HONDA Recalls

May 18, 2011 – HONDA IS RECALLING CERTAIN MODEL YEAR 2012 CIVIC 2-DOOR AND 4-DOOR VEHICLES MANUFACTURED FROM APRIL 21, 2011, THROUGH MAY 2, 2011. THERE IS A POSSIBILITY THAT AN O-RING, WHICH SEALS A CONNECTION IN THE FUEL FEED LINE, IS MISALIGNED. IF THE O-RING IS MISALIGNED, A SMALL FUEL LEAK MAY OCCUR.

Mar 21, 2011 – HONDA IS RECALLING CERTAIN MODEL YEAR 2011 HONDA ODYSSEY VEHICLES. THERE IS A POTENTIAL FAILURE WITH THE DRIVER AND THE FRONT PASSENGER DOOR POWER WINDOWS IN WHICH THE WINDOW MAY COME OFF THE TRACK CAUSING THE WINDOW TO BECOME INOPERATIVE AND PREVENTING IT FROM BEING ROLLED UP OR DOWN OR IT COULD DROP INTO THE DOOR.

Mar 15, 2011 – HONDA IS RECALLING CERTAIN MODEL YEAR 2011 HONDA CIVIC VEHICLES. TO PREVENT FUEL FROM LEAKING OUT OF A VEHICLE'S FUEL TANK INTO THE EVAPORATIVE EMISSIONS CANISTER IN THE EVENT A ROLL-OVER INCIDENT OCCURS, THE FUEL PUMP MODULE IS EQUIPPED WITH A ROLL OVER VALVE (ROV). DUE TO IMPROPER ULTRASONIC WELDING OF THE PLASTIC CASE THAT HOUSES THE ROV WITHIN THE FUEL PUMP MODULE, THE CASE MATERIAL MAY BREAK OR CRACK, WHICH MAY CAUSE THE ROV TO SEPARATE FROM THE CASE AND FAIL TO FUNCTION, THEREBY INCREASING THE RISK OF FUEL LEAKAGE IN A ROLL-OVER INCIDENT.

Mar 15, 2011 – HONDA IS RECALLING CERTAIN MODEL YEAR 2011 HONDA ODYSSEY VEHICLES. IF THE FRONT WINDSHIELD WIPER BLADES BECOME FROZEN TO THE WINDSHIELD AND THE WIPER MOTOR IS SWITCHED ON, ONE OF THE FRONT WINDSHIELD WIPER LINKAGE RODS MAY BEND OR SEPARATE FROM THE MOTOR DUE TO INSUFFICIENT STIFFNESS OF THE ROD.

Mar 02, 2011 – HONDA IS RECALLING CERTAIN MODEL YEAR 2006-2007 HONDA CIVIC HYBRID VEHICLES. THERE IS A POTENTIAL FOR THE VOLTAGE CONVERTER THAT RELAYS POWER FROM THE INTEGRATED MOTOR ASSIST (IMA) SYSTEM TO THE VEHICLE'S ELECTRICAL COMPONENTS TO FAIL.

Feb 17, 2011 – HONDA IS RECALLING CERTAIN MODEL YEAR 2009-2010 HONDA FIT VEHICLES. THERE IS A POTENTIAL FOR ONE OR MORE OF THE FOUR SPRING ASSEMBLIES ON THE ENGINE'S VARIABLE VALVE TIMING AND LIFT ELECTRONIC CONTROL (VTEC) SYSTEM TO FAIL.

Jan 06, 2011 – HONDA IS RECALLING CERTAIN MODEL YEAR 2010 HONDA ACCORD AND CR-V VEHICLES. THERE IS A POTENTIAL FAILURE WITH THE ENGINE WIRING HARNESS CONNECTOR WHICH MAY CAUSE INTERMITTENT SPARK FIRING OR THE ENGINE TO STALL.

Dec 16, 2010 – HONDA IS RECALLING CERTAIN MODEL YEAR 2010-2011 HONDA ACCORD V6 AND MODEL YEAR 2011 HONDA PILOT VEHICLES. THE BOLTS THAT ATTACH THE LOWER LEFT AND RIGHT FRONT DAMPER BRACKET TO THE FRONT SUSPENSION AND THE SPINDLE NUTS ON THE PILOT MAY NOT HAVE BEEN PROPERLY TIGHTENED WHICH MAY RESULT IN LOSS OF STEERING. THE SPINDLE NUTS FOR THE AXLE ON THE ACCORD V6 MAY NOT HAVE BEEN TIGHTENED PROPERLY WHICH MAY RESULT IN EXCESSIVE NOISE AND/OR LOSS OF STEERING.

Dec 15, 2010 – HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING HARNESS FOR THE COMBINATION SWITCH THAT CONTROLS LOW HEAD BEAM FUNCTION, THE WIRES FOR THE LOWER BEAM CIRCUIT WERE PULLED TIGHTER THAN INTENDED. AFTER REPEATED USE OF THE HEADLIGHT SWITCH, THE ELECTRICAL CONNECTOR TERMINAL FOR THE LOW BEAM HEADLIGHT CIRCUIT CAN BECOME WORN AS A RESULT OF THIS TENSION, WHICH CAN RESULT IN LOW CONDUCTIVITY AND CAUSE AN ACCUMULATION OF COPPER OXIDE IN THE AREA OF THE CONTACTS.

Oct 22, 2010 – HONDA IS RECALLING CERTAIN MODEL YEAR 2005-2007 ODYSSEY AND ACURA RL VEHICLES. BRAKE FLUID CONTAINING POLYMERS IS USED THAT ACTS AS A LUBRICANT FOR CERTAIN BRAKE SYSTEM COMPONENTS. IF REPLACEMENT BRAKE FLUID IS USED THAT DOES NOT CONTAIN SUCH POLYMERS, OR THAT CONTAINS ONLY SMALL AMOUNTS, A PART OF THE RUBBER SEAL LOCATED AT THE REAR OF THE BRAKE MASTER CYLINDER MAY BECOME DRY, AND THE SEAL MAY CURL DURING MOVEMENT OF THE PISTON. IF THIS OCCURS, A SMALL AMOUNT OF BRAKE FLUID COULD SLOWLY LEAK FROM THE SEAL INTO THE BRAKE BOOSTER.