FREIGHTLINER CENTURY Recalls

Aug 07, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS AND SCHOOL BUS CHASSIS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.

May 30, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH EATON AUTOSHIFT GEN II TRANSMISSION ASSEMBLIES. DUE TO A SOFTWARE PROBLEM IN THE TRANSMISSION ASSEMBLIES, THE TRANSMISSION WILL SELECT THE WRONG GEAR.

Mar 17, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH DUAL LEAF SPRING TYPE AIR RIDE SUSPENSIONS AND VEHICLES BUILT WITH SINGLE LEAF SPRING TYPE AIR RIDE SUSPENSIONS. REAR SUSPENSION SPRINGS CAN FRACTURE THROUGH THE CENTER BOLT HOLE AFTER VEHICLE ASSEMBLY.

Dec 29, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE TIE ROD ENDS CAN FRACTURE DUE TO LOW STRESS, HIGH CYCLE, REVERSED BENDING FATIGUE RESULTING FROM A SYSTEM RESONANCE.

Oct 26, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE OUTBOARD BEARING ON THE STEERING AXLE HUBS CAN FAIL DUE TO WATER INTRUSION THROUGH A HUBCAP VENT.

Dec 21, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE WINDSHIELD WIPER CONNECTING LINKAGE SOCKETS CAN WEAR OUT PREMATURELY DUE TO INSUFFICIENT GREASING DURING ASSEMBLY.

Apr 21, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH MERITOR INTERAXLE DRIVELINE U-JOINTS. DEFLECTOR RINGS, A PART OF THE SYSTEM TO SEAL THE U-JOINTS FROM CONTAMINATES, ARE LOOSE. THIS ALLOWS WATER TO ENTER THE U-JOINT BEARING AREA RESULT IN DILUTION OF THE LUBRICANT, OXIDATION OF THE BEARING AND SEAL SURFACES, AND LOSS OF LUBRICANT.

Jul 16, 1997 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCK. LEAKS THROUGH THE FIREWALL OR STEERING SHAFT BOOTS ALLOWS WATER TO RUN DOWN THE STEERING SHAFT. THE STEERING SHAFT SLIP SPLINE CORRODES CAUSING IT TO SEIZE.

Jan 21, 1997 – DUE TO UNDERSIZED RIVETS AND OVERSIZED HOLES, THE B-PILLAR ANCHORAGE WILL NOT MEET THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD (FMVSS) NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES."

Nov 20, 1996 – VEHICLE DESCRIPTION: ALL VEHICLES EQUIPPED WITH EATON DRIVE AXLES AND AXILOK SPINDLE NUTS. THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION.