INTERNATIONAL 4400 Recalls

Jan 28, 2003 – CERTAIN SCHOOL BUSES AND HEAVY DUTY TRUCKS BUILT WITH HYDRAULIC BRAKES AND AN AIR POWERED PARKING BRAKE (BRAKE CODE 04GAS) FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." THE HYDRAULIC BRAKE MONITOR MODULE WAS NOT INSTALLED ON CERTAIN VEHICLES.

Sep 20, 2002 – ON CERTAIN MEDIUM AND HEAVY DUTY TRUCKS BUILT WITH DRIVELINE PARKING BRAKE CODES 04GAR, THE PARKING BRAKE ASSEMBLY MAY NOT HOLD THE VEHICLE IN POSITION WHEN SET. FACTORS CONTRIBUTING TO THIS POSSIBILITY ARE AS FOLLOWS: (1) CRACKED OR BROKEN CAMS; (2) LOOSE OR BROKEN ANCHOR BOLTS; (3) INITIAL SHOE DIAMETER NOT SET PROPERLY DURING ASSEMBLY, WHICH CAN LEAD TO PROGRESSIVE COMPONENT DAMAGE; (4) BENT ADJUSTER LEVERS THAT CANNOT FUNCTION; OR (5) AUTOMATIC ADJUSTER CABLES THAT ARE DISCONNECTED.

Jul 12, 2002 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH MANUAL TRANSMISSIONS, LOWER CLUTCH RODS WITH TURNBUCKLES ARE FAILING FROM FATIGUE NEAR THE TURNBUCKLE DUE TO BENDING FORCES EXPERIENCED DURING EACH CLUTCH PEDAL CYCLE.

Mar 22, 2002 – CERTAIN TRUCKS EQUIPPED WITH ENGINE STARTERS (CODE 08WWN OR 08WWP) BUILT BY LEECE-NEVILLE. THESE STARTERS HAVE A DEFECTIVE TERMINAL ADAPTER STUD. THE STUD IS USED ONLY AT THE POSITIVE BATTERY CONNECTION TO THE STARTER SOLENOID. IT WAS DESIGNED TO BE SCREWED ON OVER THE EXISTING STUD TO INCREASE THE STUD DIAMETER TO ACCOMMODATE THE LARGER SIZE OF THE POSITIVE BATTERY CABLE TERMINAL. THE ADAPTER STUD WAS WEAKENED WHEN THE HOLE WAS DRILLED TOO DEEP.

Mar 22, 2002 – ON CERTAIN TRUCKS, THE COTTER PIN THAT GOES THROUGH THE DRAG LINK BALL STUD AT THE CONNECTION TO THE PITMAN ARM IS MISSING. THIS PIN PREVENTS THE CASTLE NUT FROM LOOSENING.

Feb 15, 2002 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH IROS REAR AIR SUSPENSIONS, DURING ASSEMBLY, FOUR BOLTS AND NUTS HOLDING THE MAIN SUPPORT MEMBER BUSHING BAR PINS TO THE MAIN SUPPORT MEMBER HANGERS WERE INCORRECTLY TIGHTENED.

Nov 15, 2001 – VEHICLE DESCRIPTION: TRUCKS. AN INCORRECT GRADE 5 FLANGE-NUT WAS INSTALLED IN PLACE OF A GRADE 8 NUT AND FLAT WASHER ON THE YOKE PINCH BOLT THAT HOLDS THE CONNECTION BETWEEN THE LOWER END OF THE I-SHAFT AND THE STEERING GEAR.