INTERNATIONAL HARVESTER LOADSTAR SERIES Recalls

Oct 16, 1979 – THE INVOLVED VEHICLES DO NOT HAVE THE REQUIRED CERTIFICATION LABELS STATING CORRECT TIRE AND RIM INFORMATION. THESE VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR VEHICLES OTHER THAN PASSENGER CARS".

Sep 18, 1979 – AS A RESULT OF SEVERE SHOCK AND VIBRATIONS, THE BRAKE SPIDERS ON THE INVOLVED VEHICLES MAY DEVELOP CRACKS NEAR THE CAMSHAFT MOUNTING BOSS. THE CRACK PROPAGATES ACROSS THE SPIDER UNTIL THE CAMSHAFT BOSS IS COMPLETELY SEVERED FROM THE REMAINDER OF THE SPIDER. WHEN THE CAMSHAFT BOSS HAS COMPLETELY SEVERED, THE S-CAM, S-CAM BRACKET, AIR CHAMBER AND SLACK ADJUSTER CAN FALL AWAY FROM THE BRAKE SPIDER RESULTING IN A "NO BRAKE" CONDITION ON THE WHEEL.

Sep 18, 1979 – THE FUEL SEPARATORS ON THE INVOLVED VEHICLES MAY HAVE THIN WALLS DUE TO A MATERIAL THICKNESS PROBLEM. THE SEPARATORS IN THESE WALLS MAY CRACK AND MAY ALLOW FUEL VAPORS OR LIQUID FUEL TO LEAK INTO THE ENGINE UNDER HIGH PRESSURE CONDITIONS.

Feb 21, 1979 – A CASTING DEFICIENCY MAY ALLOW WHEELS TO DEVELOP CRACKS IN THE SPOKES BETWEEN THE HUB CAP MOUNTING AREA AND THE RIM CLAMP POCKET. CONTINUED USAGE CAN LEAD TO THE DISENGAGING OF THE RIM AND TIRE FROM THE VEHICLE.

Oct 17, 1978 – THE PARKING BRAKE LEVER MOUNTING BRACKET MAY BEND AND BREAK DUE TO REPEATED APPLICATIONS OF THE PARKING BRAKE. THIS WILL CREATE A TEARING FORCE AT THE BOLT MOUNTING AREA OF THE BRACKET.

Jun 21, 1978 – THE VAPOR SEPARATOR IN THE FUEL TANK EVAPORATIVE OMISSION SYSTEM LACKS THE CAPACITY TO PROHIBIT LIQUID GASOLINE FROM PASSING TO THE CANISTER UNDER CERTAIN FUEL EXPANSION CONDITIONS. GASOLINE WOULD BE DISCHARGED FROM THE BOTTOM OF THE CANISTER ONTO THE REAR OF ENGINE, CREATING A FIRE HAZARD.

Dec 28, 1977 – THE INVOLVED VEHICLES MAY CONTAIN A POOR QUALITY OR AN INSUFFICIENT WELD OF THE BRAKE GROUP MOUNTING FLANGES TO THE AXLE HOUSING. THIS COULD LEAD TO THE FLANGE BREAKING LOOSE FROM THE HOUSING, ALLOWING THE BRAKE GROUP TO TURN WITH THE BRAKE DRUM ON BRAKE APPLICATION. THIS WILL CUT THE BRAKE LINES TO THE BRAKE GROUP AND MAY CAUSE PARTIAL LOSS OF BRAKING CAPABILITY.

Oct 17, 1977 – THE DEFICIENCY EXISTS IN THE FRONT AXLE FORGED ALUMINUM HUBS. THE DEFICIENCY WHICH IS IN THE BARREL SECTION BETWEEN THE INNER AND OUTER BEARING, MAY RESULT IN CRACKS WHICH COULD LEAD TO HUB FAILURE. WHEN HUB FAILURE OCCURS, THE SEPARATED HUB IS RETAINED ON THE AXLE SPINDLE BY THE WHEEL BEARING AND ADJUSTING NUT.

Feb 10, 1977 – THE STUB ENDS OF THE AXLE HOUSING MAY NOT HAVE BEEN PROPERLY MANUFACTURED TO SPECIFICATIONS. THESE STUBS WOULD BE OF INADEQUATE STRENGTH AND COULD FRACTURE. COMPLETE FRACTURE WOULD CAUSE THE FRONT WHEEL, HUB, AND BRAKE ASSEMBLY TO DETACH FROM THE AXLE.