INTERNATIONAL 1652 Recalls

Mar 25, 2019 – North American Repower LLC (North American Repower) is recalling one 2005 Navistar International 1652 4x2 Compressed Natural Gas vehicle equipped with CNG tanks that have Luxfer One-Turn valves recalled under 18E-111. If the knob is turned more than one turn, the valve's snap ring may fail and the valve stem may forcibly eject from the valve body.

Jun 15, 2010 – NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2003 THROUGH 2010 INTERNATIONAL TRUCKS AND IC COMMERCIAL BUSES MANUFACTURED FROM DECEMBER 4, 2001 THROUGH DECEMBER 14, 2009 EQUIPPED WITH INTERNATIONAL VT365 ENGINES HAVING ENGINE CALIBRATION PAN2PVR0, PAN2PVR1, OR PAN2PWR. THE ENGINE NORMALLY RESPONDS TO A FAILED OPEN ACCELERATOR POSITION SENSOR CIRCUIT FAULT BY RETURNING THE ENGINE TO LOW IDLE SPEED OF 800 RPM AND DISABLING THE DRIVER'S ABILITY TO INCREASE THE ENGINE SPEED. HOWEVER IF THE OPEN CIRCUIT CORRECTS ITSELF WITHIN 30 SECONDS OF INITIATION, ENGINE SPEED COULD SUDDENLY INCREASE TO A HIGH IDLE SPEED OF 1200 RPM.

Jun 03, 2004 – ON CERTAIN SCHOOL BUSES AND TRUCK MODEL VEHICLES MANUFACTURED BETWEEN FEBRUARY 28, 1999, THROUGH APRIL 5, 2004, THE ANTI-LOCK BRAKE SYSTEM ELECTRONIC CONTROL UNIT (ECU) MAY MISINTERPRET A CORRUPT WHEEL SPEED SIGNAL.

May 27, 2004 – ON CERTAIN SCHOOL AND TRANSIT BUSES THE STUDS USED TO SECURE THE POWER STEERING PUMP TO THE ENGINE BLOCK CAN FAIL, RESULTING IN ENGINE OIL LEAKAGE AND COMPLETE LOSS OF POWER STEERING. THE POWER STEERING PUMP IS DESIGNED TO PROVIDE POWER ASSIST TO BOTH THE STEERING SYSTEM AND THE HYDRAULIC BRAKING SYSTEM. SHOULD STUD FAILURE CAUSE THE PUMP TO BECOME DISENGAGED FROM ITS DRIVE GEARS, A REDUCTION OF THE FLUID FLOW RATE TO THE BRAKE SYSTEM COULD OCCUR AND POSSIBLY CAUSE AN EXTENDED STOPPING DISTANCE AS WELL AS INCREASED STEERING WHEEL EFFORTS.

Feb 25, 2003 – ON CERTAIN SCHOOL AND TRANSIT BUSES BUILT WITH BOSCH ZERO OFFSET PIN SLIDE (ZOPS) HYDRAULIC DISC BRAKES, THE ZOPS HYDRAULIC DISC BRAKES MAY EXPERIENCE CALIPERS STICKING IN THE APPLIED POSITION, WHICH CAN RESULT IN EXCESSIVE OR ABNORMAL HEAT GENERATION AT ONE OR MORE OF THE BRAKES.

Feb 01, 2001 – VEHICLE DESCRIPTION: STRIPPED CHASSIS AND COMMERCIAL BUSES AND SCHOOL BUSES EQUIPPED WITH HYDRAULIC BRAKES AND AUTOMATIC TRANSMISSIONS. THE MISALIGNMENT OF THE BRAKE PEDAL CAN CAUSE DELAYED BRAKE LIGHT ACTIVATION DURING LIGHT BRAKING APPLICATIONS.

Sep 26, 2000 – VEHICLE DESCRIPTION: TRUCKS EQUIPPED WITH ALLISON 1000 OR 2400 SERIES TRANSMISSIONS. THESE TRANSMISSIONS CAN EXPERIENCE PARK PAWL TO REAR COVER INTERFERENCE DUE TO AN OUT OF FLATNESS CONDITION.

May 21, 1993 – THE PRESSURE RELIEF VALVE WAS OMITTED IN THE AIR TANK. THE AIR TANK IS THE RESERVOIR FOR THE AIR SUSPENSION AND IS NOT BRAKE RELATED. WITHOUT THE PRESSURE RELIEF VALVE, THERE IS NO BACK-UP SYSTEM TO LIMIT AIR PRESSURE IN THE AIR SUSPENSION SYSTEM.

Oct 24, 1992 – THE SAGINAW GEAR DOES NOT RELIEVE PRESSURE WHEN THE WHEELS HAVE BEEN TURNED FULLY AGAINST THE AXLE STOPS. THE RESULTING CONTINUED PRESSURE ON THE STEERING SYSTEM CAN RESULT IN THE DEVELOPMENT OF CRACKS IN THE SPLINES OF THE PITMAN SHAFT, WHICH CAN DEVELOP INTO A COMPLETE FRACTURE OF THE PITMAN SHAFT.

Dec 11, 1989 – THE THROTTLE VALVE INSIDE THE HYDRAULIC BRAKE BOOSTER MAY DEFORM FROM BUILDUP OF HEAT AND PRESSURE AND CLOSE-OFF FLUID RETURN PORTS.