FLEETWOOD FIESTA Recalls

Oct 04, 2006 – ON CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH GENERAL MOTORS 8.1L V8 ENGINES, IMPROPER HARDENING DURING THE HEAT TREATMENT PROCESS CAN CAUSE THE FUEL RAIL PULSE DAMPER RETAINER CLIP TO FRACTURE, RESULTING IN INADEQUATE RETENTION OF THE DAMPER. IF THE DAMPER BECOMES LOOSE, FUEL COULD BE PUMPED BY THE FUEL PUMP INTO THE UNDER HOOD AREA.

Apr 12, 2006 – CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH ACTIA CORPORATE INSTRUMENT CLUSTERS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 101 "CONTROLS AND DISPLAYS" AND NO. 105 "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." IF THE BRAKE FAIL INPUT FALLS BELOW A VOLTAGE OF 1.5V, THE BRAKE FAILURE LAMP AND ALARM WILL BE ACTIVATED. ALSO ACTIVATION OF THE ABS TELLTALE WHEN THE ABS IS NOT PROPERLY FUNCTIONING DOES NOT ALWAYS OCCUR.

Feb 23, 2006 – ON CERTAIN MOTOR HOMES EQUIPPED WITH KWIKEE BRAND ELECTRIC ENTRY STEP BUILT WITH A CONTROL UNIT MANUFACTURED BY AMERICAN TECHNOLOGIES, MAY DEVELOP AN ELECTRICAL SHORT DURING COLD WEATHER, ALLOWING FOR THE POTENTIAL OF THE PLASTIC CASE TO IGNITE.

Jul 20, 2004 – CERTAIN MOTOR HOMES EQUIPPED WITH DRAW TITE HITCH RECEIVERS MAY BE MISSING ONE OR MORE WELDS BETWEEN THE HITCH RECEIVER BOX AND THE BOTTOM SUPPORT PLATE.

Nov 04, 2003 – ON CERTAIN TRAVEL TRAILERS EQUIPPED WITH SAMSUNG MICROWAVE OVENS, THESE OVENS WERE PRODUCED WITH A DEFECTIVE PANEL. AN ELECTRICAL SHORT CAN OCCUR BETWEEN CIRCUIT PATTERNS ON THE MEMBRANE PANEL, ESPECIALLY OVERLAPPED BY A "JUMPER" OR JUMP WIRE. THIS MAY CAUSE THE OVEN TO ACTIVATE WITHOUT PRESSING ANY KEY PADS.

Mar 04, 2003 – CERTAIN MOTOR HOME CHASSIS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." THE BRAKE SYSTEM WARNING INDICATOR MAY NOT FUNCTION AS REQUIRED BY STANDARD.