FORD F750 Recalls

Sep 19, 2005 – ON CERTAIN MEDIUM DUTY CHASSIS CAB VEHICLES EQUIPPED WITH HYDRAULIC BRAKES, THE DRIVE LINE PARK BRAKE ANCHOR BOLT MAY BE SUSCEPTIBLE TO FATIGUE LOADING. THE BOLT COULD FRACTURE OVER TIME DUE TO INSUFFICIENT CLAMP LOAD AS A RESULT OF IMPROPER ANCHOR BOLT PLATING.

May 04, 2005 – ON CERTAIN CAB CHASSIS VEHICLES EQUIPPED WITH ACCURIDE ALUMINUM WHEELS, THE WHEELS WERE NOT PROPERLY PRE-STRESSED. THIS ALLOWS CRACKS TO DEVELOP OVER TIME.

Jan 18, 2002 – CERTAIN MEDIUM DUTY PICKUP TRUCKS EQUIPPED WITH AIR BRAKES THAT INCLUDE THE OPTIONAL TRAILER PACKAGE FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS." THE AIR BRAKE LINES CONNECTED TO THE TRACTOR PROTECTION VALVE ARE MISROUTED.

Aug 08, 2001 – VEHICLE DESCRIPTION: PASSENGER CARS, SPORT UTILITY VEHICLES, AND LIGHT AND MEDIUM DUTY PICKUP TRUCKS. A SWITCH LOCATED IN THE PLASTIC COVER OF THE WIPER MOTOR GEAR CASE COULD MALFUNCTION AND OVERHEAT, POTENTIALLY RESULTING IN LOSS OF INTERMITTENT WIPER FUNCTION, LOSS OF WIPER PARK FUNCTION, COMPLETE LOSS OF WIPER FUNCTION, OR IGNITION OF THE PLASTIC COVER MATERIAL. SWITCH MALFUNCTION IS MOST LIKELY TO OCCUR WHEN THE INTERMITTENT SETTING OF THE WIPERS IS BEING USED, OR WHEN SNOW OR ICE OBSTRUCTS THE BLADES FROM RETURNING TO THE "PARKED" POSITION AT THE BOTTOM OF THE WINDSHIELD. THESE VEHICLES WERE BUILT AT THE FOLLOWING ASSEMBLY PLANTS: ATLANTA PLANT FROM 2/11/00 THROUGH 7/31/00; CHICAGO PLANT FROM 2/14/00 THROUGH 8/4/00; KANSAS CITY PLANT FROM 2/26/00 TO 9/4/00; KENTUCKY TRUCK PLANT FROM 2/18/00 TO 8/31/00; MICHIGAN TRUCK PLANT FROM 2/23/00 THROUGH 8/3/00; NORFOLK PLANT FROM 2/21/00 THROUGH 7/27/00; WAYNE STAMPING AND ASSEMBLY PLANT FROM 2/25/00 THROUGH 8/15/00; AND WIXOM PLANT FROM 2/15/00 THROUGH 8/8/00.

May 11, 2001 – VEHICLE DESCRIPTION: TRUCKS EQUIPPED WITH DRAG LINK ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.

Sep 21, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.

Aug 18, 2000 – TRUCKS EQUIPPED WITH ALLISON 1000 OR 2400 SERIES TRANSMISSIONS. THESE TRANSMISSIONS CAN EXPERIENCE PARK PAWL TO REAR COVER INTERFERENCE DUE TO AN OUT OF FLATNESS CONDITION.

Sep 27, 1999 – VEHICLE DESCRIPTION: MEDIUM DUTY TRUCKS EQUIPPED WITH HYDROMAX HYDRAULIC BRAKE SYSTEMS. THE PARK BRAKE WARNING LAMP CIRCUITRY DOES NOT INCLUDE A PROVISION FOR A PARK BRAKE WARNING LAMP CHECK FUNCTION. THEREFORE, THESE VEHICLES DO NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS."

Mar 14, 1977 – THE INVOLVED VEHICLES MAY HAVE BEEN ASSEMBLED WITH IMPROPERLY MANUFACTURED FRONT SPRING U-BOLTS USED TO SECURE THE FRONT AXLE ASSEMBLY TO THE SPRING. THE FOUR U-BOLTS MAY EXPERIENCE CRACKS AND COULD ULTIMATELY BREAK. SHOULD TWO U-BOLTS ON THE SAME SIDE OF THE VEHICLE BREAK, THE FRONT AXLE WOULD NOT BE RETAINED SECURELY.