FLEETWOOD TIOGA Recalls

Jun 14, 2005 – CERTAIN CLASS C MOTOR HOMES BUILT ON CHEVROLET CHASSIS FAIL TO COMPLY WITH THE REQUIREMENTS OF PART 567, "CERTIFICATION." THE FEDERAL CERTIFICATION TAG WAS PRINTED WITH THE INCORRECT REAR GROSS AXLE WEIGHT RATING (GAWR) AND INCORRECT CARGO CARRYING CAPACITY TAG.

Aug 27, 2004 – ON CERTAIN CLASS C MOTOR HOMES, THE RANGE TOP LIQUID PROPANE GAS (LPG) CONNECTION LINE IS A FLEXIBLE HOSE CONNECTOR. THIS HOSE IS ROUTED IN CLOSE PROXIMITY TO A BURNER AND MAY MELT WHEN EXPOSED TO HIGH HEAT FOR A PERIOD OF TIME.

Jul 20, 2004 – CERTAIN MOTOR HOMES EQUIPPED WITH DRAW TITE HITCH RECEIVERS MAY BE MISSING ONE OR MORE WELDS BETWEEN THE HITCH RECEIVER BOX AND THE BOTTOM SUPPORT PLATE.

Nov 04, 2003 – ON CERTAIN TRAVEL TRAILERS EQUIPPED WITH SAMSUNG MICROWAVE OVENS, THESE OVENS WERE PRODUCED WITH A DEFECTIVE PANEL. AN ELECTRICAL SHORT CAN OCCUR BETWEEN CIRCUIT PATTERNS ON THE MEMBRANE PANEL, ESPECIALLY OVERLAPPED BY A "JUMPER" OR JUMP WIRE. THIS MAY CAUSE THE OVEN TO ACTIVATE WITHOUT PRESSING ANY KEY PADS.

Jul 14, 2003 – ON CERTAIN MODEL R, CLASS C MOTOR HOMES, A LIQUID PROPANE (LP) GAS PIPE AND HOSE IS UNSUPPORTED AND CAN BE PINCHED DURING SLIDE OUT ROOM OPERATION.

May 06, 2003 – ON CERTAIN MODELS R, V, AND W MOTOR HOMES, THE INTERMEDIATE DRIVE SHAFT WILL VIBRATE EXCESSIVELY, LEADING TO CARRIER BEARING FAILURE.

Apr 10, 2000 – VEHICLE DESCRIPTION: CLASS C MOTOR HOMES EQUIPPED WITH A SPARE WHEEL . THIS WHEEL HAS INSUFFICIENT WEIGHT CARRYING CAPACITY WHEN MATCHED TO A MAXIMUM LOADED TIRE. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS."

Jun 04, 1999 – VEHICLE DESCRIPTION: MOTOR HOMES. A GENERATOR BATTERY CABLE MAY HAVE BEEN ROUTED TOO CLOSE TO A NOTCH IN THE HEAT SHIELD, RESULTING IN DAMAGE TO THE BATTERY CABLE INSULATION.

Feb 01, 1995 – THE FRONT CABOVER HAS A TEMPERED GLASS WINDOW MOUNTED AT AN ANGLE OF 20 DEGREES FROM THE VERTICAL WHICH CAN CAUSE THE GLASS TO BREAK WHILE THE VEHICLE IS IN MOTION.

Jan 19, 1994 – THE ELECTRICAL CABLE BETWEEN THE ENGINE COMPARTMENT AND THE GENERATOR COMPARTMENT IS ROUTED TOO CLOSE TO THE LEFT-HAND ENGINE EXHAUST MANIFOLD WHICH CAUSES THE CABLE INSULATION TO MELT AND POSSIBLY CATCH ON FIRE.