FORD L SERIES Recalls

Aug 27, 2007 – CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

Sep 09, 1997 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE AIR BRAKE RESERVOIR ASSEMBLIES HAVE POOR WELD FUSION AT THE WELDED SEAMS IN THE RESERVOIRS. THIS COULD RESULT IN REPUTURE OF THE SEAM AND SUBSEQUENT RELEASE OF THE COMPRESSED AIR.

Jan 22, 1990 – STEERING COLUMNS CONTAIN AN INCORRECT AND POSSIBLY UNDER TORQUED COUPLING TO STEERING COLUMN CLAMPING BOLT.

Nov 07, 1989 – INTERMEDIATE STEERING SHAFTS HAVE AN INADEQUATE LENGTH OF SPLINE ENGAGEMENT AND MAY EXHIBIT EXCESSIVE SIDE-TO-SIDE FREEPLAY MOVEMENTS.

Apr 27, 1987 – DIESEL ENGINE GOVEERNOR LEVER ASSEMBLIES MAY HAVE BEEN IMPROPERLY ASSEMBLED SO THAT ONE OR MORE OF THREE RETAINING PRONGS MAY NOT BE ENGAGED IN THE GOVERNOR LEVER PIVOT SHAFTS.

Dec 20, 1985 – THE HYDRAULIC PARKING BRAKE CONTROL VALVE MAY INADVERTENTLY ACTIVATE DUE TO MOMENTARY PRESSURE DISRUPTIONS WITHIN THE SYSTEM AND CAUSE THE PARKING BRAKE TO BE APPLIED, STOPPING OR SLOWING THE TRUCK UNEXPECTEDLY. CONSEQUENCE OF DEFECT: THIS UNEXPECTED STOPPING OR SLOWING OF THE TRUCK MAY INCREASE THE RISK OF A REAR END COLLISION SINCE THE BRAKE (STOP) LIGHTS ARE NOT ACTIVATED. ALSO, ON CERTAIN ROAD CONDITIONS THIS OCCURRENCE MAY RESULT IN LOSS OF VEHICLE CONTROL WHICH WOULD LEAD TO AN ACCIDENT.

Mar 22, 1983 – SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF MAINTAINING IT.

Mar 26, 1982 – THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE STANDARD NO. 124, "ACCELERATOR CONTROL SYSTEMS", DUE TO FAILURE OF THE THROTTLE TO RETURN COMPLETELY TO IDLE UNDER CERTAIN CONDITIONS WITH ONE OF THE TWO ACCELERATOR CONTROL RETURN SPRINGS INOPERATIVE.

Dec 04, 1979 – THE OPTIONAL TANDEM SUSPENSION ASSEMBLY MAY HAVE BEEN INSTALLED USING A STANDARD BEAM END ADAPTER KIT, RATHER THAN THE REQUIRED SPECIAL KIT. PROGRESSIVE DETERIORATION COULD OCCUR TO THE ADAPTER TO BEAM END BUSHING JOINT, POSSIBLY RESULTING IN FRACTURE OF THE BEAM TO AXLE ATTACHING BOLTS.

Sep 11, 1979 – THE CAST HUBS ON SOME OF THE INVOLVED VEHICLES WERE IMPROPERLY MANUFACTURED. THEY MAY BE SUBJECT TO HIGH MILEAGE FATIGUE CRACKS AT THE INNER BEARING AREA OR ALONG THE FLANGE PORTIONS TO WHICH THE WHEELS ARE MOUNTED.