FOUR WINDS Recalls

Jul 02, 2007 – ON CERTAIN MOTOR HOMES EQUIPPED WITH ATWOOD SEALED BURNER RANGES, THE RANGE AND SLIDE-IN BURNER TUBES LEADING FROM THE GAS MANIFOLD TO THE BURNER HEADS HAD A DEPRESSION OR 'KINK' IN THE EXTERIOR BEND RESTRICTING PROPER AIRFLOW AND GAS MIXTURE.

Mar 05, 2007 – CERTAIN MOTOR HOMES EQUIPPED WITH A TWO-DOOR REFRIGERATOR, MANUFACTURED BY THE DOMETIC CORPORATION, MAY HAVE A DEFECT IN THE BOILER TUBE. PRESSURIZED COOLANT SOLUTION COULD BE RELEASED INTO AN AREA WHERE AN IGNITION SOURCE (GAS FLAME) IS PRESENT.

Feb 12, 2007 – CERTAIN MOTOR HOMES MAY HAVE IMPROPER ROUTING OR SUPPORT OF THE PROPANE (LP) GAS LINE TO THE KITCHEN SLIDE-OUT ROOM.

Sep 13, 2006 – ON CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH GM 8.1L V8 ENGINES, IMPROPER HARDENING DURING THE HEAT TREATMENT PROCESS CAN CAUSE THE FUEL RAIL PULSE DAMPER RETAINER CLIP TO FRACTURE, RESULTING IN INADEQUATE RETENTION OF THE DAMPER. IF THE DAMPER BECOMES LOOSE, FUEL COULD BE PUMPED BY THE FUEL PUMP INTO THE UNDER HOOD AREA.

Jul 12, 2006 – CERTAIN CHASSIS MAY HAVE BEEN EQUIPPED WITH INCORRECT STEERING INTERMEDIATE SHAFTS. THE SPLINE CAN STRIP WHILE THE STEERING WHEEL IS BEING TURNED.

Mar 30, 2006 – CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH ACTIA CORPORATE INSTRUMENT CLUSTERS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NOS. 101 "CONTROLS AND DISPLAYS" AND 105 "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." IF THE BRAKE FAIL INPUT FALLS BELOW A VOLTAGE OF 1.5V, THE BRAKE FAILURE LAMP AND ALARM WILL BE ACTIVATED. ALSO ACTIVATION OF THE ABS TELLTALE WHEN THE ABS IS NOT PROPERLY FUNCTIONING DOES NOT ALWAYS OCCUR.

Mar 16, 2006 – ON CERTAIN MOTOR HOMES BUILT ON FREIGHTLINER CHASSIS AND EQUIPPED WITH I-SHAFTS SUPPLIED BY ZF HEAVY DUTY STEERING, THE STEERING SHAFT ASSEMBLIES WITH LOWER YOKES MAY HAVE BEEN INCORRECTLY MACHINED. THE STEERING SHAFT SPLINES COULD PUSH THROUGH THE LOWER YOKE, ALLOWING THE STEERING WHEEL TO TURN WITHOUT ANY RESPONSE.

Oct 06, 2005 – ON CERTAIN CLASS A AND CLASS B MOTOR HOMES, THE HITCH MAY HAVE BEEN MANUFACTURED WITH A SPACER PLATE THAT DOES NOT FIT FLUSH TO THE REAR EXTENSION.

Jul 05, 2005 – ON CERTAIN MOTOR HOMES BUILT ON FORD CHASSIS CAB VEHICLES EQUIPPED WITH 5.4L OR 6.8L GASOLINE ENGINES, THE FUEL JUMPER LINE MAY HAVE AN INCORRECT END FORM.

Jun 10, 2005 – CERTAIN MOTOR HOMES BUILT ON FORD E-450 CHASSIS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, 'TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS.' THE TIRE PRESSURE IS INCORRECTLY LISTED ON THE LABEL FOR THE REAR TIRES.