FCCC Recalls

Aug 25, 2008 – DAIMLER TRUCKS IS RECALLING 2,250 MY 2006 AND 2007 THOMAS BUILT MINOTOUR, FS65, C2, HDX, AND MVP EF SCHOOL BUSES AND RECREATIONAL VEHICLE CHASSIS MANUFACTURED BETWEEN MARCH 9, 2005 AND FEBRUARY 23, 2007, EQUIPPED WITH RICON S OR K SERIES WHEELCHAIR LIFTS. THE ANTI-STOW INTERLOCK MAY NOT DETECT THE PRESENCE OF A WHEELCHAIR OR MOBILITY AID USER. THE PRESSURE SENSING SWITCH THAT DETECTS THE PRESENCE OF WEIGHT ON THE PLATFORM WAS NOT ADJUSTED TO THE NECESSARY SENSITIVITY LEVEL. THE LIFT COULD STOW EVEN THOUGH SOMEONE OR SOMETHING IS STILL ON THE LIFT WHICH FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 404, "PLATFORM LIFT INSTALLATIONS IN MOTOR VEHICLES."

Jun 17, 2008 – DAIMLER TRUCKS IS RECALLING 2,506 MY 2008 XC MOTOR HOME CHASSIS AND THOMAS BUILT HDX SCHOOL AND TRANSIT BUSES EQUIPPED WITH SAF-HOLLAND ADL SERIES REAR SUSPENSIONS. IN SOME INSTANCES THE TRANSVERSE BEAM WAS NOT PROPERLY WELDED WHICH COULD RESULT IN A FAILURE OF THE WELD.

Mar 25, 2008 – DAIMLER TRUCKS IS RECALLING 28,764 MY 2001 THROUGH 2008 FCCC B2 AND FS65 SCHOOL BUS CHASSIS, FCCC FB65 CONVENTIONAL BUSES, AND STERLING ACTERRA, FREIGHTLINER FLN, AND BUSINESS CLASS M2 HEAVY TRUCKS, BUILT FROM JANUARY 26, 2000, THROUGH MARCH 24, 2008, MANUFACTURED WITH ARVINMERITOR OR AXLE ALLIANCE COMPANY 6,000 THROUGH 8,000 POUND FRONT AXLES UTILIZING A FOUR PIECE SPINDLE-NUT SET. THESE AXLE ASSEMBLIES MAY HAVE BEEN PRODUCED WITH A THIN SPINDLE NUT WHICH MAY LEAD TO INCORRECT END PLAY, CONE SPIN, EXCESSIVE HEAT, DEGRADATION OF LUBRICATION, WEAR OF THE SPINDLE NUT AND BEARING JOURNAL, OIL CONTAMINATION WITH METAL SHAVINGS, AND PREMATURE BEARING FAILURE.

Jan 28, 2008 – ON CERTAIN TRUCKS AND MOTOR HOMES CHASSIS, INCORRECT FASTENERS MAY NOT PROVIDE ADEQUATE CLAMPING FORCE BETWEEN THE BRAKE CALIPER AND BRAKE ANCHOR PLATE POTENTIALLY RESULTING IN REDUCED BRAKE EFFECTIVENESS.

Aug 08, 2007 – CERTAIN MOTOR HOME CHASSIS EQUIPPED WITH ZF MODEL 8018 STEERING GEARS MAY HAVE BEEN ASSEMBLED WITH THE INCORRECT RECIRCULATING BALL SPACER. THIS COULD POTENTIALLY ALLOW THE RECIRCULATING BALLS TO ESCAPE FROM THE RECIRCULATING BALL CIRCUIT RESULTING IN A LOSS OF STEERING.

Aug 02, 2007 – ON CERTAIN TRUCKS, A MANUFACTURING ERROR IN THE FUEL-WATER SEPARATOR PREHEATER THERMOSWITCH MAY PREVENT THE FUEL PREHEATER FROM TURNING OFF IF THE IGNITION IS LEFT ON. IF THE IGNITION SWITCH IS LEFT ON WHEN FUEL IS ADDED TO THE FUEL- WATER SEPARATOR AT THE FACTORY OR DURING A FILTER ELEMENT CHANGE, A SMALL FLAME MAY OCCUR INSIDE THE FILTER COVER.

Jul 20, 2007 – ON CERTAIN MOTOR HOMES BUILT WITH CUMMINS ISL CM850 DIESEL ENGINES, THE CONNECTING ROD CONTAINS A MACHINING DEFECT IN THE WRIST PIN BUSHING OF THE ROD THAT COULD CAUSE A SEIZURE OF THE PISTON PIN.

Jul 18, 2007 – FREIGHTLINER IS RECALLING CERTAIN SCHOOL BUS CHASSIS, HEAVY TRUCKS, VAN CHASSIS, RV MOTORHOME CHASSIS MANUFACTURED FROM JANUARY 5 TO MAY 17, 2007, EQUIPPED WITH AXLE ALLIANCE COMPANY (AAC) FRONT AXLES. DURING THE FRONT AXLE ASSEMBLY, THE FASTENERS THAT ATTACH THE STEERING ARM OR TIE ROD ARMS TO THE SPINDLE MAY BE OVER OR UNDER TIGHTENED.

Jul 16, 2007 – CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY.

Feb 13, 2007 – CERTAIN MY 2007 THOMAS BUILT C2 SAF-T-LINER SCHOOL BUSES AND FREIGHTLINER BUSINESS CLASS M2, FCCC B2, AND S2 BUS CHASSIS MANUFACTURED BETWEEN JULY 3 AND NOVEMBER 3, 2006.