FORD L9000 Recalls

May 09, 2019 – Stainless & Repair, Inc. (Stainless & Repair) is recalling certain 2016-2017 Freightliner M2-112 and 1994-1995 Ford L9000 vehicles equipped with Whelen brake lights. Depending on the specific wiring of the vehicle, these brake lights may illuminate when the brake pedal has not been pressed.

Jun 13, 1995 – AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVERPRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM THE MOUNTING BASE.

Aug 15, 1994 – THE LABELS REMINDING OPERATORS CLOSING THE FUEL TANK CROSSOVER VALVES TO REOPEN THE VALVES BEFORE OPERATING THE ENGINES WERE OMITTED. IF THE TANKS ARE OVER HALF FULL AND VEHICLE OPERATION WAS RESUMED WITHOUT REOPENING THE FUEL TANK CROSS-OVER VALVES, PRESSURE COULD BUILD IN ONE OF THE TANKS.

Jun 25, 1990 – SECONDARY SERVICE RESERVOIR AIR CHECK VALVES MAY NOT SEAT PROPERLY DUE TO A MECHANICAL INTERFERENCE CONDITION BETWEEN A CIRCULAR BRASS GUIDE AND THE WALL OF A CYLINDRICAL FERRULE IN WHICH THE BRASS GUIDE IS INTENDED TO MOVE FREELY.

Aug 12, 1986 – HAND THROTTLE CONTROLS WERE NOT IDENTIFIED EITHER ON THE CONTROL KNOB OR ON THE INSTRUMENT PANEL AS REQUIRED BY FMVSS 101. CONSEQUENCE OF DEFECT: TRUCKS ARE NOT IN COMPLIANCE WITH FMVSS 101, CONTROLS AND DISPLAYS.

Oct 25, 1977 – THE SEAT BELTS ON THE INVOLVED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NOS. 208, "OCCUPANT CRASH PROTECTION", AND 209, "SEAT BELT ASSEMBLIES". THE NON-CONFORMITY EXISTS BECAUSE WHEN THE DRIVER"S SEAT IS ADJUSTED TO THE FULL FORWARD POSITION, THE SEAT CUSHION IS ADJUSTED TO MAXIMUM ELEVATION, AND THE SEAT BACK IS TILTED TO THE FULLY UPRIGHT POSITION, THE SEAT BELTS ARE NOT LONG ENOUGH TO ACCOMMODATE SOME DRIVERS.