ELDORADO XHF Recalls

Feb 07, 2024 – Eldorado National-California, Inc. (ENC) is recalling certain 2012-2023 XHF and Arrivo vehicles equipped with a Ricon wheelchair lift. The red beacon lighting on the threshold warning system (TWS) may not be bright enough. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 403, "Platform Lift Systems."

May 10, 2021 – Eldorado National-California, Inc. (Eldorado National-California) is recalling certain 2017-2020 Axess, EXRM, and XHF vehicles. The sealing washer may not seat correctly in the pilot bore holes, allowing the high pressure fuel rail assembly to leak.

Apr 20, 2020 – Eldorado National-California, Inc. (Eldorado National-California) is recalling certain 2018-2020 EZ Rider, XHF, and Axess vehicles powered by compressed natural gas (CNG). The thermally activated pressure relief device (PRDs) installed on the CNG fuel system may not vent the system when exposed to heat, potentially resulting in the system rupturing.

Oct 27, 2017 – Eldorado National-California, Inc. (Eldorado National) is recalling certain 2017 Axess, E-Z Rider, XHF, and Arrivo buses, equipped with certain Recaro Commercial Bus Driver Seats, models Ergo R, Ergo D, AM71, AM72 and AM80. In the affected seats, the seat belt buckle may be stuck in the locked position, preventing the seat belt tongue from being able to be inserted and locked.

Jan 14, 2016 – Eldorado National-California , Inc. (Eldorado) is recalling certain model year 2010-2015 Axess and EZRM, 2011-2015 XHF, and 2014-2016 Arrivo vehicles equipped with certain Recaro Ergo-M Commercial Bus Driver Seats. The affected seats have J-Brackets that may be missing welds which could allow the seat belt anchorage assembly to separate from the J-Bracket.

May 27, 2015 – Eldorado National-California, Inc. (Eldorado) is recalling certain model year 2007-2015 Axess, E-Z Rider II, and XHF vehicles manufactured July 1, 2007, to May 2, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.

Oct 31, 2014 – Eldorado National-California, Inc. (Eldorado) is recalling certain model year 2008-2009 Axess, E-Z Rider II, XHF, Escort RE-A, and Transmark RE vehicles manufactured April 1, 2008, to December 30, 2008. The mechanical springs used to return the accelerator pedal to idle after the driver lifts their foot off the pedal may break.

Jun 11, 2012 – ELDORADO NATIONAL ? CALIFORNIA (ELDORADO NATIONAL) IS RECALLING CERTAIN MODEL YEAR 2009 AND 2010 PASSPORT, MST II, AND XHF TRANSIT BUSES EQUIPPED WITH BRAUN CENTURY-2 AND/OR VISTA-2 WHEELCHAIR LIFTS. OVER TIME AND WITH FREQUENT USE, THE ROLL STOP LATCHES ON THE OUTER BARRIER MAY BECOME BENT OR MISALIGNED. 

Aug 22, 2011 – ELDORADO IS RECALLING CERTAIN MODEL YEAR 2011 COMMERCIAL BUSES, MODELS EZ RIDER II MAX, TRANSMARK, XHF, AND AXESS, MANUFACTURED FROM NOVEMBER 1, 2010, THROUGH MARCH 31, 2011, EQUIPPED WITH A CUMMINS ISB, ISL, ISC, OR ISX DIESEL ENGINE. THE V-BAND CLAMP ASSEMBLY, PART NUMBERS Q187684, Q187685, AND Q187686, USED TO CONNECT THE INLET AND OUTLET CONE SECTIONS TO THE DIESEL OXIDATION CATALYST (DOC)/DIESEL PARTICULATE FILTER (DPF) INCLUDE A T-BOLT WHICH CAN FRACTURE AND FAIL WHEN SUBJECTED TO STRESS OR LOAD. A FRACTURE OR FAILURE OF THE T-BOLT MAY CAUSE THE CLAMP TO LOOSEN AND THE INLET OR OUTLET SECTIONS ATTACHED TO THE DOC/DPF HOUSING TO DISCONNECT.

Mar 25, 2010 – ELDORADO NATIONAL - CALIFORNIA HAS NOTIFIED NHTSA OF A DEFECT IN CERTAIN MODEL YEAR 2005-2010 TRANSIT BUSES FITTED WITH RICON PUBLIC USE LIFTS. THE RESTRAINT BELT ON THESE LIFTS WAS DESIGNED TO PREVENT THE LIFT FROM MOVING, UNLESS THE TONGUE OF THE BELT IS FULLY ENGAGED AND LATCHED IN THE BUCKLE. RICON HAS DISCOVERED, HOWEVER, THAT IT IS POSSIBLE FOR THE OPERATOR TO INSERT THE BELT TONGUE INTO THE BUCKLE WITHOUT FULLY ENGAGING THE LATCHING MECHANISM. IN THIS CASE, THE RESTRAINT BELT WOULD APPEAR TO BE LATCHED, AND THE OPERATOR COULD RUN THE LIFT. IF THE RESTRAINT BELT TONGUE IS NOT FULLY ENGAGED INTO THE RESTRAINT BELT BUCKLE, AND LATCHED, THE LIFT MAY OPERATE WITH AN OCCUPANT ON THE PLATFORM.