GMC P20 Recalls

Sep 02, 1983 – IN A VEHICLE IMPACT FROM THE REAR, THE THREE PIECE HOSES COULD SEPARATE AND RESULT IN FUEL LEAKAGE IN EXCESS OF THE AMOUNT PERMITTED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".

Aug 24, 1982 – THE REAR AXLE SHAFTS RECEIVED IMPROPER HEAT TREATMENT DURING MANUFACTURE. THE SHAFT MAY BREAK AND THE TIRE AND WHEEL ASSEMBLY COULD DISENGAGE FROM THE VEHICLE.

Dec 14, 1977 – THE INVOLVED VEHICLES FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "ANCHORAGE OF SEATS", DUE TO POSSIBLE FAILURE OF THE SEAT POST ATTACHMENT AT THE FLOOR IN THE EVENT OF AN ACCIDENT. THESE VEHICLES HAVE OVERSIZED BOLT HOLES IN THE FLOOR PAN WHICH MAY ALLOW THE SEAT ATTACHING NUTS TO PASS THROUGH THEM AND THUS TIGHTEN AGAINST THE BOTTOM OF THE SEAT BASE INSTEAD OF THE LONGITUDINAL SILL.

Jun 22, 1977 – THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE.