FREIGHTLINER COLUMBIA Recalls

Sep 05, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH RACK AND PINION STEERING, THE TIE ROD ARMS MAY HAVE BEEN INCORRECTLY INSTALLED. THE THREADED END OF THE BALL SOCKET ASSEMBLY MAY FRACTURE AND SEPARATE.

Aug 13, 2007 – ON CERTAIN TRUCKS BUILT WITH A TRW GLOBAL ADJUSTABLE UPPER STEERING COLUMN, TWO UPPER TILT PLATE BOLTS MAY LOOSEN WITH USE AND FALL OUT. THESE FASTENERS HOLD THE UPPER COLUMN ASSEMBLY IN PLACE. THE STEERING COLUMN PIVOT MAY FRACTURE IF THE BOLTS ARE MISSING WHEN AN EXCESSIVE FORCE IS APPLIED TO THE STEERING WHEEL.

Aug 02, 2007 – ON CERTAIN TRUCKS, A MANUFACTURING ERROR IN THE FUEL-WATER SEPARATOR PREHEATER THERMOSWITCH MAY PREVENT THE FUEL PREHEATER FROM TURNING OFF IF THE IGNITION IS LEFT ON. IF THE IGNITION SWITCH IS LEFT ON WHEN FUEL IS ADDED TO THE FUEL- WATER SEPARATOR AT THE FACTORY OR DURING A FILTER ELEMENT CHANGE, A SMALL FLAME MAY OCCUR INSIDE THE FILTER COVER.

Jul 24, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH TUFTRAC REAR SUSPENSIONS, THE CENTER CASTING BRACKETS MAY BE OUT OF SPECIFICATION. AN OUT OF SQUARE CASTING MAY HAVE UNACCEPTABLE STRESS IN THE BRACKET WHEN IT IS INSTALLED AND MAY CAUSE IT TO CRACK IN SERVICE.

Jul 18, 2007 – FREIGHTLINER IS RECALLING CERTAIN SCHOOL BUS CHASSIS, HEAVY TRUCKS, VAN CHASSIS, RV MOTORHOME CHASSIS MANUFACTURED FROM JANUARY 5 TO MAY 17, 2007, EQUIPPED WITH AXLE ALLIANCE COMPANY (AAC) FRONT AXLES. DURING THE FRONT AXLE ASSEMBLY, THE FASTENERS THAT ATTACH THE STEERING ARM OR TIE ROD ARMS TO THE SPINDLE MAY BE OVER OR UNDER TIGHTENED.

Jul 16, 2007 – CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY.

Jul 03, 2007 – CERTAIN FREIGHTLINER SCHOOL BUSES AND TRUCKS MANUFACTURED FROM OCTOBER 23, 2004, TO MARCH 21, 2006. DURING THE STEERING COLUMN MANUFACTURING PROCESS TWO WELDS MAY HAVE BEEN MISSING.

Jun 07, 2007 – ON CERTAIN TRUCKS BUILT WITH DANA REAR AXLES, THE HOUSINGS MAY CONTAIN THINNER MATERIAL THAN WHAT IS NECESSARY FOR NORMAL VEHICLE OPERATION.

Apr 12, 2007 – ON CERTAIN TRUCKS BUILT WITH FRONT AXLES ASSEMBLED BY ARVINMERITOR, THE FRONT SPINDLE NUT MAY BE OVER-TIGHTENED CAUSING PRELOAD ON THE FRONT WHEEL BEARINGS WHICH COULD LEAD TO PREMATURE BEARING WEAR.

Nov 02, 2006 – ON CERTAIN TRUCKS EQUIPPED WITH ARVINMERITOR FRONT AXLE ASSEMBLIES, THE FRONT SPINDLE NUT MAY BE OVER-TIGHTENED CAUSING PRELOAD ON THE FRONT WHEEL BEARINGS WHICH MAY LEAD TO PREMATURE BEARING WEAR.