITH CARBON STEEL SPRINGS INSTEAD OF STAINLESS STEEL SPRINGS, AS INTENDED. THE CARBON STEEL SPRING IS MORE SUSCEPTIBLE TO RUSTING THAN THE STAINLESS STEEL SPRING. THIS RUSTING COULD CAUSE THE CHECK VALVE TO FAIL, CAUSING TOTAL LOSS OF FRONT AND REAR BRAKES.

May 29, 1984 – UNWANTED AIR IS BEING DRAWN INTO THE BRAKE SYSTEM WHEN BRAKE PEDAL IS RELEASED. THIS IS DUE TO THE USE OF THE BENDIX MASTER CYLINDER IN COMBINATION WITH THE BENDIX HYDROVAC.