IC BUS Recalls

Jun 07, 2007 – CERTAIN MY 1996 THRU 2004 RE COMMERCIAL AND SCHOOL BUSES EQUIPPED WITH INTERNATIONAL T444E V-8 DIESEL ENGINES MANUFACTURED BETWEEN JANUARY 3, 1996, AND MARCH 22, 2004. HOSE ASSEMBLIES THAT SUPPLY HIGH PRESSURE OIL TO THE ENGINE'S CYLINDER HEADS MAY DETERIORATE OVER TIME AND ALLOW OIL TO LEAK OR MIST THE ENGINE COMPARTMENT.

Jun 01, 2007 – CERTAIN MY 2007 AND 2008 INTERNATIONAL SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN JANUARY 20 AND SEPTEMBER 28, 2006, EQUIPPED WITH RICON WHEELCHAIR LIFTS . THE LIFT INNER BARRIER INTERLOCK SWITCH SYSTEM MAY NOT DETECT THE PRESENCE OF A PASSENGER ON THE INNER BARRIER AND ALLOW THE PLATFORM TO MOVE DOWN MORE THAN ONE INCH BELOW FLOOR LEVEL WHILE OCCUPIED WHICH DOES NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 403, PLATFORM LIFT SYSTEMS FOR MOTOR VEHICLES.

Feb 23, 2007 – CERTAIN MY 2004-2007 IC CE, RE, AND FE COMMERCIAL AND SCHOOL BUSES MANUFACTURED BETWEEN MARCH 12, 2004, AND NOVEMBER 29, 2006. THE SIDE EMERGENCY DOOR HOLDBACK MECHANISM MAY NOT BE INSTALLED IN THE PROPER LOCATION. THIS MAY CAUSE THE MECHANISM TO HOLD THE DOOR IN THE CLOSED POSITION.

Feb 05, 2007 – CERTAIN 2007 AND 2008 MY IC SCHOOL BUSES MANUFACTURED BETWEEN JANUARY 18, 2006, AND JANUARY 17, 2007. THE AIR SUPPLY FITTING MAY SEPARATE FROM THE BASE PLATE, PREVENTING ACTUATION AIR FROM REACHING THE STOP ARM AND/OR CROSSING ARM. THIS CONDITION WILL RESULT IN NON-DEPLOYMENT OF THE STOP ARM AND/OR CROSSING ARM DURING A SCHOOL BUS STOP TO PICK-UP OR DISCHARGE PASSENGERS.

Dec 21, 2006 – CERTAIN IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN OCTOBER 11, 2005, AND OCTOBER 31, 2006. THESE BUSES HAVE THE FOLLOWING SAFETY ISSUES: IF THE DRIVER'S SEAT IS IN THE HIGHEST AND MOST REAR POSITION, THE BACK OF THE SEAT MAY LEAN AGAINST A BARRIER BEHIND THE SEAT, OR AGAINST THE SEAT BACK. THIS WILL PREVENT THE SEAT BELT FROM RETRACTING WHICH FAILS TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, SEAT BELT ASSEMBLIES. WHEN ADJUST THE SEAT TO A HIGHER POSITION, THE DRIVER MAY PULL THE SEAT PAST THE LAST STOP SO THAT THE SEAT SITS ON THE ADJUSTING PIN, WHICH ALLOWS THE SEAT TO TEETER ON TOP OF THE PIN. IF OVER-TRAVEL OCCURS, THE UPPER SEAT PEDESTAL TUBE COULD SEPARATE FROM THE LOWER PEDESTAL TUBE DURING VEHICLE OPERATION. IF THE DRIVER IS SITTING IN THE DRIVER'S SEAT AND REACHES TO ADJUST THE SEAT HEIGHT, THEIR WEIGHT WILL CAUSE THE SEAT TO DROP, WHICH COULD RESULT IN THEIR HAND BEING PINCHED BETWEEN THE SEAT AND THE LEVER. THE DRIVER'S SEAT IS DIFFICULT TO ADJUST TO A HIGHER POSITION BECAUSE OF THE ADDITIONAL WEIGHT OF THE ALL BELTS TO SEAT (ABTS) DESIGN.

Oct 25, 2006 – CERTAIN MY 2003 THROUGH 2007 IC CESB AND MY 1998 3800 SCHOOL BUSES MANUFACTURED BETWEEN DECEMBER 23, 1997, AND MARCH 31, 2006. THE HANDRAILS WERE NOT INSTALLED CORRECTLY WHICH WILL ALLOW PASSENGER COAT STRINGS OR DRAWSTRINGS TO GET CAUGHT AS THE PASSENGER EXITS THE BUS.

Jul 27, 2006 – CERTAIN MY 2006 AND 2007 IC CE AND 2007 BE SCHOOL BUSES MANUFACTURED BETWEEN AUGUST 3, 2005, AND MAY 1, 2006. THE CONFIGURATION OF THE MOUNTING BRACKET FOR THE 39 INCH TRACK MOUNTED CE WHITE CHILD SAFETY SEAT FAILS TO CONFORM TO THE STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, SEAT BELT ASSEMBLY ANCHORAGES.

Jun 23, 2006 – CERTAIN 2006 AND 2007 IC RESB (PB305) SCHOOL BUSES MANUFACTURED BETWEEN JULY 1, 2005, AND MAY 9, 2006. A JOINT AT THE REAR OF THE BUS WHERE THE DAVENPORT IS ATTACHED TO THE FLOOR DOES NOT MEET THE JOINT STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 221, SCHOOL BUS BODY JOINT STRENGTH.

Jun 02, 2006 – CERTAIN MY 2004 THROUGH 2007 CE AND BE SCHOOL BUSES AND 1300 AND 3300 MODEL VEHICLE CHASSIS MANUFACTURED BY IC CORPORATION BETWEEN MARCH 17, 2004, AND MAY 15, 2006. THE PARK BRAKE SYSTEM MAY ACTIVATE WHILE THE VEHICLE IS UNDER NORMAL OPERATION. ALTHOUGH THE VEHICLE IS BROUGHT TO A STOP, THE ACTIVATION MAY OCCUR WITHOUT WARNING OR INPUT FROM THE DRIVER AND MAY STRAND THE VEHICLE IN AN ACTIVE LANE. THE SPRING APPLIED, HYDRAULIC RELEASE (SAHR) PARK BRAKE ACTUATOR COULD EXPERIENCE A HYDRAULIC LOCK CONDITION THAT WILL NOT ALLOW THE PARK BRAKE TO APPLY.

Apr 25, 2006 – CERTAIN MY 2006 AND 2007 IC CORPORATION FE, RE, AND IC SCHOOL BUSES AND CE SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN JUNE 12, 2005, AND MARCH 29, 2006, AND EQUIPPED WITH RICON 1200, 2000, AND 5500 SERIES WHEELCHAIR LIFTS. THE PLATFORM LIFTS MAY HAVE A DEFECT IN THE WELD WHICH WILL ALLOW A JOINT ON THE VERTICAL LIFT TO CRACK.