IC Recalls

Jul 30, 2008 – NAVISTAR IS RECALLING 24,975 MY 2003 THROUGH 2008 IC BE, CE, HC, AND RE SCHOOL AND COMMERCIAL BUSES AND 2002 THROUGH 2008 INTERNATIONAL 3200 AND 3300 MODEL BUSES MANUFACTURED BETWEEN SEPTEMBER 21, 2001 THROUGH DECEMBER 14, 2007, EQUIPPED WITH INTERNATIONAL VT365 ENGINES. THESE VEHICLES MAY EXHIBIT ENGINE HARD START, NO START, OR STALL CONDITIONS DUE TO POSSIBLY DAMAGED TERMINALS IN THE FUSE HOLDER CONNECTOR OF THE INJECTOR DRIVE MODULE (IDM) CLEAN BATTERY POWER CIRCUITS. THE TERMINALS MAY HAVE BEEN DAMAGED DURING ELECTRICAL CONTINUITY TESTING IN THE MANUFACTURING PROCESS.

Jul 30, 2008 – NAVISTAR IS RECALLING 1,765 MY 1998 THROUGH 2003 RE SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN JANUARY 5, 1998 AND JULY 23, 2002, EQUIPPED WITH INTERNATIONAL T444E ENGINES. THE HOSE ASSEMBLIES THAT SUPPLY HIGH PRESSURE OIL TO THE ENGINE'S CYLINDER HEADS MAY DETERIORATE AND ALLOW OIL TO LEAK OR MIST IN THE ENGINE COMPARTMENT.

Jun 05, 2008 – NAVISTAR IS RECALLING 51,588 HEAVY TRUCKS, COMMERCIAL BUSES AND SCHOOL BUSES MANUFACTURED BETWEEN NOVEMBER 21, 2000 AND MAY 21, 2008, EQUIPPED WITH ONE OR MORE REMOTE POWER MODULES. THE POTTING MATERIAL THAT ENCAPSULATES THE CIRCUIT BOARD OF THE VEHICLE'S REMOTE POWER MODULE MAY NOT SUFFICIENTLY SEAL THE CIRCUIT BOARD FROM WATER AND CONTAMINATION INTRUSION. IF THE ENCAPSULATION IS COMPROMISED, WATER AND CONTAMINANTS MAY CAUSE AN INTERNAL ELECTRICAL SHORT, POSSIBLY RESULTING IN A FIRE.

Feb 27, 2008 – INTERNATIONAL IS RECALLING 34,993 MY 2006-2008 SCHOOL AND TRANSIT BUSES AND HEAVY DUTY TRUCKS/TRACTORS MANUFACTURED BETWEEN JUNE 1, 2006 AND JUNE 28, 2007, EQUIPPED WITH INTERNATIONAL DT466 OR DT570 ENGINES. THE BASE PLATE OF THE ENGINE OIL COOLER MAY CRACK ALLOWING PRESSURIZED OIL TO LEAK INTO THE ENGINE COMPARTMENT.

Sep 24, 2007 – CERTAIN IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN MARCH 29 AND AUGUST 28, 2007. THE ROUTING OF THE SERVICE AND PARKING BRAKE RUBBER DROP HOSES TO THE REAR AXLE'S BRAKE COMPONENTS MAY BRING THEM TOO CLOSE TO THE EXHAUST TAIL PIPE.

Jun 07, 2007 – CERTAIN MY 1996 THRU 2004 RE COMMERCIAL AND SCHOOL BUSES EQUIPPED WITH INTERNATIONAL T444E V-8 DIESEL ENGINES MANUFACTURED BETWEEN JANUARY 3, 1996, AND MARCH 22, 2004. HOSE ASSEMBLIES THAT SUPPLY HIGH PRESSURE OIL TO THE ENGINE'S CYLINDER HEADS MAY DETERIORATE OVER TIME AND ALLOW OIL TO LEAK OR MIST THE ENGINE COMPARTMENT.

Feb 23, 2007 – CERTAIN MY 2004-2007 IC CE, RE, AND FE COMMERCIAL AND SCHOOL BUSES MANUFACTURED BETWEEN MARCH 12, 2004, AND NOVEMBER 29, 2006. THE SIDE EMERGENCY DOOR HOLDBACK MECHANISM MAY NOT BE INSTALLED IN THE PROPER LOCATION. THIS MAY CAUSE THE MECHANISM TO HOLD THE DOOR IN THE CLOSED POSITION.

Dec 21, 2006 – CERTAIN IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN OCTOBER 11, 2005, AND OCTOBER 31, 2006. THESE BUSES HAVE THE FOLLOWING SAFETY ISSUES: IF THE DRIVER'S SEAT IS IN THE HIGHEST AND MOST REAR POSITION, THE BACK OF THE SEAT MAY LEAN AGAINST A BARRIER BEHIND THE SEAT, OR AGAINST THE SEAT BACK. THIS WILL PREVENT THE SEAT BELT FROM RETRACTING WHICH FAILS TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, SEAT BELT ASSEMBLIES. WHEN ADJUST THE SEAT TO A HIGHER POSITION, THE DRIVER MAY PULL THE SEAT PAST THE LAST STOP SO THAT THE SEAT SITS ON THE ADJUSTING PIN, WHICH ALLOWS THE SEAT TO TEETER ON TOP OF THE PIN. IF OVER-TRAVEL OCCURS, THE UPPER SEAT PEDESTAL TUBE COULD SEPARATE FROM THE LOWER PEDESTAL TUBE DURING VEHICLE OPERATION. IF THE DRIVER IS SITTING IN THE DRIVER'S SEAT AND REACHES TO ADJUST THE SEAT HEIGHT, THEIR WEIGHT WILL CAUSE THE SEAT TO DROP, WHICH COULD RESULT IN THEIR HAND BEING PINCHED BETWEEN THE SEAT AND THE LEVER. THE DRIVER'S SEAT IS DIFFICULT TO ADJUST TO A HIGHER POSITION BECAUSE OF THE ADDITIONAL WEIGHT OF THE ALL BELTS TO SEAT (ABTS) DESIGN.

Oct 25, 2006 – CERTAIN MY 2003 THROUGH 2007 IC CESB AND MY 1998 3800 SCHOOL BUSES MANUFACTURED BETWEEN DECEMBER 23, 1997, AND MARCH 31, 2006. THE HANDRAILS WERE NOT INSTALLED CORRECTLY WHICH WILL ALLOW PASSENGER COAT STRINGS OR DRAWSTRINGS TO GET CAUGHT AS THE PASSENGER EXITS THE BUS.

Jun 02, 2006 – CERTAIN MY 2004 THROUGH 2007 CE AND BE SCHOOL BUSES AND 1300 AND 3300 MODEL VEHICLE CHASSIS MANUFACTURED BY IC CORPORATION BETWEEN MARCH 17, 2004, AND MAY 15, 2006. THE PARK BRAKE SYSTEM MAY ACTIVATE WHILE THE VEHICLE IS UNDER NORMAL OPERATION. ALTHOUGH THE VEHICLE IS BROUGHT TO A STOP, THE ACTIVATION MAY OCCUR WITHOUT WARNING OR INPUT FROM THE DRIVER AND MAY STRAND THE VEHICLE IN AN ACTIVE LANE. THE SPRING APPLIED, HYDRAULIC RELEASE (SAHR) PARK BRAKE ACTUATOR COULD EXPERIENCE A HYDRAULIC LOCK CONDITION THAT WILL NOT ALLOW THE PARK BRAKE TO APPLY.