INTERNATIONAL HARVESTER TRANSTAR Recalls

Feb 14, 1984 – A COTTER PIN THAT PREVENTS THE HINGE ATTACHING THE BRAKE PEDAL TO THE FLOOR FROM COMING APART MAY HAVE BEEN OMITTED.

Nov 17, 1980 – THE NUTS WHICH FASTEN THE TIE ROD ENDS TO THE STEERING ARMS MAY NOT HAVE BEEN TIGHTENED TO THE SPECIFIED 150 FT-LB TORQUE. INSUFFICIENTLY TIGHTENED TIE ROD END NUTS COULD LOOSEN, BREAK OFF THE LOCKING COTTER PIN, AND ALLOW THE TIE ROD TO DISENGAGE FROM THE STEERING ARM.

Oct 16, 1979 – THE INVOLVED VEHICLES DO NOT HAVE THE REQUIRED CERTIFICATION LABELS STATING CORRECT TIRE AND RIM INFORMATION. THESE VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR VEHICLES OTHER THAN PASSENGER CARS".

Sep 18, 1979 – AS A RESULT OF SEVERE SHOCK AND VIBRATIONS, THE BRAKE SPIDERS ON THE INVOLVED VEHICLES MAY DEVELOP CRACKS NEAR THE CAMSHAFT MOUNTING BOSS. THE CRACK PROPAGATES ACROSS THE SPIDER UNTIL THE CAMSHAFT BOSS IS COMPLETELY SEVERED FROM THE REMAINDER OF THE SPIDER. WHEN THE CAMSHAFT BOSS HAS COMPLETELY SEVERED, THE S-CAM, S-CAM BRACKET, AIR CHAMBER AND SLACK ADJUSTER CAN FALL AWAY FROM THE BRAKE SPIDER RESULTING IN A "NO BRAKE" CONDITION ON THE WHEEL.

Jun 19, 1979 – THE PINCH BOLT HOLES IN THE LOWER STEERING C0LUMN UNIVERSAL JOINT YOKE WERE DRILLED OFF LOCATION OF THE CENTER LINE, THUS REDUCING BOLT TO STEERING GEAR INPUT SHAFT ENGAGEMENT. AS A RESULT, THE JOINT COULD SLIP OR SEPARATE FROM THE STEERING GEAR INPUT SHAFT.

Feb 21, 1979 – A CASTING DEFICIENCY MAY ALLOW WHEELS TO DEVELOP CRACKS IN THE SPOKES BETWEEN THE HUB CAP MOUNTING AREA AND THE RIM CLAMP POCKET. CONTINUED USAGE CAN LEAD TO THE DISENGAGING OF THE RIM AND TIRE FROM THE VEHICLE.

May 17, 1978 – THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS". THE WASHERS USED TO SPACE THE ANTI-LOCK SENSOR BRACKET AWAY FROM THE BRAKE SPIDER WERE OMITTED DURING ASSEMBLY. THIS OMISSION COULD CAUSE THE SENSOR BRACKET TO BE DEFORMED. BRAKING CAPABILITY COULD BE PARTIALLY LOST.

Dec 28, 1977 – ON THE INVOLVED VEHICLES A DEFECT MAY EXIST IN THE ACCELERATOR LINKAGE BALL JOINTS WHICH COULD CAUSE BINDING AND MAY LOCK THE ACCELERATOR CONTROL IN A PARTIALLY OR FULLY OPEN THROTTLE POSITION.

Oct 17, 1977 – THE DEFICIENCY EXISTS IN THE FRONT AXLE FORGED ALUMINUM HUBS. THE DEFICIENCY WHICH IS IN THE BARREL SECTION BETWEEN THE INNER AND OUTER BEARING, MAY RESULT IN CRACKS WHICH COULD LEAD TO HUB FAILURE. WHEN HUB FAILURE OCCURS, THE SEPARATED HUB IS RETAINED ON THE AXLE SPINDLE BY THE WHEEL BEARING AND ADJUSTING NUT.